2. A 20 kg box sitting on a horizontal surface is pulled by a horizontal force of 64 N. The coefficient of kinetic friction between the box and the surface is 0.2. (Draw free-body diagram here) MOITANUMAX MUITOM MOD blow my wode so gol Dano tost esot ow 02 to shisingem seer sono torisc et on bas 1979 mang sib vhod-seil war(1) 1285 x 21 to sbutingam a. What is the normal force acting on the box?

Q: A child goes down a playground slide with an acceleration a. coefficient of kinetic friction, Uk,…

A:

Q: Consider the following diagram. m1320 kg and m2= 10 kg. The system is being pulled by an applied…

A:

Q: 1. The 500-lb block in Fig. P-507/p. 122 is in contact with a 45° incline. The coefficient of static…

A: Given data  weight of block (W) = 500 lb angle of inclination of plane (θ) = 45o coefficient of…

Q: consider a circle of radius 1m and weight of 100n resting on a right angle surface where the…

A:

Q: 300 lb 30° AT 40 lb T 300 lb 34P Sürtünmesiz makaraların olduğu yukarıdaki sistemde her iki tarafa…

A:

Q: Two blocks are connected by a rope that passes over a frictionless pulley A and a fixed drum B, as…

A:

Q: The A kg collar is initially at rest on the bar at position 1 as shown in Figure Q2. The coefficient…

A:

Q: A dustbin of mass 12 kg standing on horizontal ground is pushed by a horizontal force of 40 N. If…

A: Mass of dustbin m=12kgHorizontal force F=40 Nμ=.4

Q: Activity 2. In the figure, the coefficients of friction are as follows: 0.25 between blocks, 0.20 at…

A:

Q: AW-16-lb weight block is lifted vertically by a force of F-27 lb. Determine its acceleration. (Hint:…

A:

Q: A block of mass M = 539.0 g sits on a horizontal tabletop. The coefficients of static and kinetic…

A:

Q: A block of mass 1kg is placed on turntable rotating with constant angular velocity o about O. The…

A: SOL : → On rotation , free body diagram of block∴ w = v r   ; r - string length = 1m .⇒ Eqn . of…

Q: 1. Find the amount of compression of the spring if the 3-kg ball does free fall from 1 m and…

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.