A synthetic sample of water is prepared by adding 100 mg Kaolinite (a clay mineral), 200 mg glucose, 168 mg NaCl, 120 mg MgSO4 and 111 mg CaCl₂ to 1 liter of pure water. The concentrations of total solids (TS) and fixed dissolved solids (FDS) respectively in the solution in rug/L are equal to A 699 and 599 B 599 and 399 C 699 and 199 с D 699 and 399

A synthetic sample of water is prepared by adding 100 mg Kaolinite (a clay mineral), 200 mg glucose, 168 mg NaCl, 120 mg MgSO4 and 111 mg CaCl₂ to 1 liter of pure water. The concentrations of total solids (TS) and fixed dissolved solids (FDS) respectively in the solution in rug/L are equal to A 699 and 599 B 599 and 399 C 699 and 199 с D 699 and 399

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

You are designing a 20 mgd wastewater treatment plant. To characterize the plant's influent solids, the lab used 90 ml samples of the ty[ical wastewater and the following equipment: Lab Equipment Evaporation Dish Gooch crucible 2.0-micron paper filter 2.0-micron Whatman GF/C filter Lab Measurement Dish + Residue after evaporation Weight 54.2830g 54.2170g 1.5240g 1.6948g 54.349g
Water quality indicates that the water contains Na* at 50 mg/L, K* at 30 mg/L, Ca2+ at 80 mg/L, and Mg²+ at 65 mg/L (all concentrations are already in mg/L as CACO3). What is the hardness of the water (in mg/L as CaCO3)?
The raw sludge has solid content of 5% and the digested sludge has moisture content of 85%. The ratio of volume of raw sludge to the volume of digested sludge is .
One of the most challenging problems in environmental remediation is isolated blobs of contaminated fluid that become trapped in soils by capillary forces (i.e., surface tension). The pore space can be analyzed by analogy to a thin-diameter glass tube. Under the conditions given, what is the maximum length of water, I, that can be retained in the vertical glass tube shown? [mm] • contact angle 0 = 0⁰ • surface tension o= 72 dyn/cm = 0.072 N/m • tube diameter D = 2.0 mm • ● neglect the small volume of water above the meniscus the weight of water completely removes the curvature in the lower air-water interface
(c) An analysis of a water sample has produced the following concentrations, as shown in Table 1(c). Determine the following and comment on the result: (i) Total Hardness in mg/L as CaCO3 (ii) Carbonate Hardness in mg/L as CACO3 (iii) Alkalinity in mg/L as CACO3
Calculate the alkalinity of a water containing 10−4.5 M total carbonate at pH 11. Express your answer in units of mg/L–CaCO3. State all relevant assumptions.
You have 1 mL (total volume) sample of quartz spheres, and it has a mass of 2.00g . What is the Void Ratio, using only the above information? Void Ratio: e = Vv /Vs Vv= volume of voids Vs = volume of solids
2. The suspended solids content is determined by filtering a portion of the sample through a glass-fiber filter disk, drying the disk at 105°C, and igniting the residue by placing the dried sample in a muffle furnace at static (?). The following masses are recorded: • Volume of sample: 30 mL • Mass of filter disk: 0.1170 g a) The total suspended solids content is: b) The volatile suspended solids content is: Mass of disk and dry solids: 0.1278 g Mass of disk and ignited solids: 0.12489 g c) The fixed suspended solids content is:
ES C raudon . A water contains 200 mg/L Ca, 75 mg/L Mg, 180 mg/L HCO,, and 150 mg/L. CO₂, all expressed as CaCO3. Determine the chemical dosages required to soften this water as much as possible without removing magnesium. What will the final hardness be? let
Water analysis was carried out for a groundwater sample. The sum of the anions is equal to the sum of the cations. Calculatea) Total hardnessb) Carbonate and Non-Carbonate Hardness Hardnessc) Alkalinity
The following mineral analysis was reported for a water sample taken from a municipal groundwater water well. Determine the total, carbonate and non carbonate hardness in mg/L as CaCO3 using the predominant polyvalent cation definition of hardness. All reported as "mg/L as the ion" Iron 0.2 Manganese 0.6 Ammonium 0.5 Sodium 4.7 Potassium 0.9 Calcium 67.2 Magnesium 39 Barium 0.5 Silica 20 Flouride 0.35 Boron 0.1 Nitrate 0 Chloride 4.5 Sulfate 29 Alkalinity 284 as CaCo3 pH 7.6 units
lon concentrations obtained for a ground water sample (having pH = 8.1) are given below Ca2+ Mg2+ Na+ HCO3- SO4²- CI- 2- Ion Ion concentration 100 6 (mg/L) Atomic weight Ca 40 Mg = 24 15 Na || 23 250 H= 1, C 16 12, 45 S = 32, O =16 39 CI= 35.5 Carbonate hardness (mg/L as CaCO3) present in the above water sample is