In a lathe machine tool, when the cutting tool moves perpendicular to the axis of rotation of the workpiece a flat surface is produced. Select one: True False

Q: Problem 6 You've been asked to design a stamping tool as shown. What are the internal forces at A…

A: FBD

Q: Name the milling machine operation in which the milling cutter axis is perpendicular to the flat…

A: Answer is Face milling

Q: It is only required to move the cutting tool from the circumference to the center of the workpiece…

A: Introduction A milling machine is a machine that removes material from a workpiece by feeding it…

Q: Which set of ordered processes best describes the steps to perform an emergency stop and reset of…

A: A lathe machine is used for the turning, facing, drilling, and surface finishing processes of…

Q: The positive and negative directions for the X and Y-axes on the mill are determined by the…

A: The mill axis which moves left and right is the x-axis for both vertical and horizontal spindle…

Q: Sally is making a sine bar, which is used to machine angles on parts (see the given figure). She has…

A:

Q: The feature of saw blade geometry that allows the blade to cut a kerf that is wider than the blade…

A: A feature is responsible when a blade cut a kerf which is wider than the blade itself.

Q: Facing is an operation to reduce the diameter of work piece. Select one: True False

A: False

Q: Lathe Machine tool is an example of two axes machines Select one: True False

A: Solution:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.