Calculate A, B, C, and D constants, sending end voltage and sending end current of a 3-phase, 50-Hz overhead transmission line 100 km long has the following constants Resistance/km/phase = 0.1, Inductive reactance/km/phase 0.20, Capacitive susceptance/km/phase = 0.04 x 10 siemen. when supplying a balanced load of 10,000 kW at 66 kV, p.f. 0-8 lagging. Use nominal T method. and

Calculate A, B, C, and D constants, sending end voltage and sending end current of a 3-phase, 50-Hz overhead transmission line 100 km long has the following constants Resistance/km/phase = 0.1, Inductive reactance/km/phase 0.20, Capacitive susceptance/km/phase = 0.04 x 10 siemen. when supplying a balanced load of 10,000 kW at 66 kV, p.f. 0-8 lagging. Use nominal T method. and

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.10MCQ: Transmission line conductance is usually neglected in power system studies. True False

See similar textbooks

Similar questions

In a three-phase line, in order to avoid unequal phase inductances due to unbalanced flux linkages, what technique is used?
Consider the 500 kV, three phase bundled conductor line as shown in the figure below. Find the line to neutral capacitance. 0.5 m 30 mm (0) (O to Ine 15 m 15 m
A 60 Hz, three-phase, transposed transmission line, is designed with three bobolink conductors per phase, in horizontal arrangement as shown in the figure below. Distance between consecutive phases is D = 6.2 m and distance among bundle conductors is h =0.5m. Each conductor has a radius of 18 mm and a GMR of 14.39mm. The per phase resistance is 1.677x10-5 2/m. r= 18 mm GMR= 14.39 mm a b h D D The per phase shunt admittance assuming zero conductance in µO/km is: О a., 5.4347 O b. j5.3316 О с /4.2266 O d. j4.0973 O e. 59630.2922 + j10.9770
In a short paragraph, explain the need to use bundled phase conductors in HV, EHV, and UHV 3-phase power transmission lines.
Problem 3.5: From a 3-phase, 480 V generator switchboard, a feeder takes 3-phase power to two equipment at the other end via cable and trans- former with the combined series impedance Z = 0.04 + j 0.09 Q per phase. The voltage at receiving end point A rises and falls as a large 3-phase, 500 kVA load at point A varies over time. The small 1 kVA load, also connected at point A, remains online continuously, and must accommodate the voltage variations at point A with the 500 kVA load fully on or fully off. Determine the voltage range that the 1 kVA load will see, over which it must perform within its specifications.
A 132 kV, 60 Hz double circuit 3-phase overhead line with specific spacing valucs shown in the figure below. The phase sequence is ABC with conductor's radius in 0.74 cm. Assume that the total length of line is 1000 meters. Calculate the following parameters; a) Inductance in H/phase/kilometer. b) The inductive reactance in ohm/km. A B C O20cm O 30cm 40cm 6m 6m
A three-phase 20 kV medium-voltage line is 10 km. Resistance is 0.365 2/km and reactance is 0.363 2/km (inductive). Voltage at the beginning of line is 20.5 kV. At the end of the line is loading P= 800 kW with power factor 0.95ind. Draw 1-phase equivalent diagram and calculate load current, line voltage at the end the of line, voltage drop and power losses of the line.
Please provide Handwritten answer
Q7: Generators G, and G2 are identical and rated 11 kV, 20 MVA and have a transient reactance of 0.25 pu at own MVA base. The transformers Tj and T2 are also identical and are rated 11:66 kV, 5 MVA and have a reactance of 0.06 pu to their own MVA base. The line is 50 km long; each conductor has a reactance of 0.848 ohm per km. The three phase fault is assumed at F, 20 km from generator G¡ as shown in Fig. below. Find the short circuit current. (G) (G2) F Ti T2
3-phase single circuit bundled conductor line with two sub-conductors per phase has horizontalspacing with 6.1 m between the centre lines of adjacent phases. The distance between the subconductorsof each phase is 30.5 cm and each sub-conductor has a diameter of 2.54 cm. Find theinductance per phase per km. [0.988 mh]
2. A three-phase 60-hz transmission line has its conductors arranged in a triangular formation so that two of the distances between conductors are 20 ft and the third is 40 ft. The conductors are ACSR Rook. Determine the capacitance to neutral in microfarads per mile and the capacitive reactance to neutral in ohm-miles. If the line is 115 mi long, find the capacitance to neutral and capacitive reactance of the line.
In the following network, the voltage magnitudes at all buses are equal to 1 p.u., the voltage phase angles are very small, and the line resistances are negligible. All the line reactances are equal to j1 p.u. (1) (2. P₂ = 0.1 p.u. P3 = 0.2 p.u. The voltage phase angle 83 in radian at bus 3 is (Assume one of the generator bus as slack bus and sin-¹ (0.1) = 0.1 rad) (a) -0.1 (b) -0.2 (c) 0.1 (d) 0