A plug flow and a CFSTR biological reactor are both operating with an influent substrate concentration of 100 and effluent substrate concentration of 90. You also know that q cap =1, Ks = 1000, kd=0.1. which of the following statements is true. Choose one only. a. The PFR will have a much smaller volume than the CFSTR b. The PFR will have a bigger volume than the CFSTR c. The PFR will have the same volume as the CFSTR d. The PFR will be a little smaller than the CFSTR e. The PFR will be a little bigger than the CFSTR

Q: A ground water with salinity (TDS) of 2850 mg/L is treated with reverse osmosis desalination process…

A: NOTE: As per our policy, we can solve only the first 3 sub-parts.   Given Data: The groundwater with…

Q: 9. A core sample is saturated with Oil, Gas and Water , the initial weight of the saturated sample…

A: Given data - bulk volume of sample = 100 cc Initial weight of saturated sample is 220 gm Increased…

Q: The analysis of a water sample for MPN calculation in Multiple Tube Fermentation Test is given…

A: Given: Multiple tube fermentation test is given below,

Q: Briefly explain about  degradation of azo dyes in wastewater using micro-nano bubble treatment.

A: Micro-nano bubbles (MNB) are bubbles which have diameter between tens of nanometer and micrometer.…

Q: 500 m3 per day of copper ore is to be crushed from a feed size of 80% is less than 5cm to a product…

A: Following are the given information. copper ore =500 m3 per day  feed size of 80% is less than 5 cm…

Q: Example 9.36. Design a Zeolite-Softener for an industrial concern, using the following data : (i)…

A:

Q: Problem 2. A reverse osmosis membrane has a kw values of 2.5-10 L/(m²-s-bar) and an average ks value…

A: Step 1:

Q: Due to rise in temperature, the viscosity and unit weight of percolating fluid are reduced to 70%…

A: We have to determine the change in coefficient of permeability

Q: Water containing 50 mg/L of monodisperse (uniformly sized) spherical particles of diameter 100 μm…

A:

Q: Problems arise if the contaminant concen- tration in the influent to the manufacturing step rises…

A:

Q: What is the pH of a buffer made from 0.350 mol of HBrO (Ka = 2.5 × 10⁻⁹) and 0.090 mol of KBrO in…

A:

Q: Write the simplified ENTROPY BALANCE equation for each process with the following set of conditions:…

A: Entropy can be transmitted to or from the system in two ways: heat transfer and maximum flow. Note…

Q: If a wastewater has a soluble orthophosphate concentration of 6.00 mg/L as P (PO:-P), what…

A: Atomic wt. Of  Al=27 S=32 O=16 Phosphorus, P=30 Here, 1 mol of Al2(SO4)3 reacts with 2 mol of P to…

Q: Determine the pH of the solution produced in the reaction flask when 25.00mL of 0.100 M NaOH has…

A: to find - ph of solution

Q: Some wastewater has a BOD, of 180 mg/L at 20°C. The reaction rate K at that temperature has heen…

A:

Q: 2. Given: Process tank shown below Find: (1) total surface area and (2) volume 3m3 m- 6m 4 m

A: Consider the given tank which has two shape i.e. cube and cone a=side of square =6 mh=height of…

Q: When a slug of tracer is injected into a cascade of CFSTRS, a maximum value of Cr occurs at t> 0 for…

A: In a cascade of continuously stirred tank reactors (CSTRs), a slug of tracer injected at the inlet…

Q: A rigid, well-insulated tank contains a two-phase mixture of ammonia with 0.0028 ft3 of saturated…

A:

Q: The capillary rise (height) in mm of an ethanol having a viscosity of 0.032 J/m2. The tube has a…

A:

Q: shown in the figure Cons The flow rate through the reactor is 3 1.

A:

Q: What is the pH of the solution containing 10-5 M H2SO4? Assume complete dissociation of H2SO4 in…

A: Given data,Concentration of H2SO4=10-5To find the ph of the solution

Q: Environmental Engineering: A reaction takes place in aqueous solution and is first order. The…

A: Calculating the rate constant for the reaction,

Q: AUF system reduces turbidity from 121 to 11 NTU. Which one of the following shows rejection? - 90 O…

A: Ultrafiltration (UF) It is a method of purifying water that involves pushing water against a…

Q: Which of the following is/are true about thin walled pressure vessels? A vessel can be classified as…

A:

Q: The alkalinity of a water sample is 120 mg/1 as CaCO3. pH of the water sample is found to be 9.…

A:

Q: The most important buffer system in water is the carbon dioxide system of acid/base reactions.…

A: Alkalinity of any solution defined as the ability to neutralise the H+ ions in the solution. here…

Q: Consider the reactor shown in the figure. The flow rate through the reactor is Q m/h. The…

A: Given- First order reactionMixing condition is CMFR or PFRCCo=0.8

Q: 2. At what point in a treatment system is ion exchange normally used?

A: Ion exchange is actually a water treatment process which was commonly used for the water softening…

Q: The theoretical yield coefficient can be estimated from the observed yield coefficient if the…

A: Cell mass and item arrangement by microorganisms can be portrayed quantitatively by yield…

Q: A Pump & Treat water treatment system at a contaminated site is designed to treat 5 m3/d of ground…

A: Given, Q = 5 m3/d Ci = 100 mg/L Ce = 25 mg/L V = 20 m3 k = 0.5/d

Q: A small lake with volume 10,000 m3 has a stream flowing into it with flow rate 100 m3/day and a…

A: a) The increase in discharge concentration will cause a slight increase in the lake concentration.…

Q: Three CFSTRS with same volume (50000 L each) in series were used to degrade an organic compound.…

A: Rate constant at 200 C=0.5 per min Rate constant at 100 C==(Rate constant at 200…

Q: Predict whether the following reactions would occur spontaneously in aqueous solution at 25°C.…

A: A spontaneous process is generally capable of proceeding in a particular direction without occurring…

Q: 1- Explain the procedure to find the total solid and what's the unit for it? 2- In total dissolved…

A: Procedure to find the total solids and it's unit.

Q: t more than 7 mg/L of soluble BOD in the effluent. The mixed liquor has a concentration of 3000 mg/L…

A:

Q: The secondary NAAQS for SO2 is 0.5 ppm (for a 3-hour averaging time). Calculate the equivalent…

A: Given:- The secondary NAAQS for SO2 is 0.5 ppm To find:- The equivalent concentration in pg/m3

Q: OD of a wastewater sample is determined by incubating the BOD bottles at four different…

A: Ultimate BOD is independent of temperature.

Q: Glycerin flows at 35 m through a 150 mm diameter new wrought iron pipe at a velocity of 3 m/s. It…

A: D=150mm L=35m V=3m/s To find coefficient of friction (f)

Q: a) Write down the chemical equations for the reactions that take place in the DO test. b) Discuss…

A: Find:The chemical equations for the reactions that take place in the DO test. The environmental…

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.