Q3- Three concrete beams were selected for flexural strength test. Results from tests are shown in table below. If the flexural strength of the concrete is 1505 KPa, determine the load needed for failure in each test using four points loading. Show the detailed calculations and loading system sketches. S.N Width, mm Depth, mm Span, mm (Width +16) (Depth +0.5x16) (Span +16) 149.2 148.4 471 2 143.3 146.8 466 3 137.6 137.1 450

Q3- Three concrete beams were selected for flexural strength test. Results from tests are shown in table below. If the flexural strength of the concrete is 1505 KPa, determine the load needed for failure in each test using four points loading. Show the detailed calculations and loading system sketches. S.N Width, mm Depth, mm Span, mm (Width +16) (Depth +0.5x16) (Span +16) 149.2 148.4 471 2 143.3 146.8 466 3 137.6 137.1 450

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Please fast
Give me right solution clearly
The stem-leaf diagram below shows compressive strength of concrete cubes measured in (Kpa). Determine the median
A half-block concrete masonry unit is tested for compressive strength. Theoutside dimensions of the specimen are 190 mm X 190 mm X 190 mm.The cross section is a hollow square with a wall thickness of 25 mm. Theload is applied perpendicular to the hollow cross section and the maximum load is 225 kN.a. Determine the gross area compressive strength.b. Determine the net area compressive strength.
A half-block concrete masonry unit is subjected to compression until failure.The outside dimensions of the specimen are 190 mm X 190 mm X 190 mm.The cross section is a hollow square with a wall thickness of 38 mm. The loadis applied perpendicular to the hollow cross section and the maximum loadis 296 kN.a. Determine the gross area compressive strength.b. Determine the net area compressive strength.
A simply supported beam 6.5m long, 350mmx500mm, prestressed with a straight tendon located 150mm below the neutral axis with effective prestressing force, Pe, of 300kN. Total load carried by the beam is 20kN/m. A. Determine the area of the concrete, mm2.B. Determine the section modulus of the concrete in x10^3 mm^3C. Determine the compressive stress caused by the tendon alone if Pe is at the centroid, MPa
what would be the average compressive strength of concrete if the load at failure of the 3 trials are 55,100 kg 54,800 kg and 55,200 kg. Diameter of the sample is 6" a. 31.1 MPa b. 30.6 MPa c. 31.6 MPa d. 30.1 MPa
Q2- A cylindrical concrete specimens 150 mm in diam. and 300mm high each were tested in split tensile test, the following results were observed, determine the tensile strength of concrete and estimate the compressive strength. S.N 1 3 4 7 Load, kN 267.3 269.4 260.5 255.4 287.2 291.4 282.5 (Load+5x18
Q1/ Cube of concrete 100 mm long pressed with a pressure test of 98 mm length. To determine the correct geometric strain
please answer in the nearest 3 decimal numbers