A mixed liquor sample form an activated sludge plant was settled in a one-litre measuring cylinder for 30 minutes after which time, a volume of 350 m/ of sludge was recorded. When 50 m/ of the mixed liquor were filtered through a GFC paper for the determination of MLSS the gain in weight of the paper was 0.1375 g. Determine the SVI.

A mixed liquor sample form an activated sludge plant was settled in a one-litre measuring cylinder for 30 minutes after which time, a volume of 350 m/ of sludge was recorded. When 50 m/ of the mixed liquor were filtered through a GFC paper for the determination of MLSS the gain in weight of the paper was 0.1375 g. Determine the SVI.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The test Carried aut en an follow. detaits sludge Somple are Weight of Dish =9.52gm Baw Sludge Sempla and duch =23 27ga Aşter Drying Clnstent) After Burning Clnstant) = 6.38gm 9.46gm %3D %3D Calculkt th percentage of total Salidl ad lloldi Solid in t cboue of cowego.
An anaerobic digester is operated with a hydraulic retention time (HRT) of 25 d and a flow rate of 0.85 m³/d. The influent substrate concentration is 18 g/L and the digestion process is assumed to follow first order kinetics with a Ko value of 0.09 d'¹. Calculate: (a) the liquid volume of the anaerobic digester, V (m³) (b) the effluent substrate concentration, So (g/L)
In an activated sludge treatment unit with tank volume of 700 m³, the imfluent BOD of the sludge at 4000 m³/day of discharge is 250 mg/lt which reduced to 30 mg/lt in the effluent sludge. The MLVSS concentration in the aeration tank is 3000 mg/lt. The F/M ratio is kg/kg/day.
I want the solution in less than 15 minutes
4. I 1 I (mm/hr) = at + 12 where it is accumlated in filtration time (min) use the below Data to estimate Dein fretration rate. after (one) hour. N'ary wiI) (t) min lime (D) Accumlation infiltratim : depth (mm) 30 Yo 150 80 - talles
1
The following data on the substrate removal rate and the substrate concentration is available for wastewater treatment (S) mol Rate, r (mol/min) 0.04 0.57 0.06 1.05 0.8 2.32 0.10 3.00 0.12 4.68 0.14 5.42 2.0 5.78 Estimate the value of substrate removal constant Km and the value of Vmax
Plz write neat
3. A 100 mL of wastewater sample was drying on a 0.5 g empty dish weight at 104 °C to weight 0.5625 g. Another 100 mL of the same wastewater was first filtered and the filtrate was dried on a 0.5 g dish at 104 °C to weight 0.5325 g. Determine in mg/L the:a) TSb) TSSc) TDSd) VSS assuming it represents 70% of TSS
1. The following information is provided for an activated sludge system design: Parameter Symbol Value Units Flow rate Q 10000 m³/d Influent BOD So 150 mg/L Effluent BOD S 2 mg/L Hydraulic residence time Ꮎ 4 hr Mean cell residence time Oc 6 d Maximum specific growth rate μm 3 1/d Half saturation constant Ks 40 mg/L Yield coefficient Y 0.5 Endogenous decay coefficient b 0.08 1/d Death rate coefficient γ 0.04 1/d Determine: a) The aeration tank biomass concentration (X) in mg/L b) The aeration tank oxygen requirement in kg/d c) The rate of biomass wasting in kg/d
Ex.3. Estimate the value of minimum particles diameter for (7m long) (1.2m height) settler chamber with gas velocity of (30 cm/sec).The air temperature is (26.6°c) and particles density is (2.5 gm/cm³) with dynamic viscosity of (1.9x 10-5Pa.sec).(for minimum particles diameter the efficiency is 100%).
Question 8A 200 g/l solution of common salt was discharged into a stream at a constant rate of 25l/s. The background concentration of the salt in the stream water was found to be 10 ppm. At a downstream section where the solution was believed to have been completely mixed, the salt concentration was found to reach an equilibrium value of 45 ppm. Estimate the discharge in the stream.