Q3: The 6-cm-diameter pipe as shown in Figure H.I contains glycerin (p = 1260 %3D kg/m', u= 1.49 kg/m s) flowing at a rate of 6 m'/h. Verify that the flow is laminar. For the pressure measurements shown, is the flow up or down? What is the indicated head loss for these pressures? Answer: Head loss 25 m 3.7 atm B 2.1 atm 12 m Figure: H.1

Q: c) When the fluid is heated to 90°C, the density drops slightly and the viscosity decreases a lot,…

A: Given Data: Water flows past a flat plate  Plate Length L=5 m Plate Width w=2 m shear stress at the…

Q: Q3:- A liquid whose coefficient of viscosity is µ flows below the critical velocity for laminar flow…

A: The loss of pressure in a length of 120 m is 11520 N/m2.

Q: The 50-mm-diameter horizontal pipe shown in (Elgure 1) is used to transport kerosene at 20°C. The…

A: To determine:a) The Reynolds number for the flowb) To check if the flow is laminar or…

Q: U - tube is used to pressure the difference in water channel. p1= 1000 kg/m3. The orange fluid in…

A: Water density = 1000 kg/m3 Orange fluid = 2000 kg/m3 Pressure at point 1 = 111 kpa a = 10 cm h = 15…

Q: A 1/4” inside diameter pipe is used to transport SAE 30 motor oil (µ = 0.006266 slug/ft-s and ρ =…

A:

Q: What is the volume flow rate for water (viscosity= .0010 Pa×s) through a length of pipe L= 0.60m and…

A:

Q: Q-3, B.: A Pitot static probe is mounted in a 25 em inner diameter pipe at a location where the…

A: Step 1: To calculate the volume flow rate through the pipe using the Pitot static probe…

Q: Pressure loss along a pipe pumping water is 6.6Pa. If the pipe is 2.1m long, what angle (in degrees)…

A: To overcome the pressure drop along the pipe, we need to consider the effect of gravity on the water…

Q: 3m/s 100 mm 非 100 mm

A: To find the x and y component of the force in the cross section of the pipegiven diameter at the…

Q: 1. Fuel flows through a pipe from a pressurized vessel to an open tank at a rate of 2.3 m³ /min (see…

A:

Q: A horizontal pipe carries cooling water at 10°C for a thermal power plant. what is the pressure in…

A: Given data: The average velocity in the pipe can be determined as,

Q: Q3: The 6-cm-diameter pipe as shown in Figure H.1 contains glycerin (p = 1260 kg/m', u = 1.49…

A:

Q: Use Bernoulli's energy balance equation (E = PV + 0.5*mU2), assume volume flow rate remains constant…

A:

Properties of Fluids

The term fluid represents a type of substance that can easily change its shape under any external pressure/force and can flow. Fluids can acquire any shape in which it is stored and can resist normal stresses but cannot resist shear stress in rest condition. Whenever external shear stress is applied to fluids, it starts to flow. The fluids may be liquid or gas. Example- water, air, etc.