One of the student wanted to analyse phosphate ion concentration in Fertilizer industry wastewater sample collected from Rusayl Industrial Estate using spectrophotometer method. She mixed 200.00 mL of wastewater sample which contains only Na,PO. (unknown molarity) with 400.00 mL of 0.0200 M K,PO, in a one liter beaker to make a Solution A. She then transferred 25.00 ml of Solution A to a 250.00 ml volumetric flask and added distilled water up to the calibration mark to make up Solution B. The Concentration of phosphate ions in Solution B is known to contain 3.00 x 10 mol/L from the spectrophotometric analysis at 460 nm using 1 cm cuvette. Calculate the concentration of phosphate ion in wastewater and how many phosphate ions are present in this wastewater.

One of the student wanted to analyse phosphate ion concentration in Fertilizer industry wastewater sample collected from Rusayl Industrial Estate using spectrophotometer method. She mixed 200.00 mL of wastewater sample which contains only Na,PO. (unknown molarity) with 400.00 mL of 0.0200 M K,PO, in a one liter beaker to make a Solution A. She then transferred 25.00 ml of Solution A to a 250.00 ml volumetric flask and added distilled water up to the calibration mark to make up Solution B. The Concentration of phosphate ions in Solution B is known to contain 3.00 x 10 mol/L from the spectrophotometric analysis at 460 nm using 1 cm cuvette. Calculate the concentration of phosphate ion in wastewater and how many phosphate ions are present in this wastewater.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

An engineer is attempting to estimate a) the hydraulic retention time (HRT), and b) the volume of a small lake. Using Br- as a conservative tracer, they very quicky adds NaBr from a boat in the middle of the lake and observes it to distribute almost instantly to a Br- concentration of 100 mg/L (precisely!). After 60 days, the concentration of Br- has dropped to 40 mg/l. What is the HRT in days? The outflow of the lake is measured by through the pipes in the dam that holds water in the lake. The total flow is 10,000 m3 /day. What is the volume of the lake?
Water analysis was carried out for solid analysis. The test was performed and the following information collected. Mass of empty dish = 51.5494 g; Mass of dish + Sample = 109.5 g; Mass of dish + dry solids =51.587 g; Mass of dish + ignited solid =51.541 g; Mass of empty filter = 0.1154 g; Mass of filter after drying = 0.1241 g; Mass of filter at ignition = 0.1160 g; Volume of sample =25 mL Compute the concentration of total solids, total volatile and fixed solids, suspended, volatile suspended solids and fixed suspended solids.
A primary clarifier is to be designed to treat a municipal wastewater. The influent to the clarifier has a flow rate of 7570 m³/d and a total suspended solids concentration of 320 mg/L. A laboratory settling test was performed with the following results: Suspended Solids Concentration (mg/L) at Given Depths Sampling Depth (m) Time (min) 0.61 1.22 246 2.44 272 243 1.83 3.05 10 230 262 282 20 157 195 230 253 30 115 160 211 221 230 45 90 134 163 179 195 60 48 102 131 154 170 90 29 58 86 115 141 (a) Determine the design overflow rate and detention time assuming 65% of the suspended solids are to be removed. Use typical scaling/safety factors as appropriate. (b) Determine the required diameter (to the nearest 0.1 m) and the required depth (to the nearest 0.01 m) for the clarifier.
Determine the suspended solids and the percent volatile matter in a solids sample based on the following data: Sample size 25 mL Tare mass of filter = 1.5325 g Tare mass of filter plus retained solids = 1.5415 g Tare mass of filter plus retained ash = 1.5378 g
Wastewater Engineering civil engineering (10)
i need the answer quickly
A synthetic sample of water is prepared by adding 100 mg Kaolinite (a clay mineral), 200 mg glucose, 168 mg NaCl, 120 mg MgSO4, and 111 mg CaCl₂ to 1 liter of pure water. The concentrations of total solids (TS) and fixed dissolved solids (FDS) respectively in the solution in rug/L are equal to A 699 and 599 B с D 599 and 399 699 and 199 699 and 399
For an electrostatic precipitator of given geometry and operating conditions, the collection efficiency for 2 micrometer particles is 99.90 percent. On the basis of a Deutsch-type equation for efficiencies, estimate the collection efficiency for (a) 1 micrometer and (b) 0.5 micrometer particles
Find BOD5 @ 20degree and BOD3 @ 30 degree
What diameter would a circular clarifier have to be to remove 50 μm particles with 75% efficiency from a 4 MGD (million gallon per day) flow? Assume the particle specific gravity is 1.5 and the temperature is 10°C. Answer: 18 m
(₁ ) A PM10 sampler was operated for a period of 24 hours at a flow rate of 0.7 m³/min. The filter tare weight was 1.7911 g, and the dried filter weight after sampling was 1.8521 g. Calculate the PM10 concentration in µg/m³.
1. The following information is provided for an activated sludge system design: Parameter Symbol Value Units Flow rate Q 10000 m³/d Influent BOD So 150 mg/L Effluent BOD S 2 mg/L Hydraulic residence time Ꮎ 4 hr Mean cell residence time Oc 6 d Maximum specific growth rate μm 3 1/d Half saturation constant Ks 40 mg/L Yield coefficient Y 0.5 Endogenous decay coefficient b 0.08 1/d Death rate coefficient γ 0.04 1/d Determine: a) The aeration tank biomass concentration (X) in mg/L b) The aeration tank oxygen requirement in kg/d c) The rate of biomass wasting in kg/d