From the laboratory result of a sample taken from the field, the total volume of wet sample is 1x 10ˉ³ m³ and weight of wet sample is 2 kg. Water content is 12%. Gs = 2.80. emax = 0.68 and emin = 0.42 1. Which of the following gives the dry unit weight?  a. 19.62 kN/m³ b. 21.26 kN/m³ c. 17.52 kN/m³ d. 23.54 kN/m³   2. Find the void ratio.  a. 0.167 b. 0.423 c. 0.292 d. 0.567   3.  Find the relative density.  a. 54.23% b. 43.46% c. 50.16% d. 49.15%

Q: After 1440 min the thickness of the specimen was 15.30 mm and the water con- tent was 23.2%.…

A: Given- A result from odometer test on specimen of saturated clay, the applied pressure is increased…

Q: Q9) The saturated clay sample put into the wax with unit density of 0.8gm/cm³ and its weight 8gm.…

A: Density of the waxγwax=0.8 gm/cm3 and mass of wax  Mwax=8 gmvolume of wax=mass density=80.8=10…

Q: Soil Mechanics An undisturbed sample of saturated clay has a volume of 16.5 cm3 and weighs 35.1 g.…

A:

Q: The Poisson's ratio for soil sample 1 and 2 are µj and µ2 respectively. 1-41 1-H2 Hi If 4 = 1.5 and…

A:

Q: A project engineer receives a laboratory report with tests performed on a certain soil sample on a…

A: Part (a)

Q: 1.11 A sample of soil 10 cm diameter, 15 cm length was tested in a variable head permeameter. The…

A:

Q: For a saturated soil sample with a void ratio of 0.920 and a saturated density of 1.690 t/m³.…

A: Answer:-                    In this question problem can be solve by using the formula of saturated…

Q: The wet density of soil mass= 1800 kg/m³ and the dry mass=90kg. If the w = 10 % and G₁ = 2.6,…

A:

Q: The Poisson's ratio for soil sample 1 and 2 are µj and µ2 1-41 = 1.5 and 1-42 respectively. If…

A:

Q: A soil sample is taken from a borehole. Sample diameter is 50mm and length is 250mm. Sample weight…

A:

Q: 1. Assumptions for using Darcy’s law. 1.1. Darcy’ Equation 1.2. Units of each parameter in Darcy’s…

A:

Q: Use the Hazen Method to estimate the hydraulic conductivity of the soil shown in the following…

A: To Determine :-  Hydraulic conductivity (k) using Hazen method.

Q: A soil sample has solids with effective (D10) = 0.004 mm. The effective pore diameter is 30% of…

A:

Q: Test no. Water Content Dry Unit Weight (KN/m³) |(%) 5.75 1 16.79 8.60 19.20 3 13.7 19.28 4 16.8…

A: Given, Water content (%) Dry Unit Weight (KN/m3) 5.75 16.79 8.60 19.20 13.7 19.28 16.8…

Q: 14.A constant head permeability test is conducted on a certain soil. The diameter of the sample is…

A:

Q: A 20-cm long soil sample is acquired with a cylindrical tub having a 5-cm diameter. On removal from…

A: Given: 20 cm long sample  Diameter of cylinder = 5 cm  Initial weight = 525 g  Dry weight = 503.2g…

Q: The figure presents stratified soil sample in a tube that is 325 mm × 325 mm in cross-sectional…

A: To determine the equivalent permeability of the layered soil.   Given, Soil A: Length of layer, La =…

Q: - Find the moisture content, using dry weight per trial based on the table. - Solve the mean,…

A: For Trial 1: Weight of empty watch glass, say W1 (g) = 38.1151 Weight of watch glass and soil…

Q: A soil sample 12 cm in diameter is placed in a tube 1 m long. A constant supply of water is allowed…

A:

Q: soil with a volume of 163cm^3 is sampled from a field. It weighs 221g. Then, the sample was…

A:

Q: Sand-cone equipment is used to determine an in-place unit weight (field density test) on a compacted…

A:

Q: To determine the water content of a soil, pycnometer test is employed. Based an the below given…

A: Weight of moist sample M2-M1=255.65 gm, Mass of pycnometer + soil + water = M3=3120.40 gm Mass of…

Q: g) Weight of water in KN that must be added per m3 for a 90%-degree saturation h) Mass of water in…

A: Given Data: γb=1960 Kg/m3 γs=2700 kg/m3 Assuming γw=1000 kg/m3 Assuming specific gravity G= 2.7…

Q: The figure below shows three layers of soil in a tube that is 125mm x 125mm in cross section. Water…

A:

Q: In the soil mechanics laboratory of UCONTI, the following masses were obtained: Wet sample weight +…

A:

Q: A 4.576 Kg of a soil with o = 20% & G, =2.68 were extracted from a hole at the surface of the soil…

A: This question is related to the Soil Properties from Geotechnical Engineering. In this problem we…

Q: A pumping test was made from a well in a permeable layer underlain by an impervious stratum. When…

A: Given that for a pumping test from a well in a permeable layer underlain by an impervious stratum, q…

Q: 3- The natural water content of a sample taken from a soil deposit was found to be 1.5%. It has been…

A: To find the amount of water to be added in the natural state of soil per 1000 grams to make the…

Q: The following are the results of the laboratory shrinkage limit test (using mercury for displacement…

A:

Q: Following is the result from the liquid limit test for a soil. y = -18.67In(x) + 111.39 60 55 50 45…

A: Liquid limit is defined as water content corresponding to 25 number of drops.

Q: The 7 day BOD of a water sample was found to be 150 mg/lt. Determine the 5 day BOD of sample and…

A: Given: 7 day BOD, L7 = 150 mg/lt Reaction rate constant, k = 0.23/day

Q: A soil sample has a bulk unit weight of 17.5 kN/m^3 at a water content of 10.1%. Use Gs=2.58…

A:

Q: A dry soil sample has the total mass (kg) shown in the table below. Use the data provided to…

A: MT = 452.65 kg  e = 0.45 Gs = 2.70

Q: Atterberg's Ilimits Problem 4.3 Results from liquid and plastic limit tests conducted on a soil are…

A:

Q: The following data were obtained from sand-cone experiment where a volume of a certain soil is…

A:

Q: O 40 80 120 160 200 Fycess nore pressurelkN/m2)

A: Given data: A soil profile consists of a clay layer between layers of sand, the water table being…

Field applications of hydraulic conductivity

Hydraulic conductivity is one of the hydraulic properties of soil defined as a measurement of the ability of a porous medium to permit water movement or fluid flow through it. It is denoted by the letter K. It is influenced by the density and viscosity of the fluid. It is also called permeability. Hydraulic conductivity is defined as the ratio of velocity to the hydraulic gradient. The different methods used to determine the hydraulic conductivity are laboratory methods (constant head permeability tests and falling head tests), in-situ field methods (pumping in and pumping out tests), small scale field tests (infiltration tests and slug tests), and indirect methods such as estimation from grain size, consolidation test data, and horizontal capillary test. The pedotransfer function (PTF) method is a specific empirical estimating approach employed in the soil sciences is also used to determine the hydraulic conductivity of the soil.