4. Three resistors are connected in delta. If the line voltage is 13.2 kV and the line current is 1202 A, calculate the following: (1) The current in each resistor (2) The voltage across each resistor (3) The power supplied to each resistor (4) The power supplied to the 3-phase load (5) The ohmic value of each resistor

4. Three resistors are connected in delta. If the line voltage is 13.2 kV and the line current is 1202 A, calculate the following: (1) The current in each resistor (2) The voltage across each resistor (3) The power supplied to each resistor (4) The power supplied to the 3-phase load (5) The ohmic value of each resistor

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.28P: For the system shown in Figure 3.34. draw an impedance diagram in per unit by choosing 100 kVA to be...

See similar textbooks

Similar questions

Differentiate Kirchhoff's voltage law from Kirchhoff's Current law.
three transformers connected as indicated below to step the voltage down from 13,200V to 460V. a) determine the ratio of the transformer if the transformers are connected wye-delta. b) determine the ratio transformation if the transformers are connected wye-delta. c) determine the ratio of transformation if the transformers are connected delta-wye. d) determine the ratio of the transformation if the transformers are connected delta-delta. BOX THE FINAL ANSWER AND USE 4-5 DECIMAL PLACES FOR THE ANSWER subject: ELECTRICAL APPARATUS AND DEVICES
Refer to Figure 8-31 to answer the following questions. Assume that a line voltage of 12,470volts is connected to the primary of the transformer and the line voltage of the secondary is 480volts. What is the turns ratio of the transformer? Assume the load has an impedance of 6Vper phase. What is the secondary line current? How much current is flowing in the secondary winding? How much current is flowing in the primary winding? What is the line current of the primary?
Q2
Does an open- operation, the kVA rating compared to that of the original thr-phase bank is (a) 2/3 (b) 58 (c) 1
1. What is the relationship of voltage and current (concerning phase angle) in a pure resistive circuit?
How do I convert the following per unit voltages to actual voltage?
Show me how to approach this problem with steps please
Please show your complete work in the solution
Three 25-Kva transformers are connected Delta to Delta (a) what total rated kilovolt amperes can the bank delivers? (b) To what Kva should the load be reduced if one of the transformers is removed so that the bank operates open delta to open delta?
Rush
A single phase load is located 2800 feet from its source. The Load draws a current of 86 A and operates on 480 V. The maximum voltage drop at the load cannot be greater than 3%. What size aluminum conductors should be installed to operate this load?