PROBLEM 11.136 To test its performance, an automobile is driven around a circular test track of diameter d. Determine (a) the value of d if when the speed of the automobile is 45 mi/h, the normal component of the acceleration is 11 ft/s“, (b) the speed of the automobile if d = 600 ft and the normal component of the acceleration is measured to be 0.6 g.

PROBLEM 11.136 To test its performance, an automobile is driven around a circular test track of diameter d. Determine (a) the value of d if when the speed of the automobile is 45 mi/h, the normal component of the acceleration is 11 ft/s“, (b) the speed of the automobile if d = 600 ft and the normal component of the acceleration is measured to be 0.6 g.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

1 A 6-ft board is placed in a truck with one end resting against a block secured to the floor and the other leaning against a vertical partition. Draw the FBD and KD necessary to determine the maximum allowable acceleration of the truck if the board is to remain in the position shown.
PROBLEM 12.34 A single wire ACB of length 2 m passes through a ring at C that is attached to a sphere which revolves at a constant speed v in the horizontal circle shown. Knowing that 0₁ = 60° and ₂ = 30° and that the tension is the same in both portions of the wire, determine the speed v. v = 2.49 m/s
Q.1: A ball is tossed with a velocity of 10 m/s directed vertically upward from a window located 20 m above the ground. Knowing that the acceleration of the ball is constant and equal to 9.81 m/s2 downward, determine: (a) the velocity v and elevation y of the ball above the ground at any time t, (b) the highest elevation reached by the ball and the corresponding value of t, (c) the time when the ball will hit the ground and the corresponding velocity. Draw the v-t and y-t curves. V- -10 m/s a--9.81 m/s Yo= +20 m SIH HASSAN
applied mechanics 2
A polisher is started so that the fleece along the circumference undergoes a constant tangential acceleration of 4 m/s2 . Three seconds after it is started, small tufts of fleece from along the circumference of the 225-mm-diameter polishing pad are observed to fly free of the pad. At this instant, determine (a) the speed v of a tuft as it leaves the pad, (b ) the magnitude of the force required to free a tuft if the average mass of a tuft is 1.6 mg.
When studying whiplash resulting from rear-end collisions, the rotation of the head is of primary interest. An impact test was performed, and it was found that the angular acceleration of the head is defined by the relation a= 700 cos0 + 70 sin 0, where a is expressed in rad/s2 and 0 in radians. Knowing that the head is initially at rest, determine the angular velocity of the head when 0= 30°.
i need the answer quickly
Q.4: The acceleration of a particle is defined by the relation a = kt. (a) Knowing that v = 28 m/s 18 m/s when t= 2 s, determine the constant k. (b) Write the %3D !3! when t = 0 and that v = equations of motion, knowing also that x = 0 when t = 2 s.
1. At an intersection car A was traveling south and car B was traveling 35° north of east when they slammed into each other. Upon investigation it was found that after the crash the two cars got stuck and skidded off at an angle of 15° north of east. Each driver claimed that he was going at the speed limit of 60 km/h and that he tried to slow down but couldn't avoid the crash because the other driver was going a lot faster. Knowing that the masses of cars A and B were 1000 kg and 1200 kg, respectively, determine (a) which car was going faster, (b) the speed of the faster of the two cars if the slower car was traveling at the speed limit. شکایت VB N 135⁰ B A V 15°
Please answer this Problem. Thanks!
applied mechanics 2
(11.46) SAMPLE PROBLEM 11.12 The rotation of the 0.9-m arm OA about O is defined by the relation 30.15t", where 0 is expressed in radians and t in seconds. Collar B slides along the arm in such a way that its distance from O is r = 0.9 – 0.12r, where r is expressed in meters and t in seconds. After the arm OA has rotated through 30°, determine (a) the total velocity of the collar, (b) the total acceleration of the collar, (c) the relative acceleration of the collar with respect to the arm.