automates for determination of the epychlorhydrine presence in the working air. The air in volume of 50 liters under temperature +16°C and barometric pressure 755 Hg mm was passed through the absorbing device with absorbing mass in it. Convert the selected air volume to its value in the standard conditions.

automates for determination of the epychlorhydrine presence in the working air. The air in volume of 50 liters under temperature +16°C and barometric pressure 755 Hg mm was passed through the absorbing device with absorbing mass in it. Convert the selected air volume to its value in the standard conditions.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

5.1g of toothpaste was weighed out and transferred to a 500 ml beaker. 250 ml of deionized water was added to the beaker by measuring cylinder, heated for 5 minutes on a hotplate, then sonicated for 10 minutes in an ultrasonic bath. The contents of the beaker was then transferred to a 1000 ml volumetric flask, made to the mark with deionized water and mixed thoroughly. Ten ml of this solution was removed from the volumetric flask (autopipette), 5 ml (measuring cylinder) of TISAB buffer was added. The concentration of the toothpaste obtained is 3.4mgF-/L, calculate the % of fluoride (F) in toothpaste.
None
A sample of water from the North Sea was analysed by ion-chromatography and the sulfate concentration determined to be 2960 mg/L. A sample of formation water from a reservoir near Shetland was analysed by atomic emission spectroscopy and the strontium concentration determined to be 770 mg/L. If the Ksp value for strontium sulfate is 3.44x10- mol- L-2 predict whether precipitation should occur if 500 ml of the seawater is mixed with 500 ml of the formation water.
Consider the following method for the analysis of cocaine (MW 303.35) powder. "Dissolve about 600 mg of cocaine, preciously dried and accurately weighed, in 50 mL of glacial acetic acid, add I drop of crystal violet TS, and titrate with 0.1 M perchloric acid VS to a green endpoint. Perform a blank determination, and make the necessary correction" Calculate the percentage purity of the cocaine sample from the data below. Show your reasoning clearly and record your final answer to four significant figures. CH₂ ● Cocaine powder weighed = 606.3 mg Concentration of HCIO3=0.09978 M H₂C-N- Volume HCIO3 required for the assay mixture = 19.97 mL ● Volume HCIO; required for blank determination = 0.059'mL
Protein ABC is a heme-containing protein responsible in electron transfer in microalgae. The target protein was extracted using ammonium sulfate fractional precipitation and quantified using Bradford assay. A set of solutions with increasing concentration was prepared using 15.00 mg/mL analogous protein standard [refer to succeeding table]. Each solution was treated with 80 μL of Bradford reagent and diluted to 1.500mL. The absorbance at 595 nm of each solution was obtained and presented below. Volume of protein std, μL A595 0 0.0002 10 0.0007 25 0.0075 50 0.0165 100 0.0356 250 0.0930 500 0.1950 750 0.3010 1000 0.4175 Report the equation of the calibration curve and proof of linearity (R2 value).
An 80% exhausted cation exchanger softened 20320 litres of water. 60 ml of this water sample consumed 12.4 ml of 0.01 M EDTA solution using EBT indicator. How many litres of water of hardness of 450 ppm as equivalents of CaCO3 can be treated by the regenerated cation exchanger? What is the volume of hydrochloric acid of specific gravity of 1.19 g.ml1 required for the complete regeneration of the cation exchanger?
A dual beam UV-visible spectroscopy was used to determine the levels of Fe(II) in the run-off water of a local mine using the ferrozine assay (i) During a check of the instrument a step-like feature at 360 nm was observed in spectrum of the standard. Suggest what may give rise to this with reference to the instrument configuration and comment on how it may be remedied. (ii) The molar absorptivity of the [Fe(Ferrozine)3]2+ complex is 27900 cm−1 M−1 at 562 nm in aqueous solution (pH 5.5). If the EU maximum contaminant level for Fe is 200 ug /L and the contract required detection limit is 100 ug/L, comment on the suitability of the assay for the detection of iron. (iii) Determine the sample range, in terms of concentration and ppm, of Fe(II) that can be confidently analysed by UV-visible spectroscopy using a 1 cm cuvette. Explain with reference to an appropriate equation and solution phenomena, the origin of the limitations that define this range
Need help with this question. Thank you :)
2
It has been noticed that adulteration of palm oil with carcinogenic dyes are on the rise. Use your knowledge in analytical processes to systematically process adultrated palm oil to gain qualitative and quantitative information spectroscopically about any added toxic.Explain also the basis for your protocol of choice
Discuss the similarities and differences of the following terms in the calibration of a particular type of equipment or instrument: TC and TD calibration in volumetric flask;
A 0.01kg plant extract in 2dm' of water was shaken with 0.1dm' ether. Upon checking, 1.7x10 kg of plant extract passes into ether. Determine the plant extract left unextracted if the aqueous solution was shaken with 0.1dm ether the second time. There are no changes on the molecular state of the plant extract.'