Q4// A liquid mixture of benzene-toluene is to be distilled in a fractionating tower. The feed contains 40 mol % benzene and 60 mol % toluene. A distillate containing 90 mol % benzene and a bottoms containing 10 mol % benzene. The feed at the boiling point, the reflux ratio is 4 and average 2.4. Equilibrium data for this system are given in the table below: XA 1 0.78 0.58 0.41 0.258 0.13 0 1 0.9 0.777 0.632 YA 0.456 0.26 1- Calculate the number of plates required. 2- What is the number of feed introducing tray from top. 3- Minimum number of theoretical plates. 4- Minimum reflux ratio. 0

Q: Crude petroleum oil is generally considered to be formed from animal and vegetable debris…

A: Given: Elemental analysis of crude petroleum 80% C 13%H 1% N 3% O 3% S Required to find: (a) Orsat…

Q: tungsten. 19 g/mo a. Deve tung

A: Let Benzene be represented as ‘A’ and toluene by ‘B’. Latent heat of vaporization for both the…

Q: Using the equilibrium data shown below for benzene-toluene system at 1 atm with relative volatility…

A: The pressure of the benzene-toluene mixture The relative volatility,

Q: Gaseous fuel composed of 65% carbon, 30% hydrogen and 5% oxygen saturated with water vapor is burned…

A:

Q: 4) The impurity of zinc in liquid lead can be removed by passing chlorine gas at 390 °C according to…

A:

Q: Two component VLE calculation:  Calculate the bubble point temperature for a liquid hydrocarbon mix…

A:

Q: 3C(s) + 3H, (g) → C,H, (g.propylene) AH" = +20.42 kJ/ mol C(s) + 02(g) CO,(g) AH" = -393.51 kJ/ mol…

A: In process calculation, change in enthalpy is calculated using the principle of conservation of…

Q: An aqueous solution of a solute is concentrated from 5% to 20% (mass basis) in a single- effect…

A: The aqueous solution is concentrated in single effect evaporator by condensing steam. Initial mass…

Q: the zeolite at 1 atmospheric pressure. If at the

A: Given data       assume :1 kg  zeolite  composition:   CO2 = .15 mole N2 = .85 mole Selectivity = 22…

Q: A solution of methylene chloride (CH,CI,) and ethanol (CH,CH,OH) is boiling at 62.7 °C. A sample of…

A: A mixture of methylene chloride (M) and ethanol (E) is boiled. The temperature of the boiling…

Q: Beginning at point X trace out the lines for one theoretical plate. What is the composition of the…

A: Given data: Temperature-composition (T,x-y) diagram of compounds An and B is given.

Q: The dry bulb temperature of the air in a room is 25°C and the wet bulb temperature is 20 °C. Find…

A: Given that, Dry bulb Temperature = 25oC Wet-bulb temperature = 20oC It is required to calculate the…

Q: a (meaning that 92% of the ben

A:

Q: A semi-batch distillation unit is filled with 300 mol of a 80 mol% benzene-20 mol% toluene mixture.…

A:

Q: A lead ore, galena, consisting mainly of lead (II) sulfide, is the principal source of lead. To…

A: Enthalpy change of reaction a = -415.4 kJ Enthalpy change of reaction b = 108.5 kJ

Q: Moist air (2.27 mol % H2O) at 25°C and 100 kPa is to be dehumidified so that during its passage…

A: The mole fraction of water in the air is calculated. The total pressure is calculated. In process…

Q: QUESTION 3-) The normal boiling point of butane is given as 0.6°C and the default specific…

A: In thermodynamics, the boiling point of a substance is defined as the temperature at which the vapor…

Q: A vapor mixture, 4.652 mol/s, of n-butane and n-hexane containing 50 mole % n-butane at 120˚C and 1…

A: Given, The molar flow rate of the mixture, nF= 4.652 mol/s The mole% of n-butane is 50 mol% The…

Q: A process produces toluene at 1 atm and 30 °C that must be condensed to avoid releasing it to the…

