Calculate the molar mass of air with classical composition (given in volume percent): 78.09% N2, 20.95%02, 0.93% Ar, 0.03% CO2. Calculate the molar volume of air at standard density of 1.293 g/dm3

So, the molar mass of air with classical composition is approximately 28.94 g/mol, and the molar…

Answered: Calculate the molar mass of air with…

Chemistry: Principles and Reactions

8th Edition

ISBN:9781305079373

Author:William L. Masterton, Cecile N. Hurley

Publisher:William L. Masterton, Cecile N. Hurley

Chapter5: Gases

Section: Chapter Questions

Problem 28QAP: Exhaled air contains 74.5% N2, 15.7% O2, 3.6% CO2, and 6.2% H2O (mole percent). (a) Calculate the...

See similar textbooks

Similar questions

The gas in the discharge cell of a laser contains (in mole percent) 11% CO2, 5.3% N2, and 84% He. (a) What is the molar mass of this mixture? (b) Calculate the density of this gas mixture at 32C and 758 mm Hg. (c) What is the ratio of the density of this gas to that of air (MM=29.0g/mol)at the same conditions?
Given that a sample of air is made up of nitrogen, oxygen, and argon in the mole fractions 0.78 N2, 0.21 O2, and 0.010 Ar, what is the density of air at standard temperature and pressure?
perform stoichiometric ca1cu1uions for reactions involving gases as reactants or products.
A sample of a smoke stack emission was collected into a 1.25-L tank at 752 mm Hg and analyzed. The analysis showed 92% CO2, 3.6% NO, 1.2% SO2, and 4.1% H2O by mass. What is the partial pressure exerted by each gas?
Earths atmosphere is approximately 80 N2 and 20 O2. If the total atmospheric pressure at sea level is about 14.7 lb/in2. where lb/in2 is pounds per square inch, a common but non-SI unit of pressure, what are the partial pressures of N2 and O2 in units lbs/in2?
In the anaerobic oxidation of glucose by yeast, CO2 is produced: If 1.56 L of CO2 were produced at 22.0 C and 0.965 atm, what mass of C6H12O6 is consumed by the yeast? Assume the ideal gas law applied.
The Mount Pinatubo volcano eruption in 1991 released an estimated 1.82 x 1013g of SO2 into the atmosphere. If the gas had an average temperature of -17.0 C and filled the troposphere, whose approximate volume is 8 x 1021L, what is the approximate partial pressure of SO2 caused by the eruption?
The compression ratio in an automobile engine is the ratio of the gas pressure at the end of the compression stroke to the pressure in the beginning. Assume that compression occurs at constant temperature. The total volume of the cylinder in an automobile is 350 cm3, and the displacement the reduction in volume during the compression stroke is 309 cm3. What is the compression ratio in that engine?
A 1.000-g sample of an unknown gas at 0C gives the following data: P(atm) V (L) 0.2500 3.1908 0.5000 1.5928 0.7500 1.0601 1.0000 0.7930 Use these data to calculate the value of the molar mass at each of the given pressures from the ideal gas law (we will call this the apparent molar mass at this pressure). Plot the apparent molar masses against pressure and extrapolate to find the molar mass at zero pressure. Because the ideal gas law is most accurate at low pressures, this extrapolation will give an accurate value for the molar mass. What is the accurate molar mass?
A glass tumbler containing 243 cm3 of air at 1.00 102 kPa (the barometric pressure) and 20C is turned upside down and immersed in a body of water to a depth of 25.5 m. The air in the glass is compressed by the weight of water above it. Calculate the volume of air in the glass, assuming the temperature and barometric pressure have not changed.
Target check For each of the macroscopic charcateristics unique to the gas phase of matter described in section 4.1-a compressibility, b expandability, c low density, d may be mixed in a fixed volume, and e uniform, constant pressure on container walls-describe how a postulate of the kinetic molecular theory explains the reason for the characteristic.
97 Homes in rural areas where natural gas service is not available often rely on propane to fuel kitchen ranges. The propane is stored as a liquid, and the gas to be burned is produced as the liquid evaporates. Suppose an architect has hired you to consult on the choice of a propane tank for such a new home. The propane gas consumed in 1.0 hour by a typical range burner at high power would occupy roughly 165 L at 25°C and 1.0 atm, and the range chosen by the client will have six burners. If the tank under consideration holds 500.0 gallons of liquid propane, what is the minimum number of hours it would take for the range to consume an entire tankful of propane? The density of liquid propane is 0.5077 kg/L.

SEE MORE QUESTIONS

Recommended textbooks for you

Chemistry: Principles and Reactions

Chemistry

ISBN:

9781305079373

Author:

William L. Masterton, Cecile N. Hurley

Publisher:

Cengage Learning

Chemistry

ISBN:

9781133611097

Author:

Steven S. Zumdahl

Publisher:

Cengage Learning

Chemistry for Engineering Students

Chemistry

ISBN:

9781337398909

Author:

Lawrence S. Brown, Tom Holme

Publisher:

Cengage Learning

Chemistry: Principles and Reactions

Chemistry

ISBN:

9781305079373

Author:

William L. Masterton, Cecile N. Hurley

Publisher:

Cengage Learning

Chemistry

ISBN:

9781133611097

Author:

Steven S. Zumdahl

Publisher:

Cengage Learning

Chemistry for Engineering Students

Chemistry

ISBN:

9781337398909

Author:

Lawrence S. Brown, Tom Holme

Publisher:

Cengage Learning

Chemistry: Principles and Practice

Chemistry

ISBN:

9780534420123

Author:

Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:

Cengage Learning

Introductory Chemistry: An Active Learning Approa…

Chemistry

ISBN:

9781305079250

Author:

Mark S. Cracolice, Ed Peters

Publisher:

Cengage Learning

Chemistry: An Atoms First Approach

Chemistry

ISBN:

9781305079243

Author:

Steven S. Zumdahl, Susan A. Zumdahl

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

Calculate the molar mass of air with classical composition (given in volume percent): 78.09% N2, 20.95% 02, 0.93% Ar, 0.03% CO2. Calculate the molar volume of air at standard density of 1.293 g/dm3