Q2/ A- implement 32K× 16 EPROM using 8K×8 EPROM Ic's and 2:4 decoder? B- Design microprocessor 8086 memory system consisting of 1M byte , using 128K×8 memory chips 2:4 decoder chips that have two enable lines one active high and the other active low control line signal that 8086 microprocessor provided it in minimum mode

Q: If R12 contains the value 0x4000 and register R8 contains the value 0x20, the effective address (EA)…

A: Correct Option:  CSummary: - Using LDR (Light Dependent Resistor) Concept and converting into Hexa…

Q: Write a single instruction (other than NOT) that reverses all the bits in EAX

A: The XOR operator checks the corresponding bits of two operands and sets the result bits of both the…

Q: Draw pinouts of 8088 or 8086 microprocessor (µp). Also draw schematics of 8088/8086 µp buses with…

A: The pinouts of the 8086 microprocessor are drawn below.

Q: d-SF 4-in 8086 register addressing all registers can be used except..... a-accumulator b-flag…

A: The given question are fill in the blank type question.

Q: 12. In a BSL instruction block B3:10 holds the word 8ECOH, and the bit starting address is B3:0/15.…

A:

Q: Q1 Write a sequence of instruction to poll switch at 17 of 74F244 that is connected to port 0. ALE…

A: In actual applications, it is occasionally essential to repeatedly read the value at an input line…

Q: Q1-Design the hardware required to interface 32KB of SRAM to the demultiplexed address and data bus…

A: To interface a 32KB SRAM to the demultiplexed address and data bus of the 8086 Microprocessor…

Q: A decoder 74LS138 is to interface with 8086 microprocessor and a memory for perfect communication.…

A: Truth table design with perfect configuration:

Q: ICs, RAM using 8G×32-bit rnal gates, mal number of components. Each RAMI as R/W. CLOCK, EN', Data…

A: Given, to draw a block diagram of a 16.*64 bit Ram using 8G*32 bit Ram ICs. Below is the detailed…

Q: in 80886 microprocessor  Write an ALP to evaluate x.(y +z) where x = 10H, y = 20H and z = 30H and…

A: Given: in 80886 microprocessor  Write an ALP to evaluate x.(y +z) where x = 10H, y = 20H and z = 30H…

Q: Develop an Intel 8086 ALP using BIOS interrupts to print a 100x50 (in pixels) parallelogram in cyan…

A: Intel 8086 is a sixteen-bit HMOS microprocessor. It is to be had in forty pin DIP chip. It uses a 5V…

Q: For the below microprogrammed architecture, what is the ALU sequence of actions/micro instruction…

A: Solution:--   1)The given question is an type of the multiple choice question so some of the options…

Q: Q2/ A-implement 32K* 16 EPROM using 8Kx8 EPROM Ic's and 2:4 decoder? B- Design microprocessor 8086…

A: A. To implement a 32Kx16 EPROM using 8Kx8 EPROM ICs and a 2:4 decoder,

Q: DESIGN AN INTERFACE BETWEEN 8086 CPU AND TOW CHIPS OF 4K X 8 EPROMS AND TWO 4K X 8 RAM CHIPS WITH…

A: The address of the RAM may be selected anywhere in the 1 MB address space of 8086, but to make the…

Q: Determine the address map by filling in the following table. Address Byte Address (hexadecimal)…

A: The answer may be found below based on the information provided above: -Address…

Q: Draw a block diagram of a microprocessor based system interfaced with 8237and RAMAlso show clock…

A: Given:

Q: A- implement 32K* 16 EPROM using 8K*8 EPROM IC's and 2:4 decoder? B- Design microprocessor 8086…

A: A.  Total number of 8Kx8 ROM chips required = 32Kx16/8Kx8 = 4x2 = 8 These 8 chips are stored as…

Q: is stored in the memory starting 2- The ISR address of interrupt number at address (0039CH). 3- In…

A: 2) Each interrupt type is given a number between 0 to 255 and the address of each interrupt js found…

Q: I - represent (-4.35) using IEEE-754 single precision

A: NOTE: Answering only the first question as per the guidelines. We have given a decimal number. We…

Q: 2. Draw an R-type datapath with an Instruction Fetch unit. Point to be noted, the ISA and ALU both…

A: Please upvote. I am providing you the correct answer below.

Q: Q2- Design the hardware required to interface 128KB of SRAM to the demultiplexed address and data…

A: Design the hardware required to interface 128KB of SRAM to demultiplexed address,data bus of the…

Q: Match segment and offsetregisters and determine their correspondingactual memory location addressed…

A: It is defined as a high-speed memory storing units. It is an element of the computer processor. It…

Q: A- implement 32KX 16 EPROM using 8K*8 EPROM Ic's and 2:4 decoder? B- Design microprocessor 8086…

A: A.  Total number of 8Kx8 chips required = 32Kx16 / 8Kx8 = 4*2 = 8 These 8 chips are arranged as 4…

Q: Write a sequence of instruction to poll switch at 17 of 74F244 that is connected to port 0.

A: The IO interface circuits of an 8086-based microcomputer system.  The input/output system of the…

Fundamentals of Input and Output Performance

The I/O subsystem is a component of computer system design that uses buses to assist communication between the Central Processing Unit, Computer Memory/Storage, and Input and Output Devices (that is known as peripheral devices). The I/O subsystem includes disc controllers, tape drives, discs, system buses, and other devices. The I/O database application reads and writes drives using the operating system windows I/O.