A dustbin of mass 12 kg standing on horizontal ground is pushed by a horizontal force of 40 N. If the coefficient of friction is 0.4, will the dustbin move?

Q: 300 lb 30° AT 40 lb T 300 lb 34P Sürtünmesiz makaraların olduğu yukarıdaki sistemde her iki tarafa…

A:

Q: A 10 lb block slides 6 ft down a plane inclined 40 degrees with horizontal. Determine the work done…

A:

Q: A box rests on a horizontal plane. The plane is slowly tilted so that the angle between the surface…

A: the coefficient of static friction between the box and the surface at which point the box begins to…

Q: A block of mass 14 kg is resting on a table is pulled by a force of 100 N. The coefficient of…

A: Given     Mass, m = 14 kg     Force, F = 100 N

Q: Question 2 A car has a mass of 1.5 tons and a centre of gravity at point G. The coefficient of…

A: (a) To demonstrate: All the forces on the car. Explanation: The forces acting on the car is its…

Q: Q2. Each of the two blocks in Figure 10.4 has a mass of 10 kg, and the coefficient of friction…

A:

Q: There is a box with height 1.2 m, width 0.8 m and mass 50 kg. It contains a very expensive…

A: Given Data m=50kg θ=30° h=1.2m w=0.8m μ=0.4 Here the FBD

Q: Q.2) A 50 Kg crate is resting on top of a 40 Kg crate as shown in figure below. The top crate is…

A:

Q: Assume that there are no frictional forces between the pulleys and the strings, and the strings are…

A: Given data: The mass of block 1 is, m1=1 kg. The mass of block 2 is, m2=2 kg. The mass of block 3…

Q: A box of mass 12 kg standing on horizontal ground is pushed by a horizontal force of 30 N. If the…

A: Given data: The mass of the box is m = 12 kg. The horizontal force is F = 30 N. The coefficient of…

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.