BW=1MHZFor Johnson-Nyquist Noise Generator (or Thermal Noise Generator), the device utilizes thethermal noise that naturally arises from the random motion of electrons in resistors at a non-zerotemperature. The voltage is arising from thermal noise in two resistors of 80 and 120 QatTemperature T=290 °k:1-Write the equations of v(t), 12(t), up on the circuit diagram of series and parallel connecti2- Apply the equation v(t) to find Vrms for series connection scheme.3- Find inrms for Series scheme4- Find the Vrms for series scheme. By using i̟rms√³(+)Ov²(t)80 120wwR₁ R₂GiGif(t)1/80 1/120

The two resistors are:R1=80 ΩR2=120 ΩTotal Req=200 ΩWe'll walk through each step freshly.…

Answered: BW=1MHZ For Johnson-Nyquist Noise…

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter8: Basic Electric Motors

Section: Chapter Questions

Problem 25RQ: List the five capacitor replacement rules.

See similar textbooks

Similar questions

List the five capacitor replacement rules.
Shown in the figure below is an "RLC" circuit driven by an AC power source. The AC power source has an RMS voltage of Vps(RMS) = 9.35 Volts and is running at a frequency of f = 113000 Hz. The resistor has a resistance of R = 1980 , the capacitor has a capacitance of C = 1.08e-09 Farads, and the inductor has an inductance of L = 3.71e-03 Henries. mm Vps Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit øztot Determine the numerical value of Ztot = 2384 Determine the numerical value of @Z tot Determine the current through the circuit: ● R www I(PEAK) = I(RMS) = ● ● Determine the voltage across the inductor: • VL(PEAK) = Volts Volts VL(RMS) = Amps Amps Determine the voltage across the capacitor: Vc(PEAK) = Volts Volts Vc(RMS) = = 33.85 a capacitive switcher Ω degrees C If a second circuit were connected in parallel with the resistor, this circuit would be considered as: O a high-pass filter a radio tuner O…
The current through a 50 mH inductor is given below. Use Ohm’s Law to find the voltage. Convert to polar form, find the impedance and complete the math, then convert back to the waveform at i1 = 7.5sin(2500t – 20°) mA and i2 = 5.9sin(200t + 40°) mA
Shown in the figure below is an "RLC" circuit driven by an AC power source. The AC power source has an RMS voltage of Vps(RMS) = 11.80 Volts and is running at a frequency of f = 147000 Hz. The resistor has a resistance of R = 3910 Ω, the capacitor has a capacitance of C = 4.01e-10 Farads, and the inductor has an inductance of L = 5.97e-03 Henries.Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit ?Ztot = Determine the numerical value of Ztot = ΩDetermine the numerical value of ?Ztot = degreesDetermine the current through the circuit: I(PEAK) = Amps I(RMS) = Amps Determine the voltage across the inductor: VL(PEAK) = Volts VL(RMS) = Volts Determine the voltage across the capacitor: VC(PEAK) = Volts VC(RMS) = Volts If a second circuit were connected in parallel with the resistor, this circuit would be considered as: a high-pass filtera flux capacitor a radio tunera phase…
A capacitor in series with a 200 ohms resistor draws a current of 0.3 ampere from 120 volts, 60 hz source. What is the value of the capacitor in microfarad? a. 8.7 b. 9.7 c. 6.7 d. 7.7
Please disregard the question on the picture. Here's the right question, at what frequency will the value of the impedance be twice that at 25Hz (refer to the given in question #20).
An inductor, a capacitor, and a resistor are connected in parallel with a function generator. The inductor draws 100mA RMS, the capacitor draws 150mA RMS, and the resistor draws 200mA RMS. Find the magnitude of the total current.
What impedance vector (0- j15) Ohms represents:A. A pure resistance. C. A pure capacitance.B. A pure inductance. D. An inductance combined with a capacitance.
please solve quickly.
For the circuit below with input voltage V1, a step function of magnitude 25 volts at time t-0, find the transient response voltage across the capacitor C1 and plot the results: (Provide your calculations and reasoning for your answer.) R1 555 250mH V1 = 0 V2 - 25 TD = 0 TR In V1 C1 TF in PW- 25 PER = 3.3u
Please show work
.A series RLC circuit contains a 4-kN resistor, an inductor with an inductive reactance (X,) of 3.5 kn, and a capacitor with a capacitive reactance (Xc) of 2.4 kN. A 120-Vac, 60-Hz power source is connected to the circuit. How much voltage is dropped across the inductor?

SEE MORE QUESTIONS

Recommended textbooks for you

Electricity for Refrigeration, Heating, and Air C…

Mechanical Engineering

ISBN:

9781337399128

Author:

Russell E. Smith

Publisher:

Cengage Learning