13.At 15°C water temperature, vapor pressure of water is 1.70 kN/m“. The saturation vaporpressure at that temperature of water is nearly:[Given: specific weight of Mercury = 845.52 lb/ft')%3D(A)0.504 inches of Hg(B) 1.450 inches of Hg(C) 0.755 inches of Hg(D) None of the above6ni noitsoot s in lo 000,21001.0(A)EALO(8)(D)O 185nowi odi 1obianoT ignsl ai 1ovo 1919mpibT91omsib s 2sd oqiq orlTninismor odi not mm 021o0.1-u 22ol tixo tot basuit 0 oteT wofn stste-ybsoteInotont dondaioW-vOtsd diw

Answered: Image /qna-images/answer/03f35843-1ff4-42e4-84b1-9639472bbc47.jpg

At 15°C water temperature, vapor pressure of water is 1.70 kN/m“. The saturation vapor pressure at that temperature of water is nearly: [Given: specific weight of Mercury = 845.52 lb/ft') 13. %3D (A)0.504 inches of Hg (B) 1.450 inches of Hg (C) 0.755 inches of Hg (D) None of the above

At 15°C water temperature, vapor pressure of water is 1.70 kN/m“. The saturation vapor pressure at that temperature of water is nearly: [Given: specific weight of Mercury = 845.52 lb/ft') 13. %3D (A)0.504 inches of Hg (B) 1.450 inches of Hg (C) 0.755 inches of Hg (D) None of the above

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: ug/L of NaOH should be added in water to change the pH from 7 to 9 at 25°C.

Q: For the pressure vessel containing glycerin, with piezometer attached as shown, what is the…

A: Note:- Hi! Thank you for the question, As per the honor code, we are allowed to answer three…

Q: The specific gravities of solids and carrier fluids of a slurry are usually known, but the specific…

A: Specific gravity is defined as the ratio of the density of solids in the slurry and the density of…

Q: The cyclindrical tank w ends shown in the figur volatile liquid and its v density is 800 kg/m³, a is…

Q: A Y-shaped tube is inserted upside down so that the left foot and right foot are immersed in two…

A: Given- density of first liquid ρ1=0.80 g/cm3density of second liquid ρ2=0.75 g/cm3height of the…

Q: Glycerin flows at 35 m through a 150 mm diameter new wrought iron pipe at a velocity of 3 m/s. It…

Q: The pressure exerted on a liquid increases from o kpa. The volume decreases by 1%. Determine the…

A: The bulk modulus is a measure of the ability of a substance to withstand changes in volume under…

Q: The tank contains a liquid having a density of 2.52 slugs/ft^3 10 in 5 ft 10 ft 7 ft Pliquid = 2.52…

A: GIVEN Density of liquid = 2.52 slugs/ft3 L = 10 ft B = 5 ft H = 7 - 10/12 = 6.167 ft Glycerine, SG…

Q: 1. A water sample is known to contain 300 g/m3 of casein (C8H12O3N2). Estimate the COD, BODu, and…

A: Given data: Mass of sample of casein m=300 gm/m3 Deoxygenating Constant at temperature 20°C=…

Q: Taking the coefficient of compressibility of water to be 2200 MPa, determine the pressure increase…

Q: ht of material in in situ sta nt of material submerge ir sity 0.4DD %3D naterialhas a diameter of

Q: Calculate the location of the center of pressure, Lp, to in m to the nearest 1000th. Fluid: Orange…

A: Concept: Center of Pressure The total pressure force acting on a fully submerged body is called the…

Q: (a) Determine the equation of the estimated regression line. (Round all numerical values to four…

A: efficiency for a steel specimen immersed in a phosphating tank is the weight of the phosphate…

Q: www (pH=7). What is the total hardness (TH) of water that contains the following ion concentrations…

A: Given:Required:Total hardness of water

Q: Benzene; s = 0.88 200 mm 业 Mercury 90 mm Kerosene; s 0.82 Air O Water T100 mm 150 mm 400 mm

Q: The saturated liquid of water at T=300C has total volume (v) of 0.05m3,quality(x) of…

A: The formula used to calculate the specific volume; v=Vf+x(Vg-Vf) Where, V=Specific volumeVf=Specific…

Q: 2. In the figure shown, if the atmosphere pressure is 101.3 kPa and the absolute Pressure at the…

Q: The cyclindrical tank with hemispherical ends shown in the figure below contains a volatile liquid…

A: To Determine (a) the gage pressure reading on the pressure gage Pressure gage is 1m below the liquid…

Q: After being filled to a depth d with SAE 30 oil (SG = 0.91), a glass is placed to float in a tank of…

A: Depth upto which SAE oil is filled in a glass to make it float on water = d , Specific Gravity og…

Q: The viscosity of the liquid is 0.002 Pa.s and its density is 0.8. Get systematic fluid viscosity.

A: Given data, Dynamic viscosity = 0.002 Pa.s Relative Density = 0.8 Density = 800 kg/m^3 Systematic…

Q: Due to rise in temperature, the viscosity and unit weight of percolating fluid are reduced to 70%…

A: The given data is: The reduction in viscosity=70 % The reduction in unit weight of percolating…

Q: The tank shown below contains 80 lbs of salt dissolved in 500 gal of water. The inflow per minute is…

Q: 3. A liquid boils when its vapor pressure is equal to a. One atmosphere of pressure b. The gage…

A: As per guidelines we need to answer only first question so please repost rest questions separately.

