(Q3) Calculate the total solar irradiation on vertical wall facing a direction 45° south of the east in a location with a latitude of 22° N at 11:00 am solar time on 1 June. Assume clear sky conditions and the ground reflectivity is 0.6. Also determine the sunrise and sunset solar times. Show all calculations and results and highlight the result of each calculation for clarity.

(Q3) Calculate the total solar irradiation on vertical wall facing a direction 45° south of the east in a location with a latitude of 22° N at 11:00 am solar time on 1 June. Assume clear sky conditions and the ground reflectivity is 0.6. Also determine the sunrise and sunset solar times. Show all calculations and results and highlight the result of each calculation for clarity.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

13.58 The end of a cylindrical liquid cryogenic propellant tank in free space is to be protected from external (solar) radi- ation by placing a thin metallic shield in front of the tank. Assume the view factor F, between the tank and the shield is unity; all surfaces are diffuse and gray, and the surroundings are at 0 K. T Shield, T, T, = 100 K E1 = E2 = 0.05 &= 0.10 Ĝ3 = 1250 W/m? Tank Solar irradiation Gs Find the temperature of the shield T, and the heat flux (W/m) to the end of the tank.
13.41 Consider two very large parallel plates with diffuse, gray surfaces. - T, = 1000 K, ɛ, = 1 T, = 500 K, ez = 0.8 Determine the irradiation and radiosity for the upper plate. What is the radiosity for the lower plate? What is the net radiation exchange between the plates per unit area of the plates?
1) The spectral, hemispherical absorptivity of an opaque surface and the spectral irradiation at the surface are as shown. d' 1.0 G₂ (W/m².um) 500 0.2 0 0 0 2 4 6 8 10 12 14 16 0 2 4 6 8 10 12 14 16 λ(μm) λ(μm) a) How does the spectral, hemispherical reflectivity vary with wavelength? b) What is the total, hemispherical absorptivity of the surface? c) If the surface is initially at 500 K and has a total, hemispherical emissivity of 0.8, how will its temperature change upon exposure to the irradiation?
Wien's law is stated as follows: AmT = C, where C is 2898 μmK and Am is the wavelength at which the emissive power of a black body is maximum for a given temperature T. The spectral hemispherical emissivity (Ex) of a surface is shown in the figure below (1Å= 10-¹0m). The temperature at which the total hemispherical emissivity will be highest is K (round off to the nearest integer). Ext n 5000 6000 7000 (A)
QUESTION 2 The Air Mass is.. A. the mass of air through which blockes solar irradiance. B. the mass of air through which the solar radiance passes. C. the mass of air through which the solar irradiance passes. O D. the mass of solar irradiance.
3. A star has a surface temperature of 5,500K. Determine the radiative heat transfer received by planet Z in Petawatts with diameter of 2100 km, temperature of surface of 300K and mean absorptivity of 0.8. Radiative energy loss due to radiation dispersion on outer space is 99%.
4. The surface temperature of a planet is T, and the measured temperature is Tm (i.e. the temper- ature measured at the top-of-atmosphere based on the upwards flux Ft there). Assume radiative equilibrium. (a) Show that the infrared optical depth of the planet's surface 7 is related to the surface temperature T, and the measured temperature Tm by Calculate the infrared optical depth at the surfaces of (a) Earth, where T, = 300 K and Tm = 250 K. (b) Venus, where T, = 750 K and Tm = 230 K. (c) Mars, where T, = 240 K and T, = 220 K.
The tungsten filament of an incandescent light bulb has a temperature of approximately 3000 K. The emissivity of tungsten is approximately 1/3, and you may assume that it is independent of wavelength. To increase the efficiency of an incandescent bulb, would you want to raise or lower the temperature? (Some incandescent bulbs do attain slightly higher efficiency by using a different temperature.)
2. An UV stepper (Exposure Machine) has a NA numerical aperture of 0.3 and uses a light source with a wavelength of 436nm. What is the minimum feature size you would expect the stepper to be able to produce? What would be the maximum thickness of resist that the stepper could successfully expose?
An opaque surface has the spectral, hemispherical reflectivity distribution as shown below. The surface receives the spectral irradiation shown below. A. Determine the total irradiation on the surfaceB. Determine the radiant flux that is absorbed by the surface
a. What is the total, hemispherical absorptivity of the sample surface? b. What is the inital vale of the total, hemispherical emissivity of the sample surface? c. What is the value of the total, hemispherical emissivity of the sample surface after the sample has been in the enclosure for a very long time?
A 5 mm-thick steel firewall is suddenly exposed to a radiant heat source that can be approximated as a blackbody at 1000K. How long will it take for the surface to reach 500 K if the initial temperature of the wall is 300K?