A:

Q: 50% by mass NaOH was diluted to 10% by the addition of water. The temperature of the 50% by mass…

A: Given: 50% at 65.6 °C by mass NaOH was diluted to 10% at 37.8 °C Enthalpy change by using NaOH/H2O…

Q: Moist air (2.27 mol% H>O) at 25°C and 100 kPa is to be dehumidified so that during its passage…

A: Moist air have 2.27mol% H2O T=25 ℃ P=100kPa Process is For dehumidification two process are…

Q: A gas mixture containing 25% mol CO2 and 75% NH3 is being scrubbed byan acid solution to remove the…

A: Given data: Composition of gas mixture entering the tower is, CO2= 25 mol % NH3= 75 mol %…

Q: 2. Gas A is reacted with gas B in a batch reactor: A+ 3B → 3C Stoichiometric ratio of A and B are…

A: A batch reactor is a reactor where the reactants are allowed to react for a certain time and then…

Q: It is required to find the number of theoretica

A:

Q: In the determination of the liquid-vapor phase diagram of 2 components A and B, the following data…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: Chloroform (bp 61 °C) and methyl ethyl ketone (79 °C) form a maximum boiling azeotrope (bp 90 °C);…

A: Boiling point of chloroform = 61°C Boiling point of ethyl ketone = 79°C Maximum boiling point…

Q: One thousand kilograms per hour of a 45 wt% acetone in water solution is to be extracted at 25°C in…

A: Given In a continuous countercurrent extractor Feed-1000 kg/hr( 45 wt% acetone in water solution)…

Q: Carbon tetra chloride is to be removed from a polymer solution by bubbling dry air through it at 297…

A: When a liquid and its vapor are in contact in a closed system, they can reach a state of balance…

Q: A saturated vapor feed that is 90 %mol maleic anhydride and 10%mol benzoic acid is distilled  at…

A: Given : since feed is sat vapor hence PsM + PBs = PThence  PsM + PBs = 99.8also, the composition of…

Q: The standard enthalpy change upon dissolving one mole of oxygen at 25°C is -11.7 kJ. Use this number…

A: Given data: Standard enthalpy of dissolution of oxygen = -11.7 kJ

Q: A dilute aqueous solution containing 45g of sucrose per liter of solution have an osmotic pressure…

A: The osmotic pressure of the solution depends on the molar concentration of the solution and…

Q: .Verizon 89% 5:33 PM Done 2. A liquid system consisting of 5 % mole ethanol and the rest being water…

A: Part (a) At constant pressure, the temperature at which the liquid mixture boils is determined as…

Q: 3. Figure shows equilibrium phase diagram of Pb-Sn eutectic alloy system. Using the given phase…

A: The phases of states are coexisted at equillibrium.These are represented by equilibrium phase…

Q: Consider 500mL of a benzene-hexane mixture at 50°C containing 30% of the more volatile. a)…

A: A mixture of benzene and hexane is given. Temperature of the mixture = 50 0C Volume of the mixture =…

Q: The equilibrium constant with respect to temperature can be expressed for the reaction: Cyclohexane…

A: Write the reaction as follows: Cyclohexaneg ↔ methylcyclopentaneg   Calculate the enthalpy of the…

Q: the following temperature-composition data were obtained for a mixture of octane (O) and…

A: The vapor liquid equilibrium curve is used to describe the composition of species between the liquid…

Q: QUESTION 3-) The normal boiling point of butane is given as 0.6°C and the default specific…

A: Norman boiling point of the butane,TB1=0.6°C=(6+273)K=279 K Normal boiling pressure, PB1=1 atm New,…

Q: The experimental enthalpy of decomposition of H2O2 was determined using another coffee-cup…

A: We will have to determine the experimental enthalpy of decomposition per mole of Hydrogen peroxide.…

Q: Carbon monoxide can react with water to form Carbon Dioxide and Hydrogen. Given the ratio between…

A: The reaction:  CO + H2 O ⥐CO2 +H2