H.W: An open tube is attached to a tank, as shown in the figure. If the water rises to a height of 800 mm in the tube. What are the pressures PA and PB of the air? A Water PB piezometer 여 100 mm B 300 mm 800 mm

H.W: An open tube is attached to a tank, as shown in the figure. If the water rises to a height of 800 mm in the tube. What are the pressures PA and PB of the air? A Water PB piezometer 여 100 mm B 300 mm 800 mm

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

As shown in Figure 1, an ideal gas flows isentropically from a large tank into a converging nozzle and exits to a receiver. The gauge pressure of the ideal gas in the large tank is 80 kPa. The nozzle exit area is 38 cm?. (Assume Pam = 101 kPa). a) Determine Mach Number at section 1, the EXIT mass flow rate and EXIT Mach mumber. b) Calculate the flow area at section 1. V: = 580 km/hr T:= 500 K Exit, A Large Tank P= 166 kPa (abs) Ideal Gas k=1.43 R= 0.2968 kJ/kg.k Vi = 480 kan/hr Figure 1
1. The figure shows a tank discharging through a pipe with a nozzle at its end. Find the discharge and the pressure at the base of the nozzle. Losses are: Tank to the base of nozzle is 5(V1)²/2g and through the nozzle is 0.05(V2)²/2g. (V is the velocity in the pipe and Vz is the velocity at the tip of the nozzle) Water D= 150mm! V Dz= 50mm
A horizontal nozzle of 30 mm diameter discharges a steady jet of water into the atmosphere at a rate of 15 litre per second. The diameter of inlet to the nozzle is 100 mm. The jet impinges normal to a flat stationary plate held close to the nozzle end. Neglecting air friction and considering the density of water as 1000 kg/m³, the force exerted by the jet (in N) on the plate is -
A horizontal nozzle of 30 mm diameter discharges a steady jet of water into the atmosphere at a rate of 15 litre per second. The diameter of inlet to the nozzle is 100 mm. The jet impinges normal to a flat stationary plate held close to the nozzle end. Neglecting air friction and considering the density of water as 1000 kg/m³, the force exerted by the jet (in N) on the plate is -
A 1-m³ volume of water is contained in a rigid container. Estimate the change in the volume of the water when a piston applies a pressure of 43 MPa. m³
A horizontal nozzle of 30 mm diameter discharges a steady jet of water into the atmosphere at a rate of 15 litre per second. The diameter of inlet to the nozzle is 100 mm. The jet impinges normal to a flat stationary plate held close to the nozzle end. Neglecting air friction and considering the density of water as 1000 kg/m³, the force exerted by the jet (in N) on the plate is -
(5) As shown in the image, an air space above a long tube is pressurized to 50 kPa vacuum. Water (15°C) from a reservoir fills the tube to a height h. If the pressure in the air space is changed to 25 kPa vacuum, will h increase or decrease, and by how much? Assume atmospheric pressure is 100 kPa. acuum, will h increase or descrease and by how much? ime atmospheric pressure is 100 kPa. PROBLEM h Air space Water
For the manometer shown, determine the difference in pressure between!
I need the answer quickly
In the Figure below, a pool of liquid sodium is sitting in open atmosphere (and somehow not exploding from the moisture in the air) and an absolute pressure measurement device. The measurement device reads an absolute pressure of P2 at the depth of L in the pool. dP a) Calculate the pressure gradient (-) b) Using Excel plot the pressure distribution from the P2 and P1. Figure 1: A 2-D pool of Sodium on Earth that magically is keeping all of it's liquid inside even though it has no front and back sides.
A horizontal nozzle of 30 mm diameter discharges a steady jet of water into the atmosphere at a rate of 15 litre per second. The diameter of inlet to the nozzle is 100 mm. The jet impinges normal to a flat stationary plate held close to the nozzle end. Neglecting air friction and considering the density of water as 1000 kg/m³, the force exerted by the jet (in N) on the plate is -
In figure 2.5, if the pressure of gas in bulb A is 50 cm Hg vacuum and Patm = 76 cm Hg, the height of column H is equal to Patm H 424 Hg: