Please solve fastly You are an oil and gas exploration reservoir engineer and your manger asked you to calculate the porosity for the following reservoir. Seismic data have been used to delineate reservoir structure (The length of this reservoir is about 200 meter, thickness is 1 meter and width is 0.8 km). A- Calculate the bulk volume of the reservoir in m3 . Make sure all the unit is consistent with each other. B- Assume that the pore spaces of the sediment in the oil-bearing unit are full of oil 32000m3. Calculate the porosity of the reservoir. C- Based on the porosity value. Is this negligible, poor, fair , or very good reservoir ( try to find table for reservoir classification based on porosity value)

Q: A sand deposit contains three distinct horizontal layers of equal thickness. The hydraulic…

A:

Q: corresponding val- of y1. (y = 27 kN/m') (b) Crystalline igneous rocks like granite, gneiss, and…

A: a.)  The Mullers equation can be written as: ηγ=γ-γ1 Substitute the value of n as '0.35' in above…

Q: A clay layer having a thickness of 13.19 m. has an initial void ratio of 1.18. It is compressed and…

A:

Q: A natural deposit of soil was found to have a water content of 27% and to be 88% saturated. Gs=2.7.…

A: Given :- water content = 27%         Degree of saturation= 88%                         Gs= 2.7

Q: The following table contains the estimated bulk mass densities as a function of depth for an…

A: Compaction is the process by which the soil is well distributed and its value is pressed by the…

Q: For constant head laboratory test on fine sand, the following values are obtained. Length of…

A: we knowk=QLAhtQ=0.044in3L=10inA=π42.52h=22int=2minso,k=0.044in310inπ42.52×22in×2mink=0.002037inmin

Q: A soft to very soft silty clay layer 3 m thick exists between a layer of permeable clayey silty sand…

A: Given Equation, Ss=Cα'H·log t2t1 where C'α=Ca1+ep Estimation of values, CaCc=0.04 hence…

Q: A cubic meter of dry (no water) quartz sand (G, = 2.65) with a porosity of 60% is immersed in an oil…

A: Vt = 1 m3Gs = 2.65n = 60% or 0.60 = 0.92 g/cm3 or 920 kg/m3 Vair = 0.27 m3

Q: shown in the figure. The coefficient of permeability of the Water is flowing through the…

A:

Q: A soil specimen is 38 mm in diameter and 76 mm long and in its natural condition weighs 168.0 g.…

A: Since you have asked multiple parts and both parts are different. As per company policy we can only…

Q: A pump test was conducted on a test well drilled into a confined aquifer, with the results showr **…

A:

Q: 4. Is Turbulent Flow Possible? Water flows through sand with an average particle size of 0.70 mm.…

A: given that is  Average particle size              =0.70mm Water temperature at sub surface  150C…

Q: The results of a constant head permeability test for a fine sand are as follows: Diameter of the…

A: solution For constant head permeability dia of sample d=33cm Area=π4d2=π4×332=855.3cm2Length of the…

Q: accordance with the Shields diagram; for a bed-quartz sediment particle of diameter € 6.177 mm and…

A: Diameter = 6.177 mmspecific gravity = 2.65 inthe specific weight = 9810 N/m3To find:The kinematic…

Q: petroleum reservoir has an areal extent of 20,000 ft2 and a pay zone thickness of 100ft. The…

A: Given that .....

Q: . The difference between the free water levels in two wells 48 m part in an aquifer is 0.6m. It took…

A:

Q: 1. Assumptions for using Darcy’s law. 1.1. Darcy’ Equation 1.2. Units of each parameter in Darcy’s…

A:

Q: The volume of a reservoir is 2×107 m3, the catchment area is 500 km2, the average annual inflow of…

A:

Q: From the laboratory result of a sample taken from the field, the total volume of wet sample is 1x…

A:

Q: The results of a constant head permeability test for a fine sand are as follows: Diameter of the…

A:

Q: A soil sample has solids with effective (D10) = 0.004 mm. The effective pore diameter is 30% of…

A:

Q: Mean diameter of the particles present of the bottom of a channel is 5cm. If the value of chezy's…

