Figure P4.3-5 10 m(t) -10-3. -10 4.3-6 (a) Sketch the time domain AM signal corresponding to the AM modulation in Prob. 4.3-5. (b) If this modulated signal is applied at the input of an envelope detector, show the output of the envelope detector is not m(t). (c) Show that, if an AM signal Ac[A + m(t)] cos wet is envelope-detected, the output is Ac|A+m(t)|.

Figure P4.3-5 10 m(t) -10-3. -10 4.3-6 (a) Sketch the time domain AM signal corresponding to the AM modulation in Prob. 4.3-5. (b) If this modulated signal is applied at the input of an envelope detector, show the output of the envelope detector is not m(t). (c) Show that, if an AM signal Ac[A + m(t)] cos wet is envelope-detected, the output is Ac|A+m(t)|.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Depanment of Electronics Engineering IX. A carrier signal is amplitude modulated by a sinewave. The resulting AM waveform Is shown below. zed 6V 2.5V a) What is the percentage of modulation? b) What is the amplitude of the carrier signal? c) To achieve 75 percent modulation, what amplitude of the modulating signal is needed? d) Calculate the effective voltage of the AM signal SSA AILE Q + Page 4 I 5 X. The frequency spectrum of an AM signal is shown betow: (9 pts)
For an FM signal, the maximum frequency of the modulating signal is 100 kHz and the frequency deviation is 10 kHz. Find out the bandwidth of the FM modulated waveform.
A bandlimited signal of max frequency 5 kHz is sampled. What will be the valuenof the Nyquist's sampling frequency?
UPVOTE WILL BE GIVEN. PELASE WRITE THE SOLUTIONS LEGIBLY. NO LONG EXPLANATION NEEDED. SOLVE IN 4 DECIMAL PLACES. BOX THE FINAL ANSWERS ANSWER LETTER D ONLY.
An electronic game uses an array of seven LEDS (light-emitting diodes) to display the results of a random roll of a die. A decoder is to be designed to illuminate the appropriate diodes for the display of each of the six die values. The desired display patterns are shown in Figure P6.19. c. Use a 3-to-8-line decoder and OR gates to map the 3-bit combinations on inputs X2, X1, and Xo for values 1 through 6 to the outputs a through g. Input combinations 000 and 111 are don't-cares.
7. In DC analysis all capacitors are replaced by a short circuit equivalent and in AC as an open circuit. Select one:TrueFalse 8. En el análisis AC del BJT todas las fuentes de cd se hacen igual a cero y las reemplaza una conexión de cortocircuito a tierra. Seleccione una: Verdadero Falso 9. The superposition theorem is applicable to the analysis and design of the dc and ac components of a BJT network, allowing the analysis of the system's dc and ac responses to be separated. Select one:TrueFalse 10. An equivalent model is a combination of appropriately selected circuit elements that accurately simulates the real behavior of a semiconductor device in any operating condition. Select one:TrueFalse
None