Answered: Design a sprinkler irrigation system…

Design a sprinkler irrigation system for tomato production area (Figure 1). The pump is located at the center of the field. Show ALL your solutions, assumptions and design considerations.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Irrigation and drainage, i need solutions in 15 minutes please. MCQ/For the given data below find…

A: The sprinkler system capacity is given by: Q=2780×A×dF×H×E Where, Q = discharge capacity of the…

Q: A wastewater flow of 10,000 m³/d containing 400 mg/L BOD5 is to be treated in a rotating biological…

Q: (i) Question 1 Sketch, label and explain all the different parts in activated sludge system used…

A: Activated sludge system: The process uses microorganisms to remove the organic contaminants in the…

Q: Analyze the quality of water and design the treatment units required to meet BIS guidelines.

Q: As a process engineer, you are designing sedimentation tanks for a new drinking water treatment…

A: Surface area is given by A A = QVo Where ; Q = discharge per tank = 0.5 / 2 = 0.25 m3 /s Vo = From…

Q: Design a sprinkler irrigation system for tomato production area (Figure 1). The pump is located at…

A: When to use sprinkler irrigation : Sprinkler irrigation is a method of applying irrigation water…

Q: Using Dupuit formula find the drain spacing for the following data 1- Coefficient of permeability =…

A: The given data is shown below: Coefficient of permeability=0.3 m/dayRecharge required =0.84…

Q: The said town has population of 720,000 today. A wastewater treatment plant is to be designed and…

A: Wastewater treatment is a process, which is being done on the wastewater to change its quality for…

Q: Example Design a coagulation tank if Q=3000 m3/day, G=700s-1, D.T=60s, viscosity= 1.03*10-3 N.s/m2…

Q: Calculate the size of the septic tank in your home according to the number users in your home.

A: As per company's guidelines we can only answer first question. Kindly post other questions as…

Q: Disinfection, sedimentation, flocculation, coagulation, and filtration are processes for a surface…

A: Coagulation is defined as a water treatment process in which chemicals which are known as coagulants…

Q: A untreated waste water enters a stream as shown in figure. The concentration of sodium in the…

A: Given data, The concentration of sodium =15 mg/l flow rate=20 m3 /sec The concentration of sodium in…

Q: A disinfection contact basin is to be designed to provide sufficient contact time for 99% kill of E.…

A: Disinfection is the process of removing harmful microorganisms from the water. The objective of…

Q: Design a coagulation tank if Q=3000 m3/day, G=700s-1, D.T=60s, viscosity= 1.03*10-3 N.s/m2

Q: 4. After the rain, Muddy Creek became muddy flowing with 136mg/L of solids at 5.1m/s. The creek is…

A: Given:- The density of the muddy flowing = 136 mg/L of solids The rate of flowing = 5.1 m3/s The…

Q: An elevated storage supplies water to a residential catchment with a population of 10000. The…

Q: Example 5.21 Design the absorption field system for the disposal of septic tank effluent for a…

A: Given data- Absorption field system for the disposal of septic tank effluent, Population P=100…

Q: Design of a Pump System As a fresh engineer, you and one of your colleague are assigned to analyze a…

A: Assume datum at the pump level The elevation of the first reservoir from the pump, Z1 = 10 ft…

Q: You have 4 acre of watermelons that you irrigate. The irrigation system you use under standard…

A: Area of watermelons field = 34 acre(a) we know that 1 acre area=43560 ft2 so the area of…

Q: QUESTION 3 " (a) There are various type of flow measuring equipments available beside the pitot…

A: When a flowing river seems to have a loose or uncontrolled surface that is exposed to the air, it is…

Q: Problem 1.12 (modified), Masters and Ela, Introduction to Environmental Engineering and Science, 3rd…

A: Given Flow rate 2.5 MGDBOD 12 mg/LVolume of 1st 6.5 MGVolume of 2nd 3.5 MGConstant 0.43/dayTo find…

Q: erage flow of 100,000 Itrated a pipe 1,500 ft d the concentration at is 5 mg/L. The storage

A: velocity in pipes =v =2.5 ft/sdistance of first point = 1500 ft-500 ft =1000 ftso that time taken…

Q: Problem 3: You are considering three design alternatives for treating a pollutant in wastewater…

Q: EX1: Design a sedimentation tank and flash mixing tank (coagulation tank) to treat 0.20 m3/sec?

