Answered: Q// What is the pressure difference (PA…

Q// What is the pressure difference (PA - PB) measured by the U-tube manometer shown in the figure below. use S.G. mercury = 13.6, y water = 9.81 KN/m³.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A pressure measurement apparatus without leakage and friction between piston and cylinder wall is…

Q: Problem 1 Convert 230 kPa to millimeters of mercury, inches of mercury, and feet of water. Problem 2…

Q: Find the differential mercury manometer gauge reading shown in the given figure if the pressure…

Q: Problem 2 A manometer connects an oil pipeline and a water pipeline as shown in Fig. 24. Determine…

A: the rate of increase of pressure in vertical downward direction at a point in static fluid must be…

Q: 2. Both a gage and a manometer are attached to a gas tank to measure its pressure. If the reading on…

Q: Two water tanks are connected to each other through a mercury manometer with inclined tubes, as…

Q: Air hsca hais Sea Tresh water water Mercury Figure 1 Figure 1 shows a U-tube manometer that connects…

Q: Q5) For the inverted manometer of Figure , all fluids are at 20C. If pB – PA=7 kPa, what must the…

A: Pressure at height h of the fluid= density of fluid × g × height of fluid.

Q: 6. A differential manometer is attached to a pipe, as shown in figure below. Calculate the pressure…

Q: 1. The gage pressure of the air in the tank shown in the figure below is measured to be 65 kPa.…

Q: For the shown inverted manometer, all fluids are at 20°C. If P - P = 97 kPa, what must the height X…

A: Using concept of Pressure in left limb of manometer = pressure in right limb solution = 1.31m

Q: 2. Consider a double fluid manometer attached to an air pipe shown. determine the specific gravity…

Q: fluids shown in the figure are at 20°C. If V₁ = 2.6 ft/s and losses are neglected, determine the…

A: This question is related to the Fluid Mechanics from Civil Engineering. Given Data - V1 = 2.6…

Q: Meriam red oil, SG=0.827 P2.32 Water A 18 cm H 35 cm B Mercury

A: Given data:- The PB-PA=89.5 kPa=89500 Pa The specific weight of water is, Wwater=9790 N/m3 The…

Q: Q1: Find the distance Z shown in the Figure below. O=30° {1 Bar=100 (KN/m2) and pw = 1000 (Kg/m³)}.…

A: "Since, you have asked multiple questions, we will answer first two questions for you (because they…

Q: The plastic block shown below measures I.5 m xl.S m x(.7 m and has a specific gravity of 0.38. The…

A: Given data: Note : in diagram height is given as 0.5 m is but in question 1.5m is given assuming…

Q: A mercury manometer used for measuring pressure difference indicates 50 cm head of Hg. This pressure…

A: Given- Pressure difference=50 cm head of Hg, Pressure difference in meters of water is required.

Q: A differential manometer is attached to a pipe, as shown in the figure. Calculate the pressure…

Q: Manometer with three liquids as shown. SGs are given. Calculate gauge pressure for oil. 20 KPa Water…

A: Given, to determine, Gauge pressure for oil.

Q: A flow rate measuring device is installed in a horizontal pipe through which water is flowing. A…

A: Given Specific weight of Gage fluid = 112 lb/ft3

Q: A manometer is fitted as shown in Figure. Oil, S= 0.9 Determine the pressure at point A. 0.125 m…

A: Given: Specific Gr of Oil Soil = 0.9 Density of Mercury = 13600kg/m3 Take γWater = 1000kg/m3 To…

Q: In a manometer shown in Fig.1, the fluid from A to B is mercury (sp. gravity 13.6) and from B to C,…

A: Given: The specific gravity of the mercury is 13.6. The specific gravity of the oil is 0.80. The…

Q: 6.8 in PA Water FIGUD

Q: Consider the U-tube manometer shown in the figure. Both ends of the U-tube manometer is open to…

Q: The level of mercury in the manometer has the reading shown in . 50 mm 1.5 m 0.3 m Part A Determine…

A: first finding pressure at point A along center line where velocity is zero then applying bernoulli's…

Q: For the shown inverted manometer, all fluids are at 20°C. If P, - P, = 130 kPa, what must the height…

Q: A gasoline line is connected to a pressure gage through a double-U manometer, as shown. If the…

Q: An inverted U-tube of the form shown in Fig. 2.18 is used to measure the pressure difference between…

A: Determine the pressure difference between B and A point.a. If manometer is filled with air. b. If…

