Assuming paint has 42 percent volume of solids, find the area that 1 litre will cover when a dry film thickness of 38.1 microns is required. (ii) The walls of a room are 3 metres high, with a total of 30 metres of wall length. The total door and window area is 3 square metres. If the spreading rate is 11 square metres per litre, and only two coats of paint are required, work out how much paint is needed.

Assuming paint has 42 percent volume of solids, find the area that 1 litre will cover when a dry film thickness of 38.1 microns is required. (ii) The walls of a room are 3 metres high, with a total of 30 metres of wall length. The total door and window area is 3 square metres. If the spreading rate is 11 square metres per litre, and only two coats of paint are required, work out how much paint is needed.

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter11: Temperature And Temperature- Related Variables In Engineering

Section: Chapter Questions

Problem 9P: Calculate the R-value for the following materials: a. 4 in. thick brick b. 10 cm thick brick c. 12...

See similar textbooks

Related questions

Q: At 15°C water temperature, vapor pressure of water is 1.70 kN/m“. The saturation vapor pressure at…

Q: 4.) GIVEN THE PHASE DIAGRAM SHOW. WHAT IS THE V₂ Va 3 AIR WATER SOLIDS W= 10% 25=165.416 f1³ 8moist…

A: Moist unit weight (γm) = 127 lb/ft3 Solid unit weight (γs) = 165.4 lb/ft3 Water content (w) = 10% =…

Q: Circular clarifiers are used to remove solid materials from water. They allow continuous treatment…

Q: Problem 1/ A vertical glass cylinder contains 850 ml of water at 20 °C; the height of the water…

A: Objective: To determine the height of water in the glass cylinder after the increase in temperature.…

Q: Find the wall thickness of this rigid polyvinylchloride (PVC) tube.

A: Outer diameter=2.375ft Inner diameter=2.181 ft

Q: Problem 9: Castor oil (SG = 0.96) A tank whose bottom is 18 inches x 18 inches is filled with 2 in.…

A: Give data: The unit weight of caster oil = specific gravity of caster oil x unit weight of water =…

Q: Draw a graph showing the emulsification breaker effect over time points (W X Y Z) .

Q: A plate with surface area of 0.4 m² and weight of 500N slides down on an inclined plane at 30 ° to…

Q: Calculate the amount of lime and soda required to treat tuwo million litre (M.L.) of hard water,…

Q: Medium fuel oil having an absolute viscosity of 6.55 x 10⁻⁵ ft²/s flows in a steel pipe 4100 ft long…

A: Given; Absolute viscosity =6.55 x 10⁻⁵ ft²/s Length of steel pipe=4100 ft Maximum rate = 0.201 cfs

Q: The saturated liquid of water at T=300C has total volume (v) of 0.05m3,quality(x) of…

A: The formula used to calculate the specific volume; v=Vf+x(Vg-Vf) Where, V=Specific volumeVf=Specific…

Q: Calculate the R-value for the following materials:a. 100 mm thick brickb. 10 cm thick brickc. 30 cm…

A: The formula for R-value is given by, R-value=LK Where, L = thickness K = thermal conductivity

Q: O Find the resultant reaction at support A. 2 What is the resultant reaction at support B.

A: support reaction:

Q: A tank initially contains 200 gallons of water in which 50 lbs of salt are dissolved. A salt…

Q: Glycerin flows at 35 m through a 150 mm diameter new wrought iron pipe at a velocity of 3 m/s. It…

Q: Convert 15,14 poises to kinematic viscosity if the liquid has a specific gravity of 0.964

Q: Glycerin flows at 35 m through a 150 mm diameter new wrought iron pipe at a velocity of 3 m/s. It…

Q: MASS CUMULATIVE CUMULATIVE SIEVE # SIEVE (mm) RETAINED MASS % RETAINED (gm) RETAINED(gm) #4 4.75mm…

Q: table of choices: Evaporation is the process by which water is changed from the liquid or solid…

A: Heat energy

Q: Glycerin flows at 35 m through a 150 mm diameter new wrought iron pipe at a velocity of 3 m/s. It…