A: First Assuming all the data that will be required for designing a sedimentation tank,Maximum daily…

Q: Calculate the required capacity of the pipe distribution system

A: Given:- The annual quantity delivered to the city = 120,000,000 m3 The population of the…

Q: It was decided to design waste water collection system. The flow rate is 75000 L/d. A circular…

Q: Design a two-compartments septic tank to serve a household of twelve persons having the water…

A: It is required to determine the detention time of sedimentation tank. th=1.5-0.3logp×q Here p is the…

Q: b. Can you improvise a simple drip irrigation system with a small plastic pipe? Show how. c. Is a…

A: The drip irrigation method is the basic advancement that happened in field irrigation over the…

Q: Briefly stated, what is the principal purpose (i.e., treatment objective) of the following steps…

A: Preliminary treatment • It involves removal of inorganic particles such as glass pieces, sand…

Q: Describe briefly why flow equalisation is used at wastewater treatment plants. Discuss briefly how…

A: The technique of adjusting hydraulic speed, or rate of flow, via a wastewater treatment process is…

Q: Design a PFD (Process Flow Diagram) an describe a full process of sewage treatment plant

A: The process of waste water treatment includes: 1. Primary treatment. 2. Secondary treatment. 3.…

Q: 5) In a town with a population of 100000, where seven rapid sand filters operated at 10 m/h are used…

A: Given information:Population of the town: 100,000Number of rapid sand filters: 7Filtration rate per…

Q: This question about Sanitary Engineering Note: Assume any missing information. Question: Design a…

A: Given data- A rectangular sedimentation tank- Population P=1 million = 106, Rate of water supply…

Q: Problem 3: You are considering three design alternatives for treating a pollutant in wastewater…

A: Given data, Q = 8.6 mgd = 8.6×10^6 gal/d V = 9000 gal. For each system K= 1.1/min for first order =…

Q: The Flames Pool Company (FPC) was hired to drain a swimming pool when it is raining outside. If it…

A: IntroductionPumps are devices that are used to transfer fluids, usually liquids, from one location…

Q: Design a circular clariflocculator for treating water required for a population of 65,000 with a…

Q: City of Longview, TX Cherokee Water Treatment Plant 1. Evaluate the treatment operations with…

A: 1. In Longview, Texas the surface water source is Lake Cherokee, Sabine river and Lake O' the Pines.…

Q: Describe a closed water cycle that could be implemented on a college campus that includes typical…

A: A closed water cycle that could be implemented on a college campus

Q: wo seperated dry stormwater ponds with the same elevation at the bottom are connected by two pipe…

A: The given data in the question is: There are two separated dry stormwater ponds with the same…

Q: The existing configuration for a water distribution system is presently considered inefficient. A…

Concept explainers

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.

Question

Design a sprinkler irrigation system for tomato
production area (Figure 1). The pump is located
at the center of the field. Show ALL your
solutions, assumptions and design
considerations.
200 meters
Figure 1. Layout
pump
150 meters

