1. The gage pressure of the air in the tank shown in the figure below is measured to be 65 kPa. Determine the differential height h of the merc column. Oil 65 kPa SG = 0.72 75 cm Air Water 30 cm -Mercury SG = 13.6

Q: 1-m³ volume of water is contained in a rigid container. Estimate the change in the volume of the…

A: Volume of water = 1m3 pressure (P)= 40MPa

Q: x=1, y=5

A: Given values: x=1, y= 5 (a)  Fluid A is gasoline, G1 = 0.715 Gauge liquid is mercury, G2 = 13.6 z =…

Q: Calculate the location of the center of pressure, Lp, to in m to the nearest 1000th. Fluid: Orange…

A: Concept: Center of Pressure The total pressure force acting on a fully submerged body is called the…

Q: ds oil as shown. The contact between the cylinder and the wall is smooth. Consider a 2- m length of…

A:

Q: Two lbs of water vapor in a piston-cylinder assembly expands at a constant pressure of 300 lb/in²…

A:

Q: calculations.  A user of the product will apply a force F1 that moves a piston (D = 80 mm)  at a…

A:

Q: The vertical reducing section shown in the figure contains oil with S flowing upward at the rate of…

A:

Q: H.W: An open tube is attached to a tank, as shown in the figure. If the water rises to a height of…

A: Given:- Height of water= 800 mm

Q: What is the gauge pressure at point P in the figure? Assume g = 10 m/s² ¥ Water Immiscible liquid of…

A: Given data- Water depth hw=0.8 m, Immiscible liquid depth hl=1 m, Specific gravity of liquid G=1.6,…