An intersection has a three-phase signal with the movements allowed in each phase and correspondinganalysis and saturation flow rates shown in the table below. Assume the lost time is 4 seconds per phase and acritical intersection v/c of 0.90 is desired.Phase123Allowed movementsNB L, SB LNB T/R, SB T/REB L, WB LEB T/R, WB TRAnalysis flow rate330, 365 veh/h1125, 1075 veh/h110, 80 veh/h250, 285 veh/hSaturation flow rate1700, 1750 veh/h3400, 3300 veh/h650, 600 veh/h1750, 1800 vehhCalculate minimum cycle lengthO 255 secO 60 secO 155 secO 100 sec

An intersection having 3 phase signal with all movements allowed in each phase and saturation flow…

An intersection has a three-phase signal with the movements allowed in each phase and corresponding analysis and saturation flow rates shown in the table below. Assume the lost time is 4 seconds per phase and a critical intersection v/c of 0.90 is desired. Phase Allowed movements NB L. SB L NB T/R, SB T/R EB L, WBL EB T/R, WB T/R Analy sis flow rate Saturation flow rate 330, 365 veh/h 1125, 1075 veh/h 110, 80 veh/h 250, 285 veh/h 1700, 1750 veh/h 3400, 3300 veh/h 650, 600 veh/h 1750, 1800 veh/h Calculate minimum cycle length

An intersection has a three-phase signal with the movements allowed in each phase and corresponding analysis and saturation flow rates shown in the table below. Assume the lost time is 4 seconds per phase and a critical intersection v/c of 0.90 is desired. Phase Allowed movements NB L. SB L NB T/R, SB T/R EB L, WBL EB T/R, WB T/R Analy sis flow rate Saturation flow rate 330, 365 veh/h 1125, 1075 veh/h 110, 80 veh/h 250, 285 veh/h 1700, 1750 veh/h 3400, 3300 veh/h 650, 600 veh/h 1750, 1800 veh/h Calculate minimum cycle length

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

4) Traffic on the eastbound approach of a signalized intersection is traveling at 35 mi/hr, with a density of 46 veh/mi/In. The duration of the red signal indication for this approach is 30 sec. If the saturation flow is 1900 veh/h/In with a density of 52 veh/mi/In, and the jam density is 125 veh/mi/In, determine the following: (i) The length of the queue at the end of the red phase (ii) The maximum queue length (iii) The time it takes for the queue to dissipate after the end of the red indication.
25 The table below shows the design flow rate and saturation flow rate for a major intersection on a highway. Using the Webster method, determine the optimum cycle length for the intersection and also determine the green time for each phase. Design Flow Rate (pcu/hr) Through Phase Saturation Flow Rate (pcu/hr) Intergreen period (sec) Left Through Left A 976 234 3700 1615 3.5 676 135 3700 1615 3.5 194 26 3700 1615 3.5 322 371 3700 1615 3.5
An approach to a pre-timed signal has 40 sec of effective green in a 75-second cycle.The approach volume is 700 veh/h and the saturation flow rate is 1600 veh/h.Calculate the time to queue clearance after the start of the effective green, themaximum number of vehicles in the queue, the total vehicle delay per cycle andthe average delay per vehicle assuming D/D/1 queuing.
Quest... In a three-phase signal system design for a four- leg intersection, the critical flow ratios for each phase are 0.18, 0.32, and 0.22. The total loss time in each of the phases is 2 s. As per Webster's formula, find the optimal cycle length.
Please estimate the minimum cycle length and the green intervals for the following signalized intersection (Figure 7). Please note that the minimum cycle length will be influenced by the design of the phasing diagram. The arrival flow, in pcu/h, for each direction, is illustrated in Figure 7. Please assume any missing values. Lost time following each phase = 2 sec, Amber = 3 sec, Red all = 1 sec, saturation flow 1400 pcu/h. 196, 367, 170 JIL! 400, 140, 215 716 120, 417, 232 400, 433, 184 Figure 7. Intersection Layout and Traffic Flow Data
7.12 The saturation flow rate of an approach to a pretimed signal is 6000 veh/h. The signal has a 60-second cycle with 20 seconds of effective red allocated to the approach. At the beginning of an effective red (with no vehicles remaining in the queue from a previous cycle), vehicles start arriving at a rate v(t) = 0.4 +0.01t + 0.00057+² (where v(t)) is in vehicles per second and t is the number of seconds from the beginning of the cycle). 30 seconds into the cycle the arrival rate remains constant at its 30-second level and stays at that rate until the end of the cycle. What is the total vehicle delay over the cycle (in vehicle- seconds), assuming D/D/1 queuing?
Q2: What are the assumptions for using the equations in the queue test? Q3: A signalized intersection, of 105 sec cycle length, the east approach has an effective green time of 20 sec, and the percentage of vehicles arriving during green time is 28%. The west approach has 16 sec green time and 32% of vehicles arriving during the green time. Determine which approach is best coordinated with the upstream signal.
A turning movement count and a saturation flow study were conducted at a major intersection on an expressway with configuration as presented in Fig.1. The peak-hour volumes and saturation flows obtained from the studies for each movement are presented in Tables 1 and 2, respectively. i) provide a diagrammatic representation of the signal sequence at the intersection. Assume a yellow interval of 3s, all-red interval of 2s and a peak hour factor of 0.95 for all the approaches. Note: No two movements should conflict during the determination of the phasing plan.
An intersection has a three-phase signal with the movements allowed in each phase and corresponding analysis and saturation flow rates shown in the table below. Assume the lost time is 4 seconds per phase and a critical intersection v/c of 0.90 is desired. Phase 3 Allowed movements NB L, SB L NB T/R, SB T/R EB L, WB L EB T/R, WB T/R Analysis flow rate 330, 365 veh/h 1125, 1075 veh/h 110, 80 veh/h 250, 285 veh/h Saturation flow rate 1700, 1750 veh/h 3400, 3300 veh/h 650, 600 veh/h 1750, 1800 veh/h Using v/c equalization ratio, calculate the effective green time for phase 1 O 15.954 sec O 12.105 sec O 14.127 sec O 13.190 sec
Determine the maximum sum of critical volumes that a signalized intersection, with four phases and a cycle length of 120 seconds, can accommodate. Assume that the lost time per phase is equal to 3.5 seconds, and that the saturation discharge headway is equal to 1.9 seconds. Ans: 1,673 veh/hr
(b) An approach to a pretimed signal has 25 seconds of effective green in a 60-second cycle. The approach volume is 500 vph and the saturation flow rate is 1400 vph. Calculate the average vehicle delay assuming D/D/1 queuing.
Subject: transportation engineering Read the question carefully and give me right solution according to the question. A signal has four phases, where the critical lane group flow ratios are 0.115, 0.204, 0.099, and 0.248. If the lost time per phase is 6 seconds and the critical intersection v/c ratio is 0.88, calculate the minimum cycle length and the phase effective green times such that the lane group v/c ratios are equal.