If only 0.264 g of Ca(OH)2 dissolves in enough water to give 0.113 L of aqueous solution at a given temperature, what is the Ksp value for calcium hydroxide at this temperature? The solubility of an ionic compound in water can be expressed in terms of the mass that will dissolve in a given volume of water, or in terms of the solubility product, Ksp.

If only 0.264 g of Ca(OH)2 dissolves in enough water to give 0.113 L of aqueous solution at a given temperature, what is the Ksp value for calcium hydroxide at this temperature? The solubility of an ionic compound in water can be expressed in terms of the mass that will dissolve in a given volume of water, or in terms of the solubility product, Ksp.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter4: Types Of Chemical Reactions And Solution Stoichiometry

Section: Chapter Questions

Problem 108AE: Consider a 1.50-g mixture of magnesium nitrate and magnesium chloride. After dissolving this mixture...

See similar textbooks

Similar questions

The equation for a reaction by which a solution of sodium carbonate may be standardized is 2HC7H5O2+Na2CO32NaC7H5O2+H2O+CO2. A student determines that 5.038g of HC7H5O2 uses 51.89mL of sodium carbonate solution in the titration. Find the molarity of the sodium carbonate.
Calcium carbonate, CaCO3, can be obtained in a very pure state. Standard solutions of calcium ion are usually prepared by dissolving calcium carbonate in acid. What mass of CaCO3 should be taken to prepare 500. mL of 0.0200 M calcium ion solution?
According to the Resource Conservation and Recovery Act (RCRA), waste material is classified as toxic and must be handled as hazardous if the lead concentration exceeds 5 mg/L. By adding chloride ion, the lead ion will precipitate as PbCl2, which can be separated from the liquid portion. Once the lead has been removed, the rest of the waste can be sent to a conventional waste treatment facility. How many grams of sodium chloride must be added to 500 L of a waste solution to reduce the concentration of the Pb2+ ion from 10 to 5 mg/L?
. For the reaction N2(g)+3H2(g)2NH3(g), list the types of bonds that must be broken and the type of bonds that must form for the chemical reaction to take place.
Describe in words the titration of an acid with a base. Be sure to use the terms equivalence point, indicator, and end point correctly.
Relative solubilities of salts in liquid ammonia can differsignificantly from those in water. Thus, silver bromide issoluble in ammonia, but barium bromide is not (thereverse of the situation in water). Write a balanced equation for the reaction of anammonia solution of barium nitrate with an ammoniasolution of silver bromide. Silver nitrate is soluble inliquid ammonia. What volume of a 0.50 M solution of silver bromidewill react completely with 0.215 L of a 0.076 M solutionof barium nitrate in ammonia? What mass of barium bromide will precipitate fromthe reaction in part (b)?
Using the general solubility rules discussed in Chapter 7, give the formulas of live substances that would be expected to be readily soluble in water and five substances that would be expected to not be very soluble in water. For each of the substances you choose, indicate the specific solubility rule you applied to make your prediction.
A student weighs out a 4.80-g sample of aluminum bromide, transfers it to a 100-mL volumetric flask, adds enough water to dissolve it, and then adds water to the 100-mL mark. What is the molarity of aluminum bromide in the resulting solution?
Lead(II) nitrate is added to four separate beakers that contain the following: aker 1 (sodium chloride) eaker 2 (sodium hydroxide) eaker 3 (sodium phosphate) eaker 4 (sodium sulfate) ter the addition of the lead(II) nitrate solution to each beaker, in which beaker(s) will a precipitate form? Use the general solubility rules given in Table 7.1 to guide you.
A student was given a 1.6240-g sample of a mixture of sodium nitrate and sodium chloride and was asked to find the percentage of each compound in the mixture. She dissolved the sample and added a solution that contained an excess of silver nitrate. The silver ion precipitated all of the chloride ion in the mixture as silver chloride. It was filtered, dried, and weighed. Its mass was 2.056g. What was the percentage of each compound in the mixture?
Polychlorinated biphenyls (PCBs) have been used extensively as dielectric materials in electrical transformers. Because PCBs have been shown to be potentially harmful, analysis for their presence in the environment has become very important. PCBs are manufactured according to the following generic reaction: C12H10+nCl2C12H10nCln.+nHCl This reaction results in a mixture of PCB products. The mixture is analyzed by decomposing the PCBs and then precipitating the resulting Cl asAgCl. a. Develop a general equation that relates the average value of n to the mass of a given mixture of PCBs and the mass of AgCl produced. b. A 0.1947-g sample of a commercial PCB yielded 0.4791 g of AgCl. What is the average value of n for this sample?
There are many ionic compounds that dissolve in water to a very small extent. One example is lead(II) chloride. When it dissolves an equilibrium is established between the solid salt and its component ions. Suppose you stir some solid PbCl2 into water. Explain how you would prove that the compound dissolves but to a small extent? Is the dissolving process product-favored or reactant-favored? pbcl2(s)pb2+(aq)+2cl(aq)