An inextensible massless string goes over a frictionless pulley. Two weights of 100 N and 200 N are attached to the two ends of the string. The weights are released from rest, ad start moving due to gravity. The tension in the string (in N) is | 200 N 100 N

An inextensible massless string goes over a frictionless pulley. Two weights of 100 N and 200 N are attached to the two ends of the string. The weights are released from rest, ad start moving due to gravity. The tension in the string (in N) is | 200 N 100 N

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Q2: Determine the magnitude and direction of the friction force which the inclined plane exerts on the 25-Kg block. 300 N 25 Kg 15 H, 0.25 H0.20 25
2. with complete final answer
An inextensible massless string goes over a frictionless pulley. Two weights of 100 N and 200 N are attached to the two ends of the string. The weights are released from rest, and start moving due to gravity. What is the tension in the string?
A 0.32 lbm baseball is tethered to a string and swung by a rotating vertical pole. If the string is 12 ft long and the speed of the ball is 55 mph, determine the tension in the string, the angle the string makes with the vertical and the angular speed of the pole. ANS. 0=86.6°, T = 5.4 lbf, o=6.73 rad/sec
Q1/ Determine the reaction forces in the following crane, assume the crane mass centered at G is 1000 kg: A 2400 kg 1.5 m -2 m→ 4 m-
E3
the two blocks in the diagram are in static equilibrium. a) draw a force diagram and for each block and set up forces balances on each block. b) determine the tension in the rope and the mass of block 1 (M1) c) if both blocks have the same mass of 90 kg, what would the magnitude and direction of the acceleration of each block be?
What would be the maximum compression (in m) of the spring?
A 5-kg bag is gently pushed off the top of a wall and swings in a vertical plane at the end of a 2.4- m rope which can withstand a maximum tension Fm. For Fm from 40 to 140 N use computational software to determine (a) the difference in elevation h between point A and point B where the rope will break, (b) the distance d from the vertical wall to the point where the bag will strike the floor. -2.4m A 3m B'
Question 7 The large piston of a hydraulic lift has a radius of 20 cm. What force must be applied to the small piston of radius 2.0 cm to raise a car of mass 1500 kg to the same level as shown? F₁ Small piston Large piston A₂ F₂
1 For the car lift shown in the figure, determine the force required to be applied (F1), for the following cases: (i)A1 = 0.1 m2 and A2 = 0.25 m2 (ii)A1 = 0.05 m2 and A2 = 0.25 m2 Take mass of the car as 1500 kg.
A gardener uses a 60-N wheelbarrow to transport a 250-N bag of fertilizer.What force must she exert on each handle?