Exercises4.13. The following data were obtained when a 25-kVA, 2300/460-V, 50-Hztransformer was tested:Voltage (V)Current (A)Power (W)Open-circuit test:Short-circuit test:4601.48460108.710.87709Determine the approximate equivalent circuit as viewed from (a) the high-voltage side and (b) the low-voltage side. Also draw the exact equivalentcircuit.A 25-kVA, 4000/400-V, 60-Hz transformer has the following parameters:18 N, X,4.14.250 m2, ReH15 kn, and= 180 mn, X225 kN. If the open-circuit and short-circuit tests are performed on25 N, R2%3DR1XmHthis transformer, what are the readings of the instruments in each case?From the data given in Exercise 4.14, determine the rating of the trans-former at maximum efficiency. What is the maximum efficiency of thetransformer at unity power factor? What is the efficiency at full load andunity power factor?%3D%3D%3D4.15.

Answered: Image /qna-images/answer/545d49b7-d427-4dd9-9969-9ce01d93df9c.jpg

Exercises 4.13. The following data were obtained when a 25-kVA, 2300/460-V, 50-Hz transformer was tested: Voltage (V) Current (A) Power (W) Open-circuit test: Short-circuit test: 460 1.48 460 108.7 10.87 709 Determine the approximate equivalent circuit as viewed from (a) the high- voltage side and (b) the low-voltage side. Also draw the exact equivalent circuit. ers:

Exercises 4.13. The following data were obtained when a 25-kVA, 2300/460-V, 50-Hz transformer was tested: Voltage (V) Current (A) Power (W) Open-circuit test: Short-circuit test: 460 1.48 460 108.7 10.87 709 Determine the approximate equivalent circuit as viewed from (a) the high- voltage side and (b) the low-voltage side. Also draw the exact equivalent circuit. ers:

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Sen 2.5 2.5 A 16,25 kVA, 220/440 V, 60 Hz transformer gave the following test results. Open circuit test (440 V side open): 220 V, 9.5 A, 650 W Short-circuit test (220 V side shorted): 37.5 V, 55 A, 950 W (a) Derive the approximate equivalent circuit in per-unit values. (b) Determine the voltage regulation at full load, 0.8 PF lagging. (c) Draw the phasor diagram for condition (b).
- A Transformer has primary windings as Np = 750 and secondary windings as Ns = 125. Its secondary voltage is Vs = 36V and output power of the transformer is PN= 3200W. The value of loses powers are Pcu = 43W and Pfe = 29 W. The resistance of loads are RLI = 1,250 and R12 = 0,88Q. (Pcu and PFE will be considered to be approximately the same in different load values.) Determine the following values in the circuit: Primary winding N, turns Secondary winding Ng turns Primary current Magnetic Flux, Secondary IsL s current ISL1 'Isl2 Primary voltage Secondary voltage RL1 R12 Transformer Core (a) the primary voltage Vr, (b) the secondary load currents ISLı and Isl2 if the transformer is rated at RLI and R12, (c) the resulting secondary power PSL, (d) the resulting primary power PPl, (e) the primary load current IPL, (f) efficiency nL
Q2/A/ What are the conditions for satisfying parallel operation of single phase transformer? Deduce an expression for the load shared by the two transformers in parallel when the transformers have equal voltage ratio? Prove your answer. B/ A 50 KVA, 2300/230 V, 60 11z transformer has a high voltage winding resistance of 0.650 and a low-voltage winding resistance of 0.0065 2. Laboratory tests showed the following results: Open circuit test: V = = 230 V, I =5.7A, P = 190 W Short circuit test: V-41.5 V, I-21.7 A, P-No wattmeter was used. 18 (2) Compute the value of primary voltage needed to give rated secondary voltage when the transformer is connected as a step-up one and is delivering 50 KVA at a power factor of 0.8 lagging. (b) Compute the efficiency under conditions of part (a).
b) A lkQ resistance is connected across the secondary winding of a 200V/400V transformer with the following equivalent circuit parameters, Kleq=502, Rc = 10k2, XM =1 k2 , ^leq = 100 2. Determine the following: R i. The Open Circuit Output Voltage (Vsoc) ii. The Output Voltage under load (Vs) i1i. The Output Current (Is) iv. The Transformer Efficiency (%)
4. 100 kVA, 6800-240 V, 50 Hz single phase step down transformer has the following parameters: RLs=0.0082 RHs=2.62 Rfe-HS=50002 XLs=0.015N XHs=5.2N Xm.Hs=88002 Transformer is delivering 80% of rated load at rated voltage and 0.95 lagging power factor. Determine the following: a) The equivalent impedance of the transformer referred to primary. b) Input impedance of the combined transformer and load. c) Actual input voltage at HV side. d) Input impedance if load is disconnected. e) Exciting current at no load.
A 36/240 V phase transformer, belonging to a phase measured from the no-load (idle) run and short-circuit test. values are given in the table below. High voltage by applying rated voltage to the low voltage winding (The winding ends were left unloaded and the results of the no-load test results were obtained. By applying nominal current to the high voltage windings, the low voltage windings were short-circuited, and the results of the short circuit test were obtained. In direct current test 1 V direct voltage is applied to the low voltage winding, and the transformer draws 500 A direct current. All equivalent Calculate the circuit elements as moved to the low voltage side. Idle run test: Voltage : 36V Power : 68W Current : 2,8A Short circuit test: Voltage : 15V Power : 325W Current : 42,2A
Following are the results of a test carried out on a 230/600 V single phase, 7.5 kVA transformer. O.C. Test : 230 V, 1.2 A, 280 W, on L.V side S.C. Test : LV winding is shorted. 26 V, 11A, 155 W, H.V. Both the full load efficiency and full load regulation of the transformer on the side are 0.8 lagging p.f Search on.
A short-circuit test has been carried out with a three-phase transformer of 30/6.5 kV. By experiment, the high-voltage side was short-circuited and it was read: Ik=30A, Uk=234V and Pk=5.24kW a) Find the nominal voltage drop in % for this transformer where a was measured power factor of 0.8 ind.Under a certain load of the transformer, we measure a voltage drop of 5%, when the primary side is at 30kV. b) Find the secondary clamping voltage at this particular load
1. A 1000-VA 350/140-V transformer has been tested to determine its equivalent circuit. The results of the tests are shown below. Open-circuit test Short-circuit test Voc = 235 V Vsc = 20.1 V loc = 0.57 A Isc = 9.6 A Poc = 34.3 w Psc = 42.7 W All data given were taken from the primary side of the transformer. Evaluate the equivalent circuit of this transformer referred to the low-voltage side of the transformer.
Q1: During the separation of transformer core losses experiment: 1. Why should always keep the ratio of V/F constant? 2. If the transformer is operated at rated frequency but at voltage lower than rated value, how do you expect the following quantities to change? And why? i. Hysteresis loss ii. Eddy current loss iii. No-load current
A 25 kVA, 2 kV(rms)/100 V(rms) single phase transformer is connected between a 120 V(rms) utility supply and a resistive load. The load current was measured to be 20 A(rms). i. Determine the active power of the load. ii. Determine the primary RMS current. iii. Determine the equivalent resistance of the transformer as seen by the utility supply.