Optical Sensor Lab; using Multisim, design a system using the photoconductive cell shown in the figure below to measure and display light intensity. Make the design such that 20 to 100mW/cm2 produces an output of 0.2 to 1.0V. What is the readout error when the intensity is 60mW/cm2? Show all calculations and circuit design in Multisim. Implement it with an inverting amp w/a sensor in the feedback, a 2.4kΩ on the input and a fixed -0.8 volt source (from a divider) on the input. This is followed by a summing amp with a constant -1.1667V on one input and the output of the first amp on the other input. Resistance (£)1310-Cell30.Intensity (mW/cm³)

Answered: Image /qna-images/answer/917434ff-5cd0-444c-881e-9be801bcb4cc.jpg

Answered: Resistance (£) 13 10- Cell 30.…

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Question

Optical Sensor Lab; using Multisim, design a system using the photoconductive cell shown in the figure below to measure and display light intensity. Make the design such that 20 to 100mW/cm² produces an output of 0.2 to 1.0V. What is the readout error when the intensity is 60mW/cm²? Show all calculations and circuit design in Multisim.

Implement it with an inverting amp w/a sensor in the feedback, a 2.4kΩ on the input and a fixed -0.8 volt source (from a divider) on the input. This is followed by a summing amp with a constant -1.1667V on one input and the output of the first amp on the other input.