Question 8 A 200 g/l solution of common salt was discharged into a stream at a constant rate of 25l/s. The  background concentration of the salt in the stream water was found to be 10 ppm. At a downstream  section where the solution was believed to have been completely mixed, the salt concentration was  found to reach an equilibrium value of 45 ppm. Estimate the discharge in the stream.

Q: Dissolved chloride in a concentration of 500 mg/L is being advected with flowing groundwater at a…

A:

Q: After three days, the BOD concentration in a water sample was determined to be 75 mg/lt with a…

A: BOD after 3 days,L3 = 75 mg/lt Reaction rate constant, k = 0.345per day

Q: 2. Please design a Type II settling tank that receives a 1000 m3/day of a waste stream, after…

A:

Q: Neglect the weight of the drum in the following problem. A sealed cylindrical drum has a diameter of…

A: The volume, mass and density is corelated with one another,  V=MD here, volume is V, mass is M and…

Q: Assume the described is at steady state. A fluid goes up to an aquifer that has groundwater and a…

A: Volume of groundwater reservoir, Outflow, Chloride Concentration of fluid, Chloride outflow,

Q: A creek is flowing at an average rate of 0.4 m^3/s. A corporation is importing 30% of the creek…

A:

Q: A container of Atrazine (500 g) is dumped into a river 2.3 km upstream of a municipal water intake…

A: Given, M = 500 gm or 0.5 kg L = 2.3 km or 2300 m  A = 5.7 m2  Q = 8.25 m3/s D = 0.1 m2/s

Q: A meat processing factory's raw effluent has a five day BOD at 20°C of 1760 mg/l. If the k value is…

A: Part a.

Q: A storm sewer is mixed into a small streams. the stream before the mixing point has a NaCl…

A:

Q: The Rappahannock River near Warrenton, VA, has a flow rate of 2.9 m³/s. Tin Pot Run (a pristine…

A:

Q: : A tracer a plastic mec recorded as

A: To find the coefficients C and n in the empirical equation for the time to peak tracer concentration…

Q: There is sedimentation tank that is used to remove suspended solid particles from an incoming…

A: Given Discharge= 150m3/hr surface area= 15m2

Q: The BODs of a domestic wastewater sample is considered to be about 200 mg/l and the DO in it is…

A:

Q: 2. Please design a Type II settling tank that receives a 1000 m3/day of a waste stream, after…

A: Flow of water per day = 1000m3/day =1000/24m3/hour, Let the detention period be 2hrs(assumed based…

Q: Q3. according to the data of water depths in figure below that collected in the cans test find: - 1-…

A: By deducting the minimum water level from the highest water depth and dividing the result by the…

Q: Salt lake has no outlet i.e., the inlet flow is completely balanced by evaporation. Lake has a…

A: Lake has a volume of 2.5 x 1011 m3 and the concentration of salt in the lake is 52 g/L. The inlet…

Q: in the carrying 2,000 mg/L of salts. The salts quickly become uniformly distrib river. A…

A:

Temperature related material properties

Temperature-related properties of materials are the properties that change or show any variation with temperature variations. Various properties of materials include physical properties, mechanical properties, chemical properties, electrical properties, magnetic properties, etc. The chemical, electrical, and magnetic properties of materials are important, but the physical and mechanical properties are more important. Based on their composition and chemical bonding, materials are classified as metals, ceramics, polymers, and composites.