There are two concrete pools with the same depth in an industrial plant site, which will be used to treat wastewater. Decide on the reactor configuration in series, for the best removal performance if the reaction is first order Concrete Pool Square Pool with a mixer Long Channel Volume Reactor Design Equation Qx Co C- V CSTR (Q + k V) kV PFR C Coe

There are two concrete pools with the same depth in an industrial plant site, which will be used to treat wastewater. Decide on the reactor configuration in series, for the best removal performance if the reaction is first order Concrete Pool Square Pool with a mixer Long Channel Volume Reactor Design Equation Qx Co C- V CSTR (Q + k V) kV PFR C Coe

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The return line in a secondary clarifier Returns sludge at a lower concentration than in the aerator O Returns only volatile material O Returns sludge at a higher concentration than in the aerator Returns sludge at the same concentration as in the aerator
Please answer all three With short explanation Otherwise please don't attempt The concentration of suspended solids in scration tanks of the activated slide process is called RAS SRT Ssr MLSS Trickling filtration process is a type of (a) Suspended growth processes (b) anaerobic Processes (c) Attached growth processes (d) Aerobic Processes (d) Aerobic Processes Sludge treatment includes (a) Softening (b) Digestion (c) Chlorination (d) All of the above
For each of the following constituents that might be found in water or wastewater, provide two examples of a unit operation that would be useful in removing that consitutent. a. Giardia lamblia (protozoan) b. Arsenic c. Bentonite (clay)
A complete mix activated sludge process is to be used for biological treatment. This plant receives 10,000 m³ of wastewater per day with BOD loading of 250 mg/L. The primary treatment efficiency is 25%. Assume the followings: ● ● -4- Plant effluent BOD5 = 12 mg/L Biomass yield = 0.54 kg biomass / kg BOD Endogenous decay rate=0.05 day-¹ Solids Retention Time = 8 days MLVSS concentration in the aeration tank = 2,700 mg/L Waste and recycle solids concentration = 12,000 mg/L Determine the followings: (i). The hydraulic detention time in hours. (ii). The aeration tank volume in cubic meters. ...4/- SULIT EAP582
Wastewater is treated with an activated sludge plug flow reactor, similar to one seen at the Norman Water Reclamation Facility. The BOD5 after primary treatment is 100mg/L and the effluent limit is 5 mg/L BOD5. Use 1.00 h-1 as the maximum specific growth rate constant and typical values for the other biokinetic constants. The biomass concentration in the reactor is 2,500 mg/L MLSS based on a recycle ratio of 1. Calculate the mean cell residence time, in hours for this system
For an electrostatic precipitator of given geometry and operating conditions, the collection efficiency for 2 micrometer particles is 99.90 percent. On the basis of a Deutsch-type equation for efficiencies, estimate the collection efficiency for (a) 1 micrometer and (b) 0.5 micrometer particles
Underneath a conventional plug flow reactor and a plug flow reactor with tapered aeration that both use sludge recycle, sketch graphs of DO, DO Uptake, S, and Xa, versus distance from the inlet of the reactor
An activated-sludge system is to be used for secondary treatment of 15,000 m3/d of municipal wastewater. After primary clarification, the BOD is 130 mg/L, and it is desired to have not more than 5 mg/L of soluble BOD in the effluent. A completely mixed reactor is to be used, and pilot-plant analysis has established the following kinetic values: Y = 0.6 kg/kg, kd = 0.07 d-1. Assuming an MLSS concentration of 2,750 mg/L and an underflow concentration of 11,000 mg/L from the secondary clarifier, determine the followings. [Use θc (MCRT or SRT) = 10 day.] 5.1. The volume of the reactor. 5.2. The mass and volume of solids that must be wasted each day. 5.3. The recycle ratio. Hint: θc = VX/QwXu : MCRT (mean cell-residence time) [or SRT (solids retention time)]; average time microbes spend in reactor = ratio of total biomass in reactor to biomass wasted per given time; currently most commonly used design parameter F/Mv: inversely proportional to SRT; ≈U (cell's specific substrate…
Civil engineering
(6) Derive an expression relating effluent concentration to influent concentration, hydraulic residence time, and the reaction rate constant for a second-order reaction in a batch at non-steady state. Repeat the exercise for a CMFR and a PFR at steady state. Explain your results.
Ex.3. Estimate the value of minimum particles diameter for (7m long) (1.2m height) settler chamber with gas velocity of (30 cm/sec).The air temperature is (26.6°c) and particles density is (2.5 gm/cm³) with dynamic viscosity of (1.9x 10-5Pa.sec).(for minimum particles diameter the efficiency is 100%).
Design rapid mix unit for 200,000 m3/day raw water, use G = 500 ses T = 40 sec, dynamic viscosity = 10.54*10- 4