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Define Irrigation, Necessity of Irrigation, Advantages and Disadvantages of Irrigation
(a) (b) (c) State the type and illustrate the sewer system commonly employed in Malaysia, Then, describe the function of each component involved. Sludge stabilization is an important step prior its disposal. Explain the stabilization process. Based on your understanding, justify if the stabilization method provided sustainable. M A new housing development in Bandar Baru Kangkar Pulai comprises the following premises: Residential Houses Schools (Day) Mosque Commercial (i) (ii) 1000 units : 3000 students : 700 persons : 30% from the above total PE (iii) treatment plant. UT Determine the size oi une commercial plot. ARANG Compute the average daily flow and peak flow of this development. PE=225 L/PE/day; Peak flow factor = 4.7p-0.11) Provide a reason why peak flow is important in the design a sewage
A wastewater treatment plat has 155000 Ib of mixed liquor volatile suspended solids (MLVSS) in the aeration tank. The flow rate is 33 MGD and the primary effluent has a BOD of 175 mg/L. Hint: MGD: million gallon per day & 8.34lb/gal. Find the food to-microorganisms ratio (Ib.d BOD/Ib MLVSS).
A storm of 0.5 in/hr falls on a watershed with three time area blocks: (A: Area =100 ac, time to gage 1 hr, B: Area = 200 ac, time to gage = 2 hours, and C: Area - 300, and time to gage = 3 hours), Determine the discharge at the end of the third hour using the time area method: O a. None of the above O b. 200 cfs O c. 300 cfs Od. 100 cfs
what are some past and current wastewater treatment methods in Singapore? (please mention pro and con in social, economic and environment)
design a 4-chamber septic tank to serve a hotel with a maximum occupancy of 250 persons.submit complete solutions and septic tank details.
Question No. (5): Choose the correct answer (A, B, C, and D) of the following 1-Which of these statements about drip irrigation A-Deep percolation and runoff are increased B-The water application efficiency is reduced C-The evapotranspiration is effectively reduced D-Fertilizers can be applied economically with the irrigation water 2-The Design application rate applied by drip irrigation is limited by A-the infiltration capacity of the soil B-the climatic conditions C-The water crop duty D-None of them 3-surface drainage usually requires A-A deep outlet for the main drains B-A careful topographic survey C-land smoothing D-Frequent maintenance 4- Soil is a heterogeneous, poly-phasic, particulate system with often very large interfacial area. We distinguish A-2 phases B- 4 phases С-1 phase D- 3 phases 5- The amount of deep percolations during the irrigation process is a function of А- The crop tуре C-Irrigation depth B- the soil properties D- Irrigation application rate
6. A company spilled a contaminant that got into the water distribution system of a small town, which has an average flow of 100,000 gpd. The contaminant infiltrated a pipe 1,500 ft from the storage tank, and the concentration at the infiltration point is 5 mg/L. The storage tank has a volume of 125,000 gallons and the first user is 500 ft from the storage tank. Assume velocity of 2.5 ft/s in pipes, and a rate constant of 3/day. What is the concentration at the first user?
Dear I need solution for this problem also The system of two basins shown in the picture, full flow stream 3785x1000 l/day in which the concentration of non-conservative pollutant is 20mg/l. The rate of decomposition of a non-conservative pollutant is 0.3/day. The volume of the first pool is 18925x1000 l and the second one is 11355x1000 l. Assuming complete mixing in each basin, determine the concentration of the non-conservative pollutant that leaves the individual basins. Please se attachemnt . Thank You very much
5. You are asked to design a single media filtration system for a drinking water facility. The design flow rate is 20 mgd (million gallons per day). The ideal filter velocity for your system is 8 m/hr. You design a set of filters to be used in parallel. Each filter box has a surface area of 50 m². a. How many filters do you need to construct? b. Estimate the (clean-filter) head loss in kPa? c. What mass removal (filter efficiency) would you expect for an influent stream that contains equal parts (by mass) of 1, 10 and 100 um particles? You can assume an adhesion efficiency a = 0.7. Sand Effective Size (mm) 0.8 Uniformity Coefficient 1.2 Grain Porosity Density (g/cm³) 2.6 0.4 Layer Thickness (m) 1.5
Design a water treatment plant for a town with a 2020 population of 25000 persons, average population growth rate of 1.5% annually and average PCWC of 120 liters per day. The treatment plant will have a design life of 20 years and expected to start operation in 2024 and will be designed to treat 1.3 times the average water requirement. The source of water supply is a river and the water treatment plant must adequately remove very fine suspended solids and microorganspisms.
PROBLEM #3 ONLY!!! Problem 1: A storm drain system is shown in Figure P16.11. For the flow conditions indicated, determine the time of concentration from Point A to Point C using the Kirpich, Kerby, Bransby-Williams, and Federal Aviation Administration Methods. Problem 2: Using the Kirpich time of concentration you calculated in Problem 1 and assuming the watershed is located in Seattle, WA, determine the intensity for the 50-year storm. Problem 3: For the watershed in Problems 1 and 2, determine the peak flowrate(in ft3/s )for the 50-year storm event at Point Cusing the Rational Method.