C4.4 The cantilever beam AB of length L carries a distributed loading w that varies with the distance x. Given L and w(x), construct an algorithm to plot the shear force and bending moment diagrams. Use (a) L=3 m and w = (50 kN/m) sin(z.x/2L); and (b) L= 5 m and 20 kN/m if x < 1.0 m (20 kN/m) 1.0 m if 1.0 m < x< 4 m W = if x > 4 m -w(x) A B

Q: Consider the following linear equations -7x + 8y + 4z - 7x + (25 – k)y + 3z = 11 - 7x + 8y + (7 –…

A: The given set of equations are:

Q: an isometric For the objects shown in orthographic projection below, construct Use the box method to…

A: Given: Draw isometric view from given orthographic projections.

Q: The given sketch is a cross section view of bracket. Sketch the 2D sketch of the below figure using…

A:

Q: Q3/ Find the angles and the distance for each plane, using by draw the following the table for each…

A:

Q: Draw the section view (locate the section line/cutting line along midpoint of dim 71 )

A:

Q: can't visualize what this stereoscopic image looks like, can someone please draw it out?

A: Find Create a given model by using the drawing.

Q: @AB=4 rad/s. AB= 6 rad/s2 A 0.5 m TB/IC 1 m 60° KIC Now let's look closer at Figure 2 from the prior…

A: Now let's look closer at Figure 2 from the prior question. By drawing lines that pass through points…

Q: i have a question, please help The resultant describes the __________ of multiple ___________. The…

A: The question is given about addition of vector. We have fill the correct sequence.

Q: 3. On the drawing and produced part below, label the following terms: Datum feature symbol Datum…

A: Label the given terms.

Q: Now we will repeat the previous problem using the Cartesian method. Values: FA = 20 N FB = 30 N a =…

A: According to the question FA =20 N FB =30 N angle = 25 deg we need to find the resultant with the…

Q: A Homework Set 7 Figures L/3- Problem 9 P C -L/3- P D -L/3- B

A:

Q: Problem 1: Basic 2-D Construction In this exercise basic construction and edit commands will be…

A: Given DataThe length of the figure is 6.5 units.The height of the figure is 4.5 units.FindCreate the…

Q: Many aspects of a gymnast's motion can be modeled by representing the gymnast by four segments…

A: Draw the given table.

Q: Use creo parametcric 4.0 drawing to Sketch all the compulsary part and partial views, including…

A:

Q: Simplify the following expressions (note that dij is the Kronecker delta, repeated index means…

A: a) The Kronecker delta is equal to 1 if the indices are equal and 0 otherwise. Therefore, δtt = 1.…

Automation in manufacturing processes

The term automation refers to the technique through which the creation of an apparatus takes place using an automatic process or a system. Let us try to understand this with an example.