A process produces toluene at 1 atm and 30 °C that must be condensed to avoid releasing it to the atmosphere. A mixture that is 20% toluene gas by volume enters the condenser with dry air and 95% condensation of the toluene is achieved at equilibrium. What is the mole fraction of toluene in the exiting vapor? What is the final temperature of the saturated vapor after compressing to a pressure of 5 atm at equilibrium?

Q: 3. In a steady-state methane-air flame at approximately atmospheric pressure, the temperature is…

A: Given :Initial temperature Final temperature Concepts used : The adiabatic flame temperature…

Q: Te Pe Natural gas is produced in a gas field | Component (K) | (bar) (Pa (m³/kmol)?) | (m³/kmol)…

A: Given that, The pressure of the gas at the sales point P = 5 MPa = 5000 kPa The temperature of the…

Q: There is liquid methanol at the bottom of a square-section tank with a total height of 7.50 m and a…

A: Total height of the tank, H = 7.50 m Side of the square tank, a = 1.50 m The tank is open at the top…

Q: 1. Calculate the steam consumption and the amount of juice per hour that can be concentrated from…

A: The figure is drawn as follows:

Q: Air at 80OF and 80% relative humidity is cooled to 51OF at a constant pressure of 1 atm. Determine…

A: Relative humidity is the ratio of partial pressure and vapor pressure. These are important…

Q: A solution of organic colloids is to be concentrated from 15% to 50% solids in a vertical tube…

A: Given data: Concentration of solids in the feed = 15 % Concentration of solids in the mother liquor…

Q: In the air conditioning process in the humidifier, air at a dry bulb temperature of 30 ° C and RH…

A: Given Data : TDB1 = 30 °C , RH1 = 25% RH2 = 50%

Q: fruit juice at 25 ° C containing 5% total solids concentrated via a single effect evaporator. The…

A:

Q: Carbon monoxide at 50°F is completely burned at 2 atm pressure with 50% excess air that is at…

A:

Q: ) A 3.0 L flask containing 2.0 mol O2 and 1.0 mol N2 is in a room that is at 22.0° What is the total…

A: The volume of the flask = 3 L Moles of O2 in the flask = 2 mol Moles of N2 in the flask = 1 mol The…

Q: Air with a wet bulb temperature of 21.9 °C and a dry bulb temperature of 40 °C is humidified by…

A: Given data: The absolute mass humidity of air entering the humidifier = 0.009 kg H2O/kg dry air The…

Q: a single effect vaporator was used to concentrate 8000 kg / hr of tomato juice from 5% total solids…

A: In heat transfer, a single-effect evaporator is a simple machine in which steam provides energy for…

Q: Sulphur can be recovered from underground elemental deposits via the Frasch process. In this…

A: Given thatT =165 CP = 2.5 MPaPT  = 6 atmρl  =1.811 gml =1.811 x 106  gm3ρs  =2.050 gml =2.05 x 106…

Q: A 1000 ft3 storage tank is filled with natural gas at 80°F and 1 atm pressure. The tank is flushed…

A: Given: V = 1000 ft3 or 28.32 m3, T = 80°F or 299.82 K, P = 1 atm and Q = 300 ft3/min or 8.5 m3/min…

Q: 5. A tank contains a liquid composed of 60 mol% toluene and 40 mol% benzene in equilibrium with the…

A: Given: x1 = 0.6, x2 = 0.4, P = 1 atm, T = 80 0F To calculate the composition of the gaseous phase…

Q: A single-effect, vertical short-tube evaporator is used to concentrate a syrup from 10% to 40%…

A: Feed rate, Wf = 2000 kg/h with 10% solidsSolids IN = 2000 x 0.1 = 200 kg/hWater IN = 2000 - 200 =…

Q: The water is at the pressure of 0.22 bar and temperature of 60°C. a) Using data from the table,…

A: Given that- Water is present at, Pressure, P=0.22 bar Temperature, T=600C To perform the…

Q: 2.71 An air-conditioner system consists of a spray section followed by a reheater. Moist air at 30°C…

A: Given the temperature of moist air initially at point 1 Now mark these points on psychometric chart

Q: astic soda is concentrated from 10% to 50% in a single-éffect evaporator. The feed at 305 K enters…

A:

Introduction and Basic Calculations in Multiphase Systems

Chemical calculations involve material and energy balance calculations which enable engineers to calculate material and energy requirements in various chemical processes. In addition to this, chemical calculations help to study the behavior and properties of gases, liquids, and their mixtures.