Q: A venturi meter 60 cm by 30 cm has its axis downward 30° from the horizontal. The distance measured…

Q: A mercury Manometer is attached to a pipe having suction pressure. The right limb is open to the…

A: Right limb which is open to atmosphere as per given data : For equilibrium condition a) Difference…

Q: A U-tube manometer is arranged, as shown in Fig. 2.15, to measure the pressure difference between…

A: The objective of the question is to calculate the pressure difference between two points in a…

Q: -oil(sg.30.85) 680 mm 1700mm water

Q: Q2:- Calculate the absolute pressure at point B as shown in fig.(2). Neglect the density of air (25…

Q: For the following inverted manometer setup, if the pressure at x is 200 kPa, what is the pressure at…

Q: For the manometer in the figure, determine the difference in gage pressures between points A and B

A: Write the pressure equilibrium equiation between A and B ·When Going down the sign is positive…

Q: 2. The U-tube manometer shown contains multiple fluids. For the giv heights of the fluids, calculate…

Q: 100 пm mercury B OIL

Q: The dead weight tester has been used to calibrate a pressure gage. After finishing the calibration…

Q: Example 2.14. A simple U-tube manometer is installed across an orificemeter. The manometer is filled…

Q: A U-tube manometer is attached to a water pipe as shown in Figure 5.1. Given specific gravity of…

Concept explainers

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?

Question

ZAIN IQ
Asiacell
Quiz (2) --- 6/2/2021
->
الوقت المتبقی 0:16:54 0
Q//
What is the pressure difference (PA -
PB) measured by the U-tube manometer
shown in the figure below.
use S.G. mercury = 13.6, y water = 9.81
KN/m3.
Water
Mercury
Your site doesn't support attaching files
II

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Derive the formula to calculate the pressure:

VIEW

Step 2: Calculate the pressure difference between the points A and B:

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the pressure difference (PA - PB) measured by the U-tube manometer shown in the figure below. use S.G. mercury = 13.6, y water = 9.81 KN/m³. Water Mercury
The pressure difference between two points as measured with a manometer is given as ?2 − ?1 = ??ℎ The following figure shows a single U-tube manometer for measuring pressure difference between points “A” and “B”. By determining the pressure at point “a” through the left leg and then through the right leg, show that the difference in pressure between point “A” ?? and “B” ?? is approximately given by ?? − ?? ≅ ?(ℎ2 − ℎ1)(??2?)
For the setup shown, Determine the rise of liquid h on the left leg of the manometer in inches.
As shown in the figure, water flows in the horizontal pipe. The pipe consists of two different sections, 60 mm and 30 mm in diameter, connected by a smooth reduction. The pressure difference between the two sections is measured with a mercury manometer. Friction effects are neglected. The height between the mercury levels in the two sections of the pipe was determined as 1.4m. Find the velocity and mass flow at points 1 and 2. (Density of mercury: 13.6 grams / cm3, Density of water: 1gr / cm3)
A docs.google.com/forms/d/e/1FAlpQLSetk8UE/ PROBLEM 6: A gasoline line is connected to a pressure gage through a double-U manometer, as shown. If the reading of the pressure gage is 260 kPa, determine the gage pressure of the gasoline line. Assume the density of air to be 1.225 kg/m3 * Oil SG = 0.79 P gage = 260 kPa Gasoline SG= 0.70 Pipe Air 45 cm 50 cm 22 cm 10 cm Mercury SG= 13.6 Water Your answer
show complete solution and diagram
I need help answering this question for a practice quiz, im unsure how to work it out.
Fluid mechanics Problem 6
6. Freshwater and seawater flowing in parallel horizontal pipelines are connected to each other by a double U-tube manometer, as shown in figure. Determine the pressure difference Pfresh water- Psea water= ?(kPa) between the two pipelines. Take the density of seawater at that location to be P = 1035 kg/m³. (2 decimal)
i need the answer quickly
Q/ The laminar flow of water through a pipe is measured by means of a pitot tube situated in the center of the pipe; the reading of a mercury manometer connected to the pitot is 100 mm. The flow is also measured by a venturi meter which connected with the same mercury manometer and the pressure drop across it equals to 300 mm. Find the ratio of venturi to pipe diameter and determine the pressure drop due to friction across the venturi meter.
7. Two water tanks are connected to each other through a mercury manometer with inclined tubes, as shown in figure. If the pressure difference between the two tanks is 20 kPa, determine the value of ? in degrees. (2 decimal)