Water flows through a venturi meter whose inlet diameter is 31 cm and throat diameter is 19 cm. The pressure at the inlet is 755kPa and at the throat 550 kPa. Determine the discharge in cumecs. Neglect head loss.

Q: A manufacturer states that their gear pump requires 0.85 hp to pump 9 gpm of oil (sg=0.90) with a…

A: The flow rate of the oil is, Q=9 gpm. The specific gravity of the oil is, SGo=0.90. The total heat…

Q: The total discharge in the system below is 15.5 cfs and the head loss from B to C is 24 ft. Using n…

A: Note: As per policy, we can solve the first three subparts. Please resubmit the remaining parts.…

Q: A 2-inch copper pipe connection was made from the basement to the second floor in the building. The…

A:

Q: Q2: The maximum flow velocity of water in a pipe is 2.4 m/s. The pipe has 0.2 cm diameter , and 15 m…

A: In this question, determine the pressure drop of the head loss.  As we know the nature of flow is…

Q: n orifice of 10 cm diameter is fitted in a 25 cm diameter pipe that carries oil of specific gravity…

A:

Q: Find the loss of head whena pipe of diameter 200nm is suddenly enlarged to a diameter of 400mm. The…

A: Continuity equation is based on the conservation of mass. If a pipe having area at one section is…

Q: 3. Determine the flow rate of water, in m3/s, at 5 C though the piping system as shown in the…

A:

Q: Write what you now about Bernoulli's equation and why it is very important in our life

A: This question is based on the concept of Bernoulli's equation.As per the guidelines of Bartleby, we…

Q: A tank 1.5 m stands on a trolly and is full of water. It has an orifice of diameter 0.1 m at 0.3m…

A: Given:h=1.5 md=0.1 mCd=0.6

Q: water flows through a horizontal venturyi meter whose inlet diameter is 33 cm. and throat diameter…

A:

Q: A fluid flows at 455 m3 per min inside a rectangular duct, whose cross-section has a length of 150…

A: Given data: Q=455 m3/min=7.5833 m3/secL=150 mw=85 cm Need to determine the average velocity of the…

Q: Water flows through a horizontal Venturi meter whose inlet diameter is 33 cm. and throat diameter is…

A: Given data: d1=33 cmd2=21 cmP1=770 kPaP2=585 kPa Need to determine the discharge.

Q: A petroleum liquid with (SG = 0.89), flows through the Venturi meter as shown with flowrates between…

A:

Q: Water flows from a pressurized tank (@ 300 kPa) to an open tank 5 meters above. What is the…

A: Ptank = 300 kPa = 300000 Pa Patm = 101.325 kPa = 101325 Pa Density  = 1000 kg/m3 g = 9.81 m/s2 Find…

Q: Q2/ Water is flowing through the system. If P1 = 0.18 MPa gage, and mass flowrate is 15 kg/s.…

A: The velocity of flow at section 2 can be determined as, The velocity at section 1 can be determined…

Q: An orifice meter with a 5 cm diameter is used to measure the flow rate of liquid. Under a head of 4…

A:

Q: There is a storage tank with a height of 5 m. Initially the tank is empty. The cross- sectional area…

A: Write the given data. Qin=1 m3/sQout=0.2 m3/sq=h

Q: Water flows in a new 10cm diameter cast iron pipe with f=0.027 at a velocity of 1m/s. For each pipe…

A:

Q: A centrifugal pump is used to pump water through horizontal distance of 150 meters and then raised…

A: Length of the pipe, L=150 mElevation difference, ∆z=20 mInside diameter, d=50 mm =0.050 mFlow rate,…

Q: A 30 cm x 15 cm venturimeter is inserted in a vertical pipe carrying water, flowing in the upward…

A: Few points regarding venturimeter. A venturimeter is a device which is used for the measurement of…

Q: QI: A closed tank partially filled with water up to a height of 0.9 m having an orifice of diameter…

A:

Q: The flow rate of the water flowing through the venturi, which has a wide section of 4.91x10^-4 m, is…

A:

Q: B4. An orifice meter with orifice area 848 mm2 is inserted in a pipe of area 1696 mm2 .The pressure…

A: Given fluid in pipe is oil with specific gravity of 0.75 and not water .Hence there is correction in…

Q: An oil of specific gravity 0.77, is flowing through a venturimeter having inlet diameter 20 cm and…

A: Given Data: The specific gravity of oil, 0.77 Inlet diameter, d1=20 cm Throat diameter, d2=10 cm

Q: A 15-ft-diameter tank discharges water at 50 F through a 2-in.-diameter sharp edged orifice. If the…

A:

Q: The variation of pump head, efficiency, and required ENPY parameters with flow rate obtained from…

A:

Q: Water flows through a venturi as shown in the figure at a flow rate of Q= 12 L/s. The inlet and…

A: Given: The flow rate is 12 L/s. The height of water column are: L1=74.6 cmL3=50 cm

Q: Water is flowing through a pipe of 100 mm diameter under a pressure of 19.62 N/cm2 (gage) and with…

A: Given: d= 100 mmp=19.62 N/cm2v=3 m/sz=8 m

Q: The water is flowing through a pipe having diameters 40 cm and 17 cm at sections land 2…

A:

Q: Water flows through a 15m pipe with 1.3 cm diameter at 20 l/min. Determine the length of entrance…

A:

Q: In a horizontal pipe water flows at a rate of 9.1 L/s. Here, the pipe has two sections, one with a…

A:

Q: A ventury meter used to measure the liquid from the reservoir. The cross-sectional area at the inlet…

A: Given:A1=4.536*10-3 m2A2=1.134*103 m2Q=9167 cm3/sx=266 mms=13.6

Q: Water flows through a horizontal verturi meter whose inlet diameter is 31 cm and throat diameter is…

A:

Q: В4. An orifice meter with orifice area 1039 mm2 is inserted in a pipe of area 2078 mm2 .The pressure…

A:

Q: e working unde

A: given:Power P=640kwHead H=16m

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.