A:

Q: A canal is cut into a soil with a stratigraphy as shown. Assume that flow takes place horizontally…

A:

Q: Question #4: It has been anticipated that the soil under the proposed dam is contaminated, and needs…

A: NOTE:“Since you have posted a question with multiple sub parts, we will provide the solution only…

Q: 2 The difference between the free water levels in two wells 48 m apart in an aquifer is 0.6 m. It…

A:

Q: 1. (30 pts) The soil profile shown below consists of 10 meters of sandy silt overlying gravel. The…

A: Step 1:Step 2: Step 3: Step 4:

Q: Sketch Mohr's Circle for Strain. Indicate the following Y Max InPlane on your sketch the following…

A:

Q: A CD test was conducted on a sample of dense sand 37 mm in diameter x 77 mm long. The cell pressure…

A:

Q: The contour map in Figure 1 depicts porosity variation  within a sandstone reservoir. The lines…

A: Solution: Given: Dimensions: 10 miles long, 3 miles  wide, 100 ft thick Section Area ft2…

Q: A soil sample is consolidated in the triaxial chamber under a chamber pressure of 200 kN/m2. The…

A: diverter = deviator   Given data,  Triaxial consolidation  drain valved is closed, which means pore…

Q: The porosity of the sedimentary rocks is high in comparison with other types of rocks. Accordingly,…

A:

Q: The given values are as follows: The specimen's e=0.46 length of soil specimen=450mm constant…

A: The given data is: Void ratio of specimen (e) = 0.46 Length of soil specimen (L) = 450 mm = 0.45 m…

Q: on at the bottom of th ostatic pore pressure nodels at 2250m:

A: Numerical analysis -the part of arithmetic that arrangements with the turn of events and utilization…

Q: The results of a constant head permeability test for a fine sand are as follows: Diameter of the…

A:

Q: A wet sand sample has a volume of 4.64 x 10-4 m3 and weighs 8N. After oven-drying, the weight…

A:

Q: what is the pore volume of the sample?

A:

Q: A layered soil is shown in following figure. a) Estimate the hydraulic conductivity for flow in the…

A: Given data of soil  Assume  K1 = 10-3 cm/sec  K2 = 2 *10-4 cm/sec  K3 = 10-5 cm/sec  K4 = 2 *10-3…

Q: The results of a constant head permeability test for a fine sand are as follows: Diameter of the…

A:

Q: Calculate the Porosity. Area = 16468 acres

A: Porosity provides information of void spaces in a material. Also known as void fraction.

Q: The volume of a reservoir is 2×107 m3, the catchment area is 500 km2, the average annual inflow of…

A:

Q: Q2: check the true and false for the following sntences and correct the false if found: 1- Acid…

A: 1. False, because acidic magma is rich in silica, while basic magma is poor in silica and rich in…

Q: Homework 1: a sample of rock has a total mass of 300 gm and a dry mass of 250 gm with a real…

A:

Q: (b) An oedometer test on a specimen of fully saturated stiff clay gave the following results in…

A: From the table calculate the thickness ; Thickness = initial thickness-change in thickness The…

Q: 10. Which one of the following is an assumption made by Coulomb in the development of his earth…

A:

Q: The results of a constant head permeability test for a fine sand are as follows: Diameter of the…

A: Given data of constant head permeability test  Diameter of the sample (Ds) = 47 cm  Length of sample…

Q: A fall cone test was carried out on a soil to determine its Atterberg limits using a cone of mass 80…

A: Given the results of the fall cone test using a cone of mass 80g as,

Q: O 40 80 120 160 200 Fycess nore pressurelkN/m2)

A: Given data: A soil profile consists of a clay layer between layers of sand, the water table being…

Groundwater Flow

The term groundwater refers to the water which is found beneath the earth's surface. Pores present in the soil and rocks with fractures make a passage for rainwater to enter the earth's surface and deposit as groundwater. The flow nature and direction of groundwater under the earth's surface directly impacts the strength and compressibility of the soil, which reflects its ability to support structural loads.