Determine the largest permissible value of P for the beam and loading shown, knowing that the allowable normal stress is +80 MPa in tension and -115 MPa in compression. 465 96 mm -0.4 m- 0.2 m 0.2 m B 12 mm The largest permissible value of P is 48 mm 12 mm KN.

Q: H h d

A: To solve this, we need to find the permissible load at critical section that is at the section where…

Q: If M=6kip.ft, determine the maximum tensile stress in the beam shown in the figure below

A: DETERMINATION OF MAXIMUM TENSILE STRESS IN THE BEAM

Q: Determine the maximum permissible value of T provided the allowable shearing stresses in brass and…

A: ζb=70 MPaζs=110 MPaGb=80 GPaGs=40 GPa di=70 mmd0=90 mm

Q: Solve it correctly please. I will rate accordingly with 4votes.

A: Given data:- Inner diameter, d= 4 inch Wall thickness, t=0.1 inch Internal pressure, P=50 ksi Axial…

Q: The wooden beam shown is made by gluing together planks as shown. 8 kN/m Glue 80 mm 80 mm - NA 6 m…

A: Determine the maximum shear stress in the glue in kPa.

Q: The member shown in the right side consists of the steel rod AB that is screwed into the end of the…

A:

Q: GIVEN: Solid aluminum bar shown: 4 in. by 4 in. E = 10 x 10° psi oy = 36 ksi 4000 & 200016 4000 16 B…

A: A) Load in each section of bar PAB = 4000 lb ( T )  PBC = 4000 - 2000 = 2000 lb ( T ) PCD = 4000 -…

Q: Draw the V&M diagrams and calculate the largest permissible value of P for the beam and loading…

A: Allowable normal stress in tension=-80MPa Allowable normal stress in Compression=-140MPa To find…

Q: t p= 0.2N2 in P = 500 lbf 3 1.N1 in 2p h = H -2p Material: Aluminum (E=10.0x106 Ib/in?, v= 0.3)…

A: Given     N1=7  and N2=0Height of the section H=1.N1=1.7 inand thickness ρ=t=0.2N2=0.20 inreduced…

Q: What would be the temperature at which the bar will have a compressive stress of 3 MPa given that at…

A: Elongation due to temperature change δT=Lα(ΔT)ΔT=T2-T1=T2-(-20)=T2+20

Q: The lap joint is connected together using a 32 mm diameter bolt. Determine the permanent shear…

A: Given data in question Load 750 kN Diameter 32 mm To find out  Permenant strain

Composite Construction

Composite construction is the construction of structures in which two or more materials are used. Regarding structural engineering, composite construction is a construction where two materials are bound together in a technical manner such that both the materials act as a single unit to carry and transfer the load. The motives of composite construction are to increase the structural strength, make structures more aesthetic, and provide a sustainable environment.