Diameter= 6 in Diameter = 3in

Q: AcylinuTIcal laiiK Tlavilng a uldilitit UI ZII and height of 4m is open at one end and closed at the…

A: γw=9.81 KN/m3

Q: Problem 3. A 30 cm pipe is connected by a reducer to a 10 cm pipe. Points 1 and 2 are at the same…

A:

Q: Determine the difference in elevation between the lower tank and the upper tank.

A:

Q: El. 200 mA A Res. H-W Pipe B Pipe E pipec → Negleet minor losses → Pipes B, C, and E are all have: L…

A: Vc = 5m/s

Q: A glass of water is filled to a height of 0.5 ft. Find the hydrostatic pressure at the bottom of the…

A: Hello dear this is the solution of your problem The answer is found to be Pressure at the bottom of…

Q: A U-tube contains a liquid of relative density 1.25 to a height of 25 cm in both the columns. It is…

A:

Q: ) A nozzle, which reduces from 45mm to 30mm in diameter, discharges water at a rate of 30 L/s. If…

A:

Q: Q-39: Two reservoirs have a difference of head of 6 m and are connected by a pipe line which…

A: We know that,

Q: Water is pumped from a supply reservoir to a ductile iron water transmission line. The high point of…

A:

Q: 2. The suction pipe of a pump rises at a slope of 3 vertical in 4 along the pipe which is 12 cm in…

A: To find Maximum discharge that the pump may deliver?

Q: The triangular valve (AB) which weighs 1500 Newtons closed at point A and is free at point B. What…

A: Length of the gate t=2sin50o=2.6108 m Depth of center of gravity from surface of water…

Q: Part B: Water at 20 °C steadily flows through the reducing section at 70 kg/s. We know the following…

A:

Q: The piston at A has a cross-sectional area of 600 sq. cm while that B is 100 sq. cm. The difference…

A:

Q: Two pressurized prismatic tanks B and P are connected at their sides by an orifice having 100 mm…

A:

Q: produces a contraction from approximately The hose 10 cm to 5 cm and exit velocity, 10 cm A, U U1,…

A: Given:- The initial diameter of the hose = 10 cm  The final diameter of the hose after contraction =…

Q: 1) Determine the flow in Ips on the orifice between the 2 tanks shown below AIR 25kPa AIR 10kPa OIL…

A:

Q: he diameter of a pipe changes gradually from 6 inches at A to 18 inches at B. A is 15 ft lower than…

A:

Q: A pressure gage at elevation of 12m at the side of the tank containing liquid reads 100 kPa. Another…

A:

Q: A pump draws water from reservoir A and lifts it to reservoir B as showm, The head los from…

A: Discharge, Head loss from A to pipe 1, Head loss from pipe 2 to B, To find:            (a)Horse…

Q: s required to deliver discharge Q = 0.04 m'/s against a total head H, =VEN m using a eller inner to…

A: Calculate the value of ϕ ϕ=e-5.25NSM+0.88ϕ=e-5.2520×62+0.88ϕ=7.386 Calculate the value of ψ…

Q: A pump draws water from a reservoir A and lifts it to reservoir B as shown. The loss of head from A…

A: Given data,  Discharge = 447 GPM Loss of head at A  is 5 times of velocity head of 12 in pipe.  Loss…

Q: Gasoline flows steadily downward through the pipe shown in the figure below. Viscous effects are…

A: Given data  Pressure at 1 (P1) = 0  Datum head of 1 (Z1) = 3.1 ft  Datum head of 2 (Z2) = 5.2 ft…

Q: Water is pumped from a supply reservoir to a ductile ron water transmission line. The high point of…

A: Given ;

Q: Oil with sp. gr. of 0.87 is being pumped from a lower reservoir to an elevated tank as shown. The…

A: Apply Bernoullis theorem…

Q: height of the pressure intensity : (f) at the interface of the two liquids, and (i) at the bottom of…

A: As per guidelines please post rest questions separately

Q: السؤال الخامس A pipe of diameter 16.6 in convey 4000 gpm oil,(viscosity = 0.0001 ft/sec, specific…

A:

Q: In a pump the suction and delivery pipes are of the same size and are at the same level. At a given…

A:

Q: 3. A pump is used to transport water at the rate of 0.075 m³/s from a reservoir 20 m above the pump…

A:

Q: Water fills the pipe AB such that the absolute pressure at A is 400 kPa The inner diameter of the…

A:

Q: A pump draws 24L/s of water from reservoir A and lifts it to reservoir B. The head lost from A to 1…

A: Flow rate=24L/s=24×10-3m3/s=0.024m3/s Head lost from A to 1= 3×velocity head at 150mm suction line…

Laws of Equilibrium

A body is said to be in equilibrium if the system of forces acting on the body tends to keep the body at rest, in other words, there is no translation motion or net torque on the body. Under such conditions, the equilibrium conditions are to be applied to analyze the condition. The branch of mechanics that deals with this condition is known as 'statics'. Under equilibrium, there are no net forces on the body.