Describe and explain how each of the following experimental errors or variations would affect the HETP value and the efficient of the separation. a) If you didn't collect the HETP sample until midway through the distillation. b) If all of your liquid distilled within 5 minutes of the time you began heating. c) If you stacked two packed columns over boiling flask rather than one.

Q: Which of the following would cause a loss of yield and would also change the observed/measured ratio…

A: Water molecules pull the sodium and chloride ions apart, breaking the ionic bond that held them…

Q: 1. Define the following terms and give an example of each taken from this experiment. а. torr…

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: for specialized fractionating column in a experiment, there are ways to increase the surface area…

A: When considering the choice between a specialized fractionating column and fractional distillation,…

Q: In a fractional distillation experiment it is important to wrap insulting tape and Al foil around…

A: Wrap the distillation column with an insulated like Aluminium foil insulation bill aloud the vapour…

Q: A mixture of the two compounds shown below is dissolved in ether. Using the information given in the…

A: Compound X is a carboxylic acid and compound Y is a tertiary amine. Both X and Y are soluble in…

Q: Imagine your original mixture had contained a component capable of sublimation, such as naphthalene.…

A:

Q: Make a seperate schematic diagram from provided procedures in photos

A: The schematic diagram shows a diagrammatic representation of procedures used in an experiment making…

Q: A student rushed through this experiment, but noted some procedural errors in their lab…

A: Remember, during titration we follow: N1V1 = N2V2 If N2V2 is considered for unknown solution then…

Q: Provide the balanced reaction for this experiment.

A: The balanced chemical reaction between KHP and NaOH is given below as,

Q: Why do we know the aqueous layer is the upper layer during the wash steps?

A:

Q: Imagine that the blue component of a given mixture moved 2.5 cm from the oigin or starting line, and…

A: Given : distance travelled by the component = 2.5 cm and distance travelled the solvent = 10.0 cm

Q: If you were to use a mixture of methylene chlorine and ethyl acetate to elute the column (rather…

A: In column chromatography, the non-polar molecule elutes first then the polar molecule because the…

Q: Volumetric Analysis  The mass of KHC8H4O4 is measured to the nearest milligram; however, the volume…

A: A popular quantitative analytical technique is volumetric analysis. As the name implies, this…

Q: Calculate the amount of isopentyl acetate that should be present in the reaction mixture at…

A: The objective of this question is to show the reaction of isopentyl alcohol and acetic acid to form…

Q: Why is it not necessary to dry the Erlenmeyer flask between each trial?

A:

Q: Use what you know about solubility, chemical kinetics, reaction rates, and how extractions works to…

A: Coffee consists of 2-3% caffeine, 3-5% tannin, 13% proteins, carbohydrates and 10-15% oil. The…

Q: Which of the following are considerations that should be taken when choosing solvents for…

A: Recrystallization is a purification technique for solid compounds. To perform recrystallization, an…

Q: Why is necessary to perform more than one extraction to obtain all the compound from the aqueous to…

A:

Q: 15. What is the dilution factor for 40 uL of sample added to 200 uL of diluent?

A: Welcome to bartleby !

Q: 2. During heating, some solution of NaCl spattered out of the evaporating dish. How would this…

A: The question is based on the concept of experimental chemistry. We have to evaluate the impact of…

Q: Select the factor that will decrease the relative supersaturation during a precipitation process? A.…

A: Raising the temperature, will increase solublity so will decrease the relative supersaturation.…

Q: The goal of the recrystallization procedure is to obtain purified materlal with a maximized…

A: Recrystallization also named fractional crystallization. It is a method used for the purification of…

Q: Why was it necessary to make sure that some solid was present in the main solution before taking the…

A: Solubility product (Ksp) is a constant that describes the equilibrium between a sparingly soluble…