Chap 14. Interfacing to external memory 1. Interface two 16 Kbytes RAM chips (16K x 8) with the 8051. Connect the first chip starting a 4000H onwards and the second chip C000H onwards. 2. Interface 4Kbyte of ROM (2732-EPROM, 4K x8) as data memory starting at the memory location 0000H. 3. Interface 8 Kbytes of SRAM (6264) and 8 Kbytes of EEPROM (2864) with the 8051 both starting at the address 0000H.

Chap 14. Interfacing to external memory 1. Interface two 16 Kbytes RAM chips (16K x 8) with the 8051. Connect the first chip starting a 4000H onwards and the second chip C000H onwards. 2. Interface 4Kbyte of ROM (2732-EPROM, 4K x8) as data memory starting at the memory location 0000H. 3. Interface 8 Kbytes of SRAM (6264) and 8 Kbytes of EEPROM (2864) with the 8051 both starting at the address 0000H.

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Consider an I/O bus that can transfer 6 bytes of data in one bus cycle.Suppose that a designer is considering to attach the following two components to this bus. Hard drive with a transfer rate of 100 M bytes/sec Video card with a transfer rate of 128 M bytes/sec What will be the implications?(The maximum frequency of the bus is 30 MHz)
A large endian byte addressed memory system with eight distinct memory modules is included in a computer system. Each memory module has 134217728 cells and is 32 bits wide. a) What is the 32-bit memory address of cell 1048578 in module 3 if the memory uses high order interleaving? b) What is the 32-bit memory address of byte 1048575 inside module 2 if the memory uses high order interleaving? c) What is the 32-bit memory address of cell 511 inside module 1 if the high order interleaved memory utilises little endian storage order instead of big endian storage order?
Q2/ A- implement 32KX 16 EPROM using 8KX8 EPROM Ic's and 2:4 decoder? B- Design microprocessor 8086 memory system consisting of 1M byte, using • 128K*8 memory chips 2:4 decoder chips that have two enable lines one active high and the other active low • control line signal that 8086 microprocessor provided it in minimum mode
Question 3 If the address range of the main memory of a hypothetical machine is 000-FFF, 1. how many addressable locations are there? 2. What is the width of the address bus(express answer in terms of nibbles)?
Suppose that a 16MB system memory is built from 256KB RAM chips. How many address lines are needed to select one of the memory chips? Explain why.
15- The (00000) and (000000) are two special pins used in-- A- SRAM O B-EPROM C-DRAM O D- Flash RAM 16- Once the 74LS138 is enabled, the address inputs ABC=111 select output pin Y7= O and all other outputs would be----- O A- ones or zeros O B- ones only O C- zeros only O D- high impedance
Suppose that a 8MB system memory is built from 256KB RAM chips. How many address lines are needed to select one of the memory chips? Explain why.
Assume a data bus is 16 bits wide. The data and address lines are multiplexed. If the bus runs at a speed of 300MHz, how long will it take to transfer 15MB over the bus?
Assume that the microprocessor can directly address 64K with a and 16 data pins The memory map for 16K x 16 RAM system that design by using 8KX8 RAM are
Question The 64K single memory chip is used in total. Determine the number of lines in address bus including CHIP SELECTS? (Chip select lines will be most left) with steps please
Q2/ A- implement 32KX 16 EPROM using 8K×8 EPROM Ic's and 2:4 decoder? B- Design microprocessor 8086 memory system consisting of 1M byte , using • 128K*8 memory chips • 2:4 decoder chips that have two enable lines one active high and the other active low • control line signal that 8086 microprocessor provided it in minimum mode
TOPIC: MARIE Assembly/MARIE Simulator Pls answer only if u know, correct answers only pls! will rate you if correct 1.) What is the address of the last (bottom-rightmost) memory location? My answer is 4095 but it is wrong. I thought MARIE starts at 0000 and ends with 4095 so I need help on this. 2.) What is the content of memory address 001? (No need to write 0x from hereon; we already assume hexadecimal unless otherwise stated.) My answer is 3000 but it is wrong.