For this siphon the elevations at A, B, C, and D are: 30 m, 32 m, 27 m, and 26 m, respectively. The head loss between the inlet and point B is three-quarters of the velocity head, and the head loss in the pipe itself between point B and the end of the pipe is one-quarter of the velocity head. For these conditions, what is the discharge and what is the pressure at point B? The pipe diameter 25 cm.

Q: the siphon shown in the  figure, calculate (a) The mass flow rate of oil from the tank and (b) The…

A: To determine the mass flow rate and pressure at point D.

Q: Develop the expression for lost head in a horizontal pipe for turbulent incompressible flow.

A:

Q: A 50-mm diameter siphon is drawing oil (S.G. = 0.82) from an oil reservoir as shown. If the head…

A:

Q: Water flows at a rate of 0.030 m³/s in a 0.16-m-diameter pipe that contains a sudden contraction to…

A: Flow rate of Flow Q = 0.030 m3/s Diameter of pipe at entrance d1= 0.16 m Diamete of pipe at…

Q: Q2/ A pump delivers water from a tank A (water surface elevation = 110 m) to tank B (water surface…

A: Data given-

Q: (a) Does the total head increase or decrease as it flows over the body? (b) What is the decrease in…

A: “Since you have posted a question with multiple sub-parts, we will provide the solution only to the…

Q: 1. Water (p = 1000- kg H = 10-3 flows in a horizontal constant-area pipe; the pipe cross ms section…

A:

Q: Water flows through a venturi as shown in the figure at a flow rate of Q= 12 L/s. The inlet and…

A: Given: Flow rate, Q=12 L/s Inlet diameter of venturimeter, D=4 cm Throat diameter of venturimeter,…

Q: A venturi meter is introduced in a 300 mm diameter horizontal pipeline carrying a liquid under a…

A:

Q: Water from a reservoir is pumped over a hill through a 450 mm diameter and an absolute pressure of…

A: Note: As per our guidelines we are supposed to answer only the first 3 sub-parts. Kindly repost…

Q: t the gasoline transfer facility (ρᵣₑₗ=0,75) from the pond of  storage to consumption, you want to…

A: The power required to operate a pump between 2 points in the system can be obtained by using the…

Q: 3- What is the head loss in the venturi (between O 0.10 m O 0.16 m O 0.12 m O 0.14 m O 0.18 m O None…

A: GivenQ=6×10-3 m3/sD=3cmd=2.5cmL1=65cmL3=53cmρ=1000kg/m3g=9.81m/s2μ=0.001Ns/m2

Q: An oil of S.G of 0.8 is flowing in a stream tube as shown in

A:

Q: Q2/ A fluid containing (water, oil, sand) flowing through the tube and open to the atmosphere as…

A: Start from Pa  going downward is adding pressure and going upward is subtracting pressure.

Q: Water (at 20C) flows through a pipeline connected in series, as shown in the Figure. The…

A: Bernoulli's theorem Bernoulli's theorem says that total energy at inlet is equal to total energy at…

Q: A vertical pipe of 1 m diameter and 20 m length has a  pressure head of 5 m of oil at the upper end.…

A:

Q: A venturi meter is introduced in a 300 mm diameter horizontal pipeline carrying a liquid under a…

A: Given data: D=300 mmd=100 mmP=150 kPaHead loss=3% of differential pressure headhloss=-400 mm Need to…

Q: A liquid of specific weight 9,101 N/m3 flows by gravity through a 30.5 cm tank and 30.5 cm long…

A:

Q: A vertical pipe in the form of a cone has a diameter of 45 cm at the top and 92 cm at the bottom and…

A:

Q: 4. A pipe has an initial radius of 30cm, which then changes to a radius of 10cm. The velocity of the…

A: Please refer to the detailed solution given below, Answers - (a) Pressure difference P1 - P2 =…

Q: Air flows steadily between two sections in a long straight portion of 0.2 m inside diameter pipe as…

A:

Q: 2) V2 = 0 water tank B Z2 - Z1 (1) Z1 D water tank A pump valve 72

A:

Q: In a horizontal pipe water flows at a rate of 9.1 L/s. Here, the pipe has two sections, one with a…

A:

Q: The water temperature in the tank is 60 °C and the pump has the capacity of 20 ton/hour. Pump is 2m…

A:

Q: 1- A 2 m long conical tube is fixed vertically with its smaller end upwards. It carries liquid in…

A:

Q: Water flows steadily into the Venturi tube in the following figure. In the section considered,…

A: Given data: -  The entrance area is A1 = 20 cm2. The throat area is A2 = 10 cm2. The weight density…

Q: Determine the downstream pressure P2, and estimate the error that would have occurred if Bernoulli's…

A:

Q: A vertical pipe of 1 m diameter and 14 m length has a  pressure head of 5 m of oil at the upper end.…

A:

Q: If the pressure head, velocity head and the potential head at a point in a fluid flow inside a…

A:

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.