Q: Two lbs of water vapor in a piston-cylinder assembly expands at a constant pressure of 300 lb/in²…

Q: 3. A differential manometer is attached to two tanks, as shown in figure. A) Calculate the…

A: The objective of the question is to calculate the difference in pressure between two chambers, the…

Q: A fluid's viscosity and unit weight are reduced to 60% and 80%, due to increase in temperature. If…

A: Given data- Fluid's viscosity & unit weights are reduced to 60% & 80%, All other parameters…

Q: The cyclindrical tank with hemispherical ends shown in the figure below contains a volatile liquid…

A: Reference : Fluid mechanics, Pressure analysis for Volatile liquid. We know that , Gage pressure is…

Q: specific gr poured into the tank. By spinbu

A: To find : Percentage change in pressure at base of tank. Given: tank of height 3 m is completely…

Q: Chamber A oil SE=0.89 0.30 mercury Chamber B tetrachloride sg=1.59 0.8 m

Q: a) determine the unit weight of the liquid when it is at the level shown b) determine the weight of…

A: Density of liquid(ρliquid)=2.52 slug/ft3Volume of liquid(Vliquid)=10×5×(7-0.82)=309 ft3a) Unit…

Q: Air (y = 0.20 Ibt/t") 48 in 30 gh Diameter - 4 in Diameter 12 in

A: Solution Calculate the flow rate of water flowing through venturi metre Flow Rate…

Q: oxygen concentrations a

A: At Temperature 0 and 25 deg , we have to calculate O2 concentration by Henry's formulaHenry's Law…

Q: Convert 15,14 poises to kinematic viscosity if the liquid has a specific gravity of 0.964

Q: Find the pressure in the pipe cortaining gasoline in kPa. Ir the given conditions, cir has a density…

Q: The cyclindrical tank with hemispherical ends shown in the figure below contains a volatile liquid…

A: Let Point A at the surface of liquid & Point B at 1m below the surface of liquid. Given density…

Question

13.
At 15°C water temperature, vapor pressure of water is 1.70 kN/m“. The saturation vapor
pressure at that temperature of water is nearly:
[Given: specific weight of Mercury = 845.52 lb/ft')
%3D
(A)0.504 inches of Hg
(B) 1.450 inches of Hg
(C) 0.755 inches of Hg
(D) None of the above
6ni noitsoot s in lo 000,21
001.0(A)
EALO(8)
(D)O 185
nowi odi 1obiano
T ignsl ai 1ovo 1919mpib
T91omsib s 2sd oqiq orlT
ninismor odi not mm 021o
0.1-u 22ol tixo tot bas
uit 0 oteT wofn stste-ybsote
Inotont dondaioW-vOtsd diw

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Please complete answer
Please provide complete solution.Thanks
VOLUME cm3 Vw= saturation= cm cm3 VT-295 cm³ water content= porosity void ratio= Total density (g/cm³) Dry density (g/cm³). AIR WATER 1 g/cm³3 SOLIDS RD 2.70 MASS Ma-0 grams Mw grams M = 415 grams MT-490 grams
. A solvent used for plastic manufacturing consists of cyclohexanol in tank A and ethyl lactate in tank B. Determine the pressure on the top of tank A if the mercury in the manometer is at the level shown, where h = 0.75 m. Take Sc= 0.953, SHg = 13.55 and Sel = 1.03. po A T 1.5 m B mercury 4.5 m
Situation 2: A liquid at 4°C has a relative density of 0.80 and a kinematic viscosity of 2.3 centistoke. 3. Determine its unit weight in (3 decimal places) kN m² na 4. Determine its dynamic viscosity in kg m-s (5 decimal places not in scientific notation)
In the figure shown, given that the absolute pressure at B is 290 kPa. Therefore, the value of "h" is 300 mm. Air, p = 175 kPa abs Water 700 mm Mercury B.
A closed tank whose bottom is 18 inches in diameter is filled with three liquids: 4 inches of carbon tetracloride (SG=1.59), 2 inches of water and 12 inches of syrup (SG= 1.31). The aire chamber in the tank is pressurized at 1296 psf. A.) Determine the pressure at the interface of carbon tetrachloride and syrup. B.)Determine the difference in pressure between the interface of water and syrup and the interface of carbon tetrachloride and syrup. C.)Compute the hydrostatic pressure (in psf) acting at the bottom of the tank.
A gas expands from 0.03 m3 to 0.05 m3 at constant pressure of 3.5 atm. Determine the work done.
A tank contains the following liquids: water with h= 2.5 m sea oil (s=0.89) with h=2.6 m mercury (s=13.6) with h= 0.8 m olive oil (s=1.37) with h=3.8 m glycerin (s= 1.2) with h= 2.7 m Compute the absolute pressure in kPa at the interface of olive oil and mercury.
The surface tension of mercury and water at 60°C are 0.47N/m and 0.0662 N/m. respectively. What capillary height (in mm) will occur in the water when it is in contact with air in a glass tube of radius 0.355 mm? Use 130° for mercury and O° for water
Quick please
mat assessment 8 number 8