The mercury manometer shown in (Figure 1) reads h = 0.28 in. Take Hg = 867 lb/ft³. % 57.4 lb/ft³, and Ho =2.09(10³) lb-s/ft². Figure 201 Be 1 of 1 Part A Determine the mass flow of SAE 10W oll through the pipe. Express your answer using three significant figures. IVE ΑΣΦ. HAIvec m = Submit Request Answer < Return to Assignment Provide Feedback ? slug/s

The mercury manometer shown in (Figure 1) reads h = 0.28 in. Take Hg = 867 lb/ft³. % 57.4 lb/ft³, and Ho =2.09(10³) lb-s/ft². Figure 201 Be 1 of 1 Part A Determine the mass flow of SAE 10W oll through the pipe. Express your answer using three significant figures. IVE ΑΣΦ. HAIvec m = Submit Request Answer < Return to Assignment Provide Feedback ? slug/s

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A glass 12 cm tall filled with water is invert the pressure at the closed end? Barometric pressure is 101.325 kPa. What is Ans. 100.15 kPaa Problem 2- 51 In Figure 13, in which fluid will a pressure of 700 kPa first be achieved? Ans: glycerin Proble Po 90 kPa A diffe water ethyl alcohol p= 773.3 kg/m³ mm, 1 betwe 60 m ol p= 899.6 kg/m 10 m water P= 979 kg/m' glycerin p = 1236 kg/m 5 m 5 m 2021/04/16 18:27
Problem #4 If the pressure difference between points 1 and 2 is 25 psi, what will be the flow rate? The pipes are galvanized iron with 0.0005 ft. Take v = 1.06 × 10−5 ft²/s and neglect Kis = minor losses. 10 in. dia 1. 2000 ft, 8 in. dia A B 1600 ft, 6 in. dia с 2. 800 ft, 10 in. dia-
The air exits the nozzle to the atmosphere and enters a vertical plate as shown in the figure. it crashes. The horizontal force required to hold the plate that way is 9 N. Pressure Determine the pressure read on the gauge. Explain under what assumptions a solution can be made. (A1=0,01m2, A2=0,003m2)
A differential manometer is attached to a pipe as shown. Calculate the pressure difference between points A and B. is n. 100 hm re A Mercury B Oil, s = 0.90
Q3: A U-tube containing mercury is used to measure the pressure of an oil of specific gravity 0.82 as in figure 2. Determine (1) Calculate the pressure of the oil, if the difference of mercury level be 400mm What was the application of pascal's law and hydrostatic law for this problem? (ii) ¼ 300 mm Water Water -oil Figure 2 200 mm. 400 mm 400 mm -X -Mercury
A differential "U"-tube manometer containing mercury of density 13000 kg/m³ is used to measure the pressure drop along a horizontal pipe. If the fluid in the pipe is water and the manometer reading is 0.65m, what is the pressure difference between the two tapping points? Fluid density Pw A B a b datum Manometric fluid density p Hg Figure of manometer setup
3. A differential manometer is attached to two tanks, as shown in figure. A) Calculate the difference in pressure of the two chamber B) Calculate the absolute pressure at A if the chamber B is open to atmos phere C) Calculate the pressure at the interface of the oil and mercury if the pressure at point A is 45 kPa Chamber A 1.1 m oil sg=0.89 0.30 m mercury Chamber B B tetrachloride sg= 1.59 0.8 m
3. Figure 3 shows a manometer being used to indicate the difference in pressure between two points in a pipe. Calculate (PA - PB). Oil (sg = 0.90) 0.91 m 0.61 m 1.83 m Water Figure 3 : Manometer
oving to another question will save this réspUI 45 Liquid 1 SG y Liquid 2 SG2 Both the top of the tank and the end of the slanted tube are open to the atmosphere. If L = 3.03 m., x = 85 cm., y = 66 cm., SG1 = 0.9, SG2 = 1.87, what is the angle of tilt (in degrees) of the tube? Round off to two decimal places. A Moving to another question will save this response.
The reading of an automobile fuel gage is proportional to the gage pressure at the botoom of the tank. If the tank is 32 cm deep and is contaminated with 3cm of water. A.) If the tank is full of gasoline what should be the reading at the page in Pa? Use Ywater=9790N/m^3, Ygasoline=6670N/m^3 and Yair=11.8N/m^3 Choices: 1934,2839,3132,2134 B.) How many centimeters of air remains at the top when the gauge indicates full? Choices: 3.75,1.41,4.42,2.36 C.) If the tank is 0.5m^2 in area, calculate the volume of gasoline when the gage reads full Choices: 138 L,160L,145L,123L
QUESTIONS AND PROBLEMS: 1. If 5.6 mm3 of oil weighs 46,800 N. Calculate its density and its specific gravity. 2. Determine the pressure at A in bar gage due to the deflection of the mercury (sp. gr. = 13.6) in the U-tube gage shown in the figure. %3D Water 0.3 m A 0.6 m Mercury 3. For a gage pressure at A of 11,000 Pa vacuum, find the specific gravity of the gage liquid Y in the figure. Air- Liquid X Sp. gr. 1.6 0.4 m 0.50 m 0.3 m Liquid Y 4. a.) convert a pressure head of 15 m of water to meters of oil (sp. gr. =0.75). b.) Convert a pressure head of 600 mm of mercury to meters of oil (sp. gr.= 0.75)
A calibration test of a 15-mm diameter circular sharp-edged orifice in a vertical side of a large tank showed a discharge of 760 N of water in 60 seconds at a constant head of 6.50 m. Measurement of the jet showed that it traveled 3.20 m. horizontally while dropping 450 mm. Compute for the nearest value of the coeficient of discharge. O 0.60724 O 0.67240 O None of the above O 0.64702 O 0.64027