The 64-kg man with center of mass G supports the 28-kg drum as shown. Find the greatest distance x at which the man can position himself without slipping if the coefficient of static friction between his shoes and the ground is 0.40. 4.3 m 28 kg 64 kg G 1.2 m

The 64-kg man with center of mass G supports the 28-kg drum as shown. Find the greatest distance x at which the man can position himself without slipping if the coefficient of static friction between his shoes and the ground is 0.40. 4.3 m 28 kg 64 kg G 1.2 m

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A uniform rod AB of weight 500 N and length 4.0 m is supported at two points P and Q as shown below. AP = QB = 0.80 m. A man of weight 800 N is walking from Q to B. Find the maximum %3D %3D distance x from Q the man can walk before the rod topples about Q. P Q A 1 -| × |- O 0.4 m O 0.8 m O 0.75 m O 0.6 m
A 65 kg person is standing on a 25 kg wood board as shown. How far can they go past the left support without the board tipping? 1.5 m 2.5 m Page 4 1.5 m of 4 ZOOM + Find the value of if the system is in equilibrium M
A 45.5‑kg box with the dimensions a×b (the width a = 0.6 m and height b = 1.3 m) is standing on a rough horizontal floor (μs = 1.3). A Professor wants to tip the box over, she pushes on the right side of the box with a horizontal force F = 140 N at a distance h = 1.04 m above the floor as shown in the picture below. The other forces acting on the box are the gravity force (applied to the CoM of the box), the static friction force Fs and the normal force N (both applied to the lower right corner of the box, point Q). Calculate the magnitude and direction of the torques produced by the forces acting on the box relative to the lower right corner (point Q). Assume uniform mass distribution. 1. The torque due to the external force, τQ(due to F) = 2. The torque due to the weight of the box, τQ(due to mg) = 3. The torque due to the friction force, τQ(due to Fs) = 4. The torque due to the normal force, τQ(due to N) =
You place a 15.0-m long, 22-kg uniform ladder against a smooth vertical wall with the bottom of the ladder 3.0 m from the wall. There is a lot of slippery mud so naturally you are worried about the ladder slipping. The coefficient of static friction between the floor and the ladder is 0.28. What distance, measured along the ladder from the bottom, can a 60-kg person climb before the ladder starts to slip?
A hungry bear weighing 85.0 kg walks out on a beam in an attempt to retrieve a basket of food hanging at the end of the beam. The beam is uniform, has a mass of 20.0 kg, is 8.00 m long, and pivoted at the wall; the basket weighs 10.0 kg. If the wire can withstand a maximum tension of 900 N, what is the maximum distance that the bear can walk before the wire breaks? ←x 60.0⁰ Goodies
Suppose a 905-kg car is on the bridge in the figure with its center of mass halfway between the hinges and the cable attachment. (The bridge is supported by the cable and hinges only.) The mass of the bridge is 2500 kg. Find the tension, in newtons, in the cable.
A 10.0 m long rod, with a mass which acts at its center, supports three weights as shown. Where is its center of gravity? X kg Y kg 0.0 5.0 m Z kg 10.0 m where X = 5.00, Y = 15.0, and Z=30.0.
A 10.0 m long rod, with a mass which acts at its center, supports three weights as shown. Where is its center of gravity? X kg Y kg 0.0 5.0 m Z kg 10.0 m where X = 5.00, Y = 27.0, and Z = 22.0
A 1 490-kg automobile has a wheel base (the distance between the axles) of 2.70 m. The automobile's center of mass is on the centerline at a point 1.05 m behind the front axle. Find the force exerted by the ground on each wheel. each front wheel _______kN each rear wheel _______kN
The maximum load that can be supported by a crane is determined by the torque that the load exerts about the pivot point of the crane. If a certain crane is rated to support a load of 1000kg at a distance of 10m from its main tower, how large a load can it support at a distance of 40m from its main tower? See figure. 10 m 40 m O 250 kg O 4000 kg O 1000 kg O 2000 kg O 500 kg
A stick which is 1.51 meters long is leaned against a wall at an angle. If the coefficient of static friction between the stick and the wall and floor is 0.395, determine the furthest distance from the wall that the bottom of the stick may be placed without slipping.
A homeowner is trying to move a stubborn rock from his yard. By using a a metal rod as a lever arm and a fulcrum (or pivot point) the homeowner will have a better chance of moving the rock. The homeowner places the fulcrum a distance ?=0.288 mfrom the rock, which has a mass of 465 kg, and fits one end of the rod under the rock's center of weight. If the homeowner can apply a maximum force of 671 N at the other end of the rod, what is the minimum total length ? of the rod required to move the rock? Assume that the rod is massless and nearly horizontal so that the weight of the rock and homeowner's force are both essentially vertical. The acceleration due to gravity is ?=9.81 m/s2.