If a wastewater has a soluble orthophosphate concentration of 6.00 mg/Las P (POs-P), what theoretical amount of [Al:(SO.)3] will be required to remove itcompletely?Al:(SO.), + 2HPO→ 2AIPO, + 2H + 350.

Atomic wt. Of Al=27 S=32 O=16 Phosphorus, P=30 Here, 1 mol of Al2(SO4)3 reacts with 2 mol of P to…

If a wastewater has a soluble orthophosphate concentration of 6.00 mg/L as P (PO:-P), what theoretical amount of [Al:(SO.)] will be required to remove it completely? Al:(SO.), + 2HPO→ 2AIPO + 2H + 350.

If a wastewater has a soluble orthophosphate concentration of 6.00 mg/L as P (PO:-P), what theoretical amount of [Al:(SO.)] will be required to remove it completely? Al:(SO.), + 2HPO→ 2AIPO + 2H + 350.

Materials Science And Engineering Properties

1st Edition

ISBN:9781111988609

Author:Charles Gilmore

Publisher:Charles Gilmore

Chapter10: Oxidation, Degradation, Corrosion, Electroprocessing, Batteries, And Fuel Cells

Section: Chapter Questions

Problem 10.1P

See similar textbooks

Similar questions

Problems arise if the contaminant concen- tration in the influent to the manufacturing step rises above a critical acceptable level (ca). Again, assuming that the contaminant con- centration in the municipal water is zero and that the UPW system does not remove any of this contaminant, solve for the recycle ra- tio (RR = R/Q) as a function of the other known quantities, Q, ca, and W. NOTE: for the purpose of answering this question, use "ca" to denote Ca.
Describe the lime soda process for removing the hardness of water. Calculate the amountof lime and soda required for treatment of 10,000 liters of water containing the followingsalts in ppm.Al2(SO4)3 = 34.2 HCl = 7.3MgCl2= 19.0 NaCl= 58.5
The pOH of a basic solution is 3.33. What is pH?
Chose the correct answer 1- The Unit measurement of suspended solids is ...A- kg 2- The Unit measurement of Turbidity is A- °C is B-m B-NTU C- mg/L C-K 3- The Unit measurement of pH www A-mg/L 4- The Unit measurement of alkalinity is .. 5-Non toxic metals includes 6-Dissolved materials size is lees than A- 10 mm D- none of above D- none of above D- none of above B- p.p.m C- g/m³ D- none of above A- m/sec B- m³/sec C- mg/L A-Chromium B- Mercury C- Calcium D- none of above B- 106, C-108 mm D- none of above mm 7- Public standards of Hardness in drinking water is A-500 mg/L B-50 mg/L C-100 mg/L D- none of above 8- Alkalinity species includes are A-HCO3 B-CO3 C- OH D-All of above ... 9- Dental cavities in children can prevented when Drinking water has Fluoride concentration of A- 0.1 mg/L B- 1 mg/L C- 10 mg/L D- none of above 10- Toxic metals are metals that harmful to humans even when exists in concentration of .. A- Small B-Large C-zero D- none of above
A water with low alkalinity of 15 mg/L as CaCO3 will be treated with the ferrous sulphate-lime coagulation. FeSO4 dosage is 18 mg/L. (CaCO3 = 100 g/mol, Ca(HCO3)2 = 162 g/mol, Ca(OH)2 = 74 g/mol, FeSO4.7H₂O = 278 g/mol, Fe(OH)2 = 90 g/mol). a. Determine the lime dosage needed to react with the ferrous sulphate for sweep coagulation. b. If dissolved oxygen (DO) concentration is 5 mg/L before coagulation, what is concentration of DO after coagulation?
(a) Discuss the importance of these products in the hydration process: i) C-S-H gel ii) Са(ОН)2
6 Ydu will obtain 2.0 L of tap water for you water hardness test. The water hardness test uses a precipitation reaction to precipitate the Calcium bicarbonate present out of solution by adding 1.9 g of Ca(OH) represented by the following equation: Ca(HC03|21ag) + Ca(OH)215) > 2CaCOsisi + 2 H20 ml What is the percent yield of CaCO3 produced in the hard water test? (fig. 4)
(a) (ii) Following chemical species were reported for water sample from a well. Concentration (milli equivalent)/L 15 15 05 30 12 18 8.8 Species Chloride (CL) Sulphate (SO2-) Carbonate (CO2) Bicarbonte (HCO3) Calcium (Ca²+) Magnesium (Mg2+) pH Find (i) The total hardness (in mg/L) as CaCO3 (ii) Alkalinity present in the water (in mg/L) as CaCO3.
The most important buffer system in water is the carbon dioxide system of acid/base reactions. CO2(g) → CO2(aq) + H2O(1) → *H2CO3 +→ H* + HCO3 2H* + CO32- A sample of water has a pH of 5.0 the concentration of HCO3 is 122 mg L-1and the CO3- concentration is 60.0 mg L-1. What is the approximate alkalinity (ALK) in the water as CaCO3? Assume there is no exchange between the solution and the atmosphere and the temperature is 25°C. ALK= [HCO3] + 2[CO3²]]
A Pump & Treat water treatment system at a contaminated site is designed to treat 5 m3/d of ground water in a reactor designed as a well mixed system. The effluent must meet quality standards of 25 mg/L of Iron. The treatment reactor’s 20 m3 volume is believed to be insufficient to achieve the standard. The ground water has an iron concentration of 100 mg/L and the treatment reactor has a kinetic constant of 0.5 d-1. – Confirm that the treatment system will NOT meet the effluent quality standards. – If not modify the design by adding a PFR system (using same treatment process and kinetics), what volume should the PFR addition be?
Which of the following is/are correct: 1. X, =+X 2. X- BOD 3. BOD; = BOD 4. BOD, = !! where X and Xy are the total and the volatile solids, respectively, in the bioreactor, fo is the biodegradable fraction in the solids, Xey is the volatile solids in the effluent, BOD5 and BOD, are the 5-day and the ultimate biochemical oxygen demand, respectively, frelates BOD5 to BOD, and is less than 1. O 2 and 4 O 2 only O 1 and 3 O 2 and 3
Please choose the correct answer for each question: 1. Activity of a gas in equilibrium with solution is ______? A. its partial pressure; B.1.0; C. its molar concentration; D. 0.0 2. During a sorption procedure, the substance transferred from the gas or liquid phase to the solid phase is called ______ A. sorbent; B. sorbate; C. partition; D. none of the above 3. When a chemical has a lower KOW, it is more ______ A. hydrophobic; B. hydrophilic; C. more absorbable; D. less absorbable 4. _____ occurs on the adsorbent surface A. Adsorption; B. Sorption; C. Absorption; D. Adsorption and absorption 5. _____ addresses the change in the amount of a substance of interest with time. A. The equilibrium approach; B. The kinetic approach; C. Henry’s Law; D. Freudlich isotherm equation