constants:A (medium) single phase transmission line 100 km long has the followingResistance/km = 0.25 2;Susceptance/km = 14 × 10 siemen;Reactance/km = 0.8Receiving end line voltage = 66,000 VAssuming that the total capacitance of the line is localised at the receiving end alone, determine(i) the sending end current (ii) the sending end voltage (iii) regulation and (iv) supply power factor.The line is delivering 15,000 kW at 0.8 power factor lagging. Draw the phasor diagram to illustrateyour calculations.

Answered: Image /qna-images/answer/1fb16484-de73-4c07-86f1-5242b944f67e.jpg

Answered: constants: A (medium) single phase…

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.15MCQ

See similar textbooks

Similar questions

In terms of line-to-line capacitance, the line-to-neutral capacitance of a single-phase transmission line is Same Twice One-half
One circuit of a single-phase transmission line is composed of three solid 0.5 cm radius wires. The return circuit is composed of two solid 2.5 cm radius wires. The arrangement of conductors is as shown in the following figure. Applying the concept of GMD and GMR, find the inductance of the complete line in mH per km. 5 m 5 m 10 m 5 m Conductor X Conductor Y
17.) A single-circuit three-phase transposed transmission line is composed of four bundled ACSR Falcon as shown in the figure below. The bundle spacing is 30 cm. 30 cm+ -D12 = 15 m- D23 = 15 m D13 = 30 m A.) Calculate the inductance per phase per kilometer B.) Calculate the capacitance per phase per kilometer of the line. C.) If the conductor is replaced with a two bundled conductor and the inductance per phase is 60% of the inductance from Part A, what would be the new self- GMR of the conductor.
Question # 2: One circuit of a single-phase transmission line is composed of three solid 0.5 cm radius wires. The return circuit is composed of two solid 2.5 cm radius wires. The arrangement of conductors is as shown in the figure. Applying the concept of the GMD and GMR, find the inductance of the complete line in millihenry per kilometer. 5m 5 m Conductor X 10 m 5 m Conductor Y
A lossless transmission line has a capacitance per unit length of 90 uF/m (microFarad/meter) and an inductance per unit length of 1 nH/m. The load impedance ZI is purely resistive. Both the load impedance and the generator impedance are 50 ohms. Source voltage amplitude is unknown at this point. Find the characteristic impedance and the propagation velocity for this transmission line!
A single-phase transmission line 35 km. long is composed of two solid round conductors having a radius of 0.45 cm. each. If the conductors are spaced 3.5 m. Calculate a.) The value of inductance per conductor b.) The inductance of the line c.) The reactance of the line
Please explain each answers... And choose the correct one
The conductor of a single-phase 60-Hz line is a solid round aluminum wire having a diameter of 0.412 cm. The conductor spacing is 3 m. Determine the inductance of the line in millinery’s per mile. How much of the inductance is due to internal flux linkages? Assume skin effect is negligible.
For a lossless trabsmisison line, the characteristic impedance is 80 ohm. If the capacitance per unit length is 1.5 mh/m then what will be the inductance per unit length.
-2. A 3-phase, 132 KV, 50 Hz, 100 Km, single circuit bundle conductor transmission line as shown in the figure below. If the diameter of each strand is 1 cm, and the conductors are regularly transposed . Determine , the capacitance to neutral per phase per Km. 6 m 5m 0.18 m 14
9. Calculate the GMR, GMD and inductance per phase per kilometer of the line with a radius of 0.250 cm 2,8 10 m 1.A 10 m 3. C -10 m 3. C 1: A 10 m 2,8
please model a transmission line pair with an equivalent circuit model. establish the transmission equations using Kirchhoff's current law and voltage law. solve the equivalent circuit model equations to get wave equation.

SEE MORE QUESTIONS

Recommended textbooks for you

Power System Analysis and Design (MindTap Course …

Electrical Engineering

ISBN:

9781305632134

Author:

J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:

Cengage Learning