Q- What will be the time required (in minute) in falling the head from 45 cm to 30 cm in a variable head permeability test, if the coefficient of permeability of the soil is known to be 6.89 x 106 m/sec. The length and cross-sectional area of the soil sample is 60 cm and 210 cm² respectively. The area of stand pipe is 6.5 cm².

Q- What will be the time required (in minute) in falling the head from 45 cm to 30 cm in a variable head permeability test, if the coefficient of permeability of the soil is known to be 6.89 x 106 m/sec. The length and cross-sectional area of the soil sample is 60 cm and 210 cm² respectively. The area of stand pipe is 6.5 cm².

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

In a falling head permeability test, the following data was obtained: diameter of standpipe = 1.5 cm; diameter of sample = 10.16 cm; height of water level at beginning of test (h1) = 30 cm; length of sample (L) = 20 cm. The soil had a coefficient of permeability (k) equal to 3.4 x 10°cm/sec. If the test was conducted for a period of 8 hours, what was the water level at the end of the test (h2)? %3D Time when water level is at h, is t, (t,) a = area of standpipe Time when level is at 19% h, is t2 (t2) A = cross-sectional area of soil sample Soil sample
Answer Question 7
18
76 .ll Q3.png The data from standard and modified proctor test on a soil sample (density of solids: 2680 kg/m3 ) are provided below: Standard proctor test Modified proctor test Dry density (kg/m) 1691 Dry density (kg/m') 1873 Water content (%) Water content (%) 9.3 9.3 1715 11,8 1910 12.8 1755 14.3 1803 15.5 1747 17.6 1699 18.7 1685 20.8 1641 21.1 1619 23 a) Plot the compaction curves (both standard and modified in one graph). b) Establish the maximum dry density and optimum water content for each test.
Consider that a 58.7 gram sample of dry soil is used in making a mechanical analysis by using the hydrometer method. The laboratory was held at a constant temperature of 20 C (68 F). The 40 s hydrometer reading was found to be 32.5 and the 8 hr hydrometer reading was 15.5. The percentage of sand in this soil sample is (note, a 58.7 gram sample is used here): Your Answer: Answer units
soil هفصشبكطودذؤ
For a falling head permeability test, the following are given: length of specimen is 360 mm, area of specimen is 70 cm2 , and hydraulic conductivity of soil specimen is 0.165 cm/min. what should be the area of the stand pipe for the head to drop from 700cm to 360cm in 7 mins? compute the seepage velocity under the test condition if the soil specimen has a void ratio of 0.55 in cm/sec compute the head difference at time equal to 5 minutes?
35 The data from a falling head test is shown. Diameter of standpipe: 6 cm. Initial Head: 90.97 cm. Duration of test: 17 min. Length of soil sample: 30.68 cm. Diameter of permeameter: 40 cm. If the soil permeability is 0.0089 cm/min, detemine the final head (in cm.) of the permeability test. Round off to two decimal places.
Solve !
Calculate K for the soil tested in the figure. Assume the cross-sectional area of the sample is 14 cm² and the area of the standpipe is 2cm². The time of test = 15 min. All dimensions shown are in mm. D 270 T 200 soil 70 580 310