A: D=150mm L=35m V=3m/s To find coefficient of friction (f)

Q: What is the effective fiber diameter of a membrane filter with a pore size of 0.45 * 10^-6? The…

A: The given values are shown below, The pore size =0.45μm The solidity (α)=0.20 Thickness (t)=0.15…

Q: An air compressor used for spraying paint has a tank of capacity 0.40 m that contains air at 27°C…

Q: ISTINYE ISU UNIVERSITY 1STA NSUL Question 3: The structure shown in figure has a cross section that…

Q: Calculate the values of: Mw = Ms 1. Bulk (O.D.) Specific Gravity =. (Mc+Mss-Mws) Mss 2. Bulk (SSD)…

A: Bulk SG=MSMC+MSS-Mws SG=MSSMC+MSS-MwsApparent SG=MSMC+MS-Mws% abs=Mss-MSMS×100

Q: Water at 20.5°C has a dynamic viscosity of 0.01 Poise and specific gravity of 0.97. What is its…

Q: 6- A liquid has a specific weight of 59 lb/ft and a dynamic viscosity of 2.75 lb . s/ft. Determine…

Q: 70 m^3 of air flows in an intake airway towards a working section. Before entering the working…

A: Given data- Inflowing air=70 m3/s10 m3/s air is drawn off and dust concentration=120 p/mL50 m3/s air…

Q: 6.0" wide wooden fence posts are embedded in a concrete driveway a distance 12.125" apart. There is…

A: Given, Width of the wooden fence (bw) = 6 in Width of the concrete slab (bc) = 12 in Coefficient of…

Q: Determine the outside surface area of the storage tank.

Question

100%

(i) Assuming paint has 42 percent volume of solids, find the area that 1 litre will cover when a dry film thickness of 38.1 microns is required.

(ii) The walls of a room are 3 metres high, with a total of 30 metres of wall length. The total door and window area is 3 square metres. If the spreading rate is 11 square metres per litre, and only two coats of paint are required, work out how much paint is needed.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

. A plate with surface area of 0.4 m² and weight of 500 N slides down on an inclined plane at 30 ° to the horizontal at a constant speed of 4 m / s . If the inclined plane is lubricated with an oil of dynamic viscosity 2 poise , find the thickness of lubricant film .
Good Luck! Problem 1/ A vertical glass cylinder contains 850 ml of water at 20 °C; the height of the water column is 70 cm. The water and its container are heated to 70 °C. Assuming no evaporation, what will be the height of the water if the coefficient of thermal expansion for the glass is 3.5 x 10-6/°C?
i need the answer quickly
Q1/ A liquid has a specific weight of 59 lb/ft³ and a dynamic viscosity of 2.75 lb-s/ft². Determine its kinematic viscosity.
6- A liquid has a specific weight of 59 lb/ft and a dynamic viscosity of 2.75 lb . s/ft'. Determine its kinematic viscosity.
Given that the absorption capacity of a sample of aggregates is 8.7% and the oven-dry mass of the sample is 1000 g. Determine the mass of water that this sample 'can absorb. O A. 43.50 O B. 8.70 O C. 870.00 O D. 0.87 O E. 87.00
What is the effective fiber diameter of a membrane filter with a pore size of0.45 * 10^-6? The solidity is 0.20, the thickness is 0.15 mm, and the pressure dropis 1 cm Hg at U0 = 0.015 m/s
TRUE/FALSE Give explanation and solve complete
What is the thermal conductivity of bricks (in W/(m · K))? on each of these
Convert 15,14 poises to kinematic viscosity if the liquid has aspecific gravity of 0.964.
q- solve.
3. 6.0" wide wooden fence posts are embedded in a concrete driveway a distance 12.125" apart. There is a 1/16" gap between the post and the concrete (see diagram). The posts are installed when the temperature is 12°C. Determine if the gap will close when the temperature increases to 32°C and if not how big the gap will be at that temperature. The thermal expansion coefficients of wood and concrete are awood =32 x 105 °C and aconcrete =13 x 106 °C. 1 inch3D2.54 cm. 6.0" 12.0" 0.0625"