Q₁ a: Compute the depth of drilling required for site investigation purposes. The type of foundation is circular foundation with diameter equal to 12 m, the depth of foundation is 2 m and the stress intensity is q. = 130 kN/m². Assume that average unit weight of soil equal to 18 kN/m². -You may need the following equation AP=q. (1-(1/(1+(B/2z)2)15)) in the solution.

Q₁ a: Compute the depth of drilling required for site investigation purposes. The type of foundation is circular foundation with diameter equal to 12 m, the depth of foundation is 2 m and the stress intensity is q. = 130 kN/m². Assume that average unit weight of soil equal to 18 kN/m². -You may need the following equation AP=q. (1-(1/(1+(B/2z)2)15)) in the solution.

Principles of Foundation Engineering (MindTap Course List)

8th Edition

ISBN:9781305081550

Author:Braja M. Das

Publisher:Braja M. Das

Chapter5: Ultimate Bearing Capacity Of Shallow Foundations: Special Cases

Section: Chapter Questions

Problem 5.9P

See similar textbooks

Similar questions

From the given soil element, determine the major principal stress, in kPa, using the Pole Method. 150 kPa A 60 kPa 45⁰ 90 kPa 60 kPa B
Exl: A footing is uniformly loaded with q = 100 kN/m² as shown in the figure. Compute the vertical stress increments under Points A, B, at z = 10 m. 13.5 m 7.0 m Footing 12 m (Plane view) 6.0 m
The square footing shown in the figure carries a load of 3500 kN. Assume that the stress below the footing is distributed at a slope of 1H:2V. The clay layer is overconsolidated with OCR=2. Pls answer asap. 3 decimal places.
The excavation was being done for a foundation trench in a plastic clay having a unit weight of 2.3 gm/cc. When the depth of excavation reached 4 meters, it failed. On the Assumption that ☀ = 0, the value of the cohesion of the clay is?
A footing of size 2m×2m transferring a pressure of 200 kN/m², is placed at a depth of 1.5 m below the ground as shown in the figure (not drawn to the scale). The clay stratum is normally consolidated. The clay has specific gravity of 2.65 and compression index of 0.3. 1.5m 1m 1.5 m 200 kN/m² Silty sand Clay Ya =15kN/m³ Y sat = 18kN/m³ Y sat = 17 kN/m³ GWT $0.5 m Dense sand Considering 2:1 (vertical to horizontal) method of load distribution and Y₁ = 10kN/m³, the primary consolida- tion settlement (in mm, round off to two decimal places) of the clay stratum is
The figure below shows a proposed foundation site, with 10 ft of sand overlying 20 ft of clay with consolidation properties shown. The clay is normally consolidated. Assume 1-D conditions.a. Compute the initial σ′v at the middle of the clay layer prior to excavation and constructionb. After excavation and during construction, the foundation area will be heavily loaded with the structure and equipment so that σ′v at the middle of the clay layer will be increased to 3900 psf. Determine the settlement that will occur under these conditionsc. After construction is completed, the equipment will be removed and the final σ′v at the middle of the clay layer will be 3200 psf. Compute the swell that occurs after the equipment is removed
Solve Problem 7.8 using Eq. (7.29). Ignore the post-construction settlement. 7.8 Solve Problem 7.4 with Eq. (7.20). Ignore the correction factor for creep. For the unit weight of soil, use γ = 115 lb/ft3. 7.4 Figure 7.3 shows a foundation of 10 ft × 6.25 ft resting on a sand deposit. The net load per unit area at the level of the foundation, qo, is 3000 lb/ft2. For the sand, μs = 0.3, Es = 3200 lb/in.2, Df = 2.5 ft, and H = 32 ft. Assume that the foundation is rigid and determine the elastic settlement the foundation would undergo. Use Eqs. (7.4) and (7.12).
A soil profile is shown in the following figure. A new footing will be placed on the ground and the average vertical stress increment at the midpoint of the clay layer due to the new footing will be Ao, = 25.5 kPa. Estimate the final primary consolidation settlement of the clay layer. Assume that the clay is normally consolidated. New footing 2.8 m Ydry 18.0 kN/m³ W.T. 4.2 m Ywet = 18.6 kN/m³ 3.0 m = Ywet 18.2 kN/m³, e₁= 0.82 LL = 44, PL = 20 Sand Sand Clay Sand
Estimate the increase in vertical stress at 0.5 m depth intervals, within the clay layer, below point A (See figure below). The foundation exerts a uniform vertical stress of 120 kPa at ground level. Using these values estimate the settlement due to the clay layer. (Hand in any graphs used) 5m 5m 2m 3m Very Dense Sand 2m 1.5m Clay E=3.5 MPa 2m Bedrock Soil profile A Plan of building 3m Soil profile and plan for Question 4 3m FA
A rectangular footing is uniformly loaded with q = 75 kN/m? as shown in the figure. Compute the vertical stress increments under Points A, B, and C at z = 5 m. 15 m 3.5 m A 1.87 m 8 m B Footing (Plane view)
A footing of size 2m x 2m transferring a pressure of 200 kN/m2, is placed at depth of 1.5 m below the ground as shown in the figure (not drawn to the scale). The clay stratum is normally consolidated. The clay has specific gravity of 2.65 and compression index of 0.3. 200 kN/m? 1.5 m GWT Ya = 15 kN/m 18 kN/m elemiu 1 m Silty Sand Ysat = 10.5 m 1.5 m Clay Yat = 17 kN/m Dense Sand Consideration 2:1 (vertical to horizontal) method of load distribution and yw primary consolidation settlement (in mm, round off to two decimal places) of the clay stratum is 10kN/m, the
Question 1) For a shallow foundation measuring (1.7 m x 2.2 m) as shown below: , C. Estimate the primary consolidation settlement; when the bottom sandy layer is replacing with a 5 m thickness of a clay layer. Noting that, the propertiės of the clay are the same for the bottom sandy soil. Use yw=10 kN/m³ qnet= 1.2 MN/m2 G.S 1.5 m Sand Ya=16 kN/m³ Ysat= 17 kN/m3 %3D 2.5 m N60=52 V W.T. Silty Sand Yd=18 kN/m³ Ysat = 18.5 kN/m? N60=52 3.5 m Sand Ya=19 kN/m3 Ysat = 22 kN/m³ e, = 0.4, Ae=0.04 , o'= 194 kN/m2 5 m Cc= 0.3, Cs= 0.2 , Ca= 0.05 N60=60 CS Scanned with CamScanner