PROBLEM 3 340 mm The plates are connected by 9-20 mm bolts. Force F = 50 KN are applied at both plates in opposite directions as shown in Figure 3. Compute the following: A. Axial stress of each plate. F 150 mm 中 F B. Shear stress of each bolt. Assume that each bolt resists the applied force equally. 50 mm 340 mm Figure 3: Bolted Plates

Q: afe strength of a 5/16 in. fillet weld if it's actual length is 3 1/2 in. and the allowable unit…

A:

Q: The following image shows a front and side view of the column connection. The bolts have a diameter…

A:

Q: Consider the girder and the moving loads shown in (Figure 1). Suppose that P= 101 kN. A 6 m C 10 mi…

A:

Q: Six rivets are used in the connection shown in the figure. If both P=50kN, what is the minimum…

A:

Q: diameter of washer = 9/8 inch = stress in the nut 18 ksi g stress 800 psi

A: d=7/8 inch  dia of root thread = 0.731 inch din = 9/8 inch tensile stress = 18ksi bearing stress  =…

Q: Q2:If allowable stresses are at = max. value of W. W 2m 8m 165MPa, oc = 100MPa t = 70MPa determine…

A:

Q: 6. The round bar shown has steel, brass, and aluminum sections. Axial loads are applied at cross…

A:

Q: A bracket shown in the figure 6.9 carries an eccentric load of 30 kN at an eccentricity of 200 mm.…

A:

Q: A hole 12 mm diameter is to be punched through a plate 18 mm thick. If the shear strength of the…

A: Diameter of hole  d=12 mm and is punched through a plate 18 mm thick   plate thickness t= 18 mmthe…

Beams

In structural engineering, a beam is a component made of a variety of materials (including steel alloys, and wood) that can resist loads applied laterally to the beam axis. Members, elements, rafters, shafts, and purlins are all terms used to describe beams.