In the Creep test for a particular model, the following information was obtained: 1. The initial crawl 0.055 2. The initial crawl time .hr 400 3 The rate of crawl increase at time .hr 350 is .1.7x10/hr and average crawl oil at time .hr 600 Decreased by 1.27 x 10 / hr from the crawl rate at a time of 350 5. Life of the model 5100 .hr Needed to find the total crawl rate when the model fails

Q: 4. Which of the following gives the plastic limit of the soil? a. 16.5 % C. 17.1 % b. 10.5 % d. 18.5…

A: First, we have to calculate the water content of the following sample then we have taken the average…

Q: assume all structures are composed of frame elements (beams and columns), i.e. internal shear,…

A: Data given Find: nse, nsi and ns

Q: If the acceptable roughness parameter variability is 20% (i.e., the coefficient of variation COV =…

A:

Q: If the primary consolidation settlement of a clay layer is calculated to be 396 mm, what is the…

A: ASKED: To compute the settlement for the given time factor.   Given, Primary consolidation…

Q: Some measurements on a blood sample at 37 °C (98.6 °F) indicate a shearing stress of 0.550 N/m² for…

A: Please refer the attached solution, thanks

Q: Q7. Discuss the difference between net normal stress and matric suction in terms of (1) expression…

A: A metric suction is defined as the difference between pore air pressure ua and pore water pressure…

Q: assume all structures are composed of frame elements (beams and co bending, and axial force may be…

A:

Q: of failure envelope ar ers through failure enve

A:

Q: It is assumed that the fundamental period of reinforced concrete frame structure is located between…

A:

Q: Direct shear test were performed on a dry, sandy soil. The size of the specimen was 50.55 mm x 50.55…

A:

Q: Question 4 Identify the borehole technique that advances drilling into rock formation Hollow stem…

A: Rotary wash technique is similar to rotary drilling method is best suitable for drilling operations…

Q: In L.L. test a minimum of three trials with values of N ~ .... are required 10 to…

A: The Liquid Limit (LL) test is a laboratory test that is performed to determine the liquid limit of a…

Q: assume all are composed élements (beams and columns), internal shear, bending, and axial force may…

A:

Q: Q1: Find out the point load strength index (Is(50)) for both of the Diametral test and Axial test…

A: Data from the Point load test for both diametral test and axial test

Time and time related variables in engineering

Time is the event progression starting from past to present and then, future statistically. The time-related variable is any particular value in relation to time to assess its changes on a specified (